Mechanistic insights into tuning the work function of indium tin oxide via vacuum ultraviolet irradiation
Source abstract
Abstract
Indium tin oxide (ITO) plays a crucial role in optoelectronic devices due to its excellent combination of optical transparency and electrical conductivity. The work function of the ITO surface critically influences charge injection efficiency and directly affects device performance. In this study, we systematically investigated the modulation of the ITO work function induced by vacuum ultraviolet (VUV) irradiation using photoelectron yield spectroscopy in air (PYSA). Two conditions were used: direct exposure and exposure through synthetic quartz glass, to elucidate the underlying mechanisms. VUV treatment significantly increased the work function from 4.6 eV to values exceeding 5.09 eV, reaching a higher saturation value of more than 5.37 eV under quartz-covered irradiation. Complementary analyses, including water contact-angle measurements, X-ray photoelectron spectroscopy (XPS), atomic force microscopy (AFM), sheet-resistance measurements, and optical transmission spectroscopy, revealed that the enhancement in work function was primarily attributed to the removal of organic contaminants. In contrast, oxygen vacancy formation and related chemical-state changes are suggested to be limited under the present experimental conditions, because the XPS survey analysis shows only small variations in the observable elemental ratios. These findings deepen the understanding of electronic property control of ITO surfaces via VUV treatment and provide practical guidelines for optimizing next-generation optoelectronic devices.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: ZnO doping and properties · Nanomaterials and Printing Technologies · Transition Metal Oxide Nanomaterials
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (26)
Show source-provided references
1. Organic electroluminescent diodes10.1063/1.98799 ↗
2. Fast write and erase surface resistance induced nematic liquid crystal display10.1063/1.98013 ↗
3. Two‐layer organic photovoltaic cell10.1063/1.96937 ↗
4. Effects of the morphology of a ZnO buffer layer on the photovoltaic performance of inverted polymer solar cells10.1002/adfm.201101915 ↗
5. Influence of heat treatment on indium–tin-oxide anodes and copper phthalocyanine hole injection layers in organic light-emitting diodes10.1016/j.tsf.2006.11.116 ↗
6. Improvement of organic solar cells by flexible substrate and ITO surface treatments10.1016/j.apsusc.2010.06.011 ↗
7. Hole mobility measurement of 4,4′-Bis[N-(1-naphthyl)-N-phenylamino]-biphenyl by dark injection method10.1016/j.cplett.2010.11.083 ↗
8. In Situ measurements of work function of indium tin oxide after UV/ozone treatment10.2320/matertrans.MA201516 ↗
9. Dependence of indium–tin–oxide work function on surface cleaning method as studied by ultraviolet and x-ray photoemission spectroscopies10.1063/1.371859 ↗
10. Work function modification of indium-tin-oxide used in organic light emitting devices10.1116/1.581889 ↗
11. Uda, Y. Nakagawa, T. Yamamoto, M. Kawasaki, A. Nakamura, T. Saito, K. Hirose, Successive change in work function of Al exposed to air, Journal of Electron Spectroscopy and Related Phenomena, 88–91 (1998) 767–771. doi: 10.1016/S0368-2048(97)00237-5.10.1016/S0368-2048(97)00237-5 ↗
12. An electron counting mechanism for the open counter operated in air10.1016/0168-9002(94)90281-X ↗
13. Nuclear instruments and methods in physics research section a: accelerators, spectrometers, detectors and associated equipment10.1016/0168-9002(95)01491-8 ↗
14. Surface modification of a polymer film for electronic packaging using vacuum ultraviolet irradiation
15. T. Arimoto, M. Miura, F. Takemoto, Surface Modification of Cyclo Olefin Polymer film for Electronic Packaging by Vacuum Ultraviolet Irradiation, 2023 International Conference on Electronics Packaging (ICEP), Kumamoto, Japan (2023) 109–110. doi: 10.23919/ICEP58572.2023.10129756.10.23919/ICEP58572.2023.10129756 ↗
16. T. Arimoto, M. Miura, F. Takemoto, Improvement of Adhesion between High-Frequency-Compatible Substrates with Low Dielectric Constants and Electroless Plated Copper Films Using a Vacuum Ultraviolet Treatment, 2023 18th International Microsystems, Packaging, Assembly and Circuits Technology Conference (IMPACT), Taipei, Taiwan (2023) 247–250. doi: 10.1109/IMPACT59481.2023.10348633.10.1109/IMPACT59481.2023.10348633 ↗
17. The analysis of photoelectric sensitivity curves for clean metals at various temperatures10.1103/PhysRev.38.45 ↗
18. In situ measurements of the desorption of water from a TiO2 surface under dry air by collecting the photoemission yield with an open counter10.2116/analsci.30.575 ↗
19. Work function changes of plasma treated indium tin oxide10.1016/j.orgel.2014.05.008 ↗
20. Tuning the ITO work function by capacitively coupled plasma and its application in inverted organic solar cells10.1016/j.apsusc.2016.05.077 ↗
21. Work function changes and surface chemistry of oxygen, hydrogen, and carbon on indium tin oxide10.1016/S0169-4332(01)00347-6 ↗
22. Importance of electrostatic effects for interpretation of X-ray photoemission spectra of self-assembled monolayers
23. Short-lived reactive components substantially contribute to particulate matter oxidative potential10.1126/sciadv.adp8100 ↗
24. Recent advances on reactive oxygen species-responsive delivery and diagnosis system10.1021/acs.biomac.9b00628 ↗
25. Reactive oxygen species: Re-evaluation of generation, monitoring and role in stress-signaling in phototrophic organisms, Biochimica et Biophysica Acta (BBA) -
26. Chemical exposure-response relationship between air pollutants and reactive oxygen species in the human respiratory tract10.1038/srep32916 ↗