Nitrogen-mediated phase transformation in RF-sputtered CuInSe2
Source abstract
Abstract
• RF-Sputtered CuInSe 2 thin films were prepared in the presence of nitrogen. • At low nitrogen flows the CuInSe 2 chalcopyrite structure is slightly disrupted. • At low nitrogen flows the thin filmś bandgap can be tuned from 0.96 eV to 1.3 eV. • Large nitrogen flows facilitate the dissociation of CuInSe 2 into CuSe and InSe. • CuInSe 2 :N with a 1.3 eV bandgap may be used for substituting CuInGaSe 2 in solar cells. Pure and nitrogen‐incorporated CuInSe 2 (CIS) thin films were fabricated by a reactive sputtering technique under controlled nitrogen flow rates ranging from 0 to 1.5 sccm. Systematic investigation using X-ray diffraction (XRD) confirmed that deposited films retained a chalcopyrite‐type structure, dominated by the (112) plane, with secondary phases (e.g., CuSe, InSe) emerging at high nitrogen flows. Topographical analyses through scanning electron microscopy (SEM) and atomic force microscopy (AFM) revealed that moderate nitrogen incorporation yielded dense, smooth, and compact CIS thin films, while higher flows (>0.3 sccm) led to an increasingly rough surface and the formation of additional binary compounds. Compositional studies by energy-dispersive X-ray spectroscopy (EDS) and X-ray photoelectron spectroscopy (XPS) verified the incorporation of nitrogen into the CIS lattice and identified concomitant changes in stoichiometry. Optical measurements demonstrated a noticeable bandgap shift from approximately 0.96 eV for pristine CIS to 1.3 eV assisted with 0.1 sccm nitrogen, highlighting the potential for bandgap engineering. However, an excess of nitrogen flow (>0.1 sccm) facilitated the partial decomposition of CIS, raising the effective bandgap above 1.6 eV and underscoring the delicate balance required to maintain chalcopyrite integrity. These findings confirm that appropriate nitrogen doping conditions can enhance both the optical and structural properties of CIS films, offering new avenues for optimizing photovoltaic performance in solar cell applications. The study provides insight into how controlled nitrogen doping can potentially fine-tune the bandgap, while highlighting that excessive nitrogen promotes detrimental phase separation.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Chalcogenide Semiconductor Thin Films · Quantum Dots Synthesis And Properties · Phase-change materials and chalcogenides
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (29)
Show source-provided references
1. Tabulated values of the Shockley–Queisser limit for tandem solar cells10.1002/pssa.202400524 ↗
2. Efficiency improvement of near-stoichiometric CuInSe2 solar cells for application in tandem devices10.1002/aenm.201901428 ↗
3. Study of the sub-bandgap absorption and the optical transitions in CuInSe2 polycrystalline thin films10.1016/S0927-0248(97)00287-0 ↗
4. Studies on optical characteristics of CuInSe2 thin films
5. Improved performance in CuInSe2 and surface-modified CuGaSe2 solar cells
6. Fabrication of bendable and narrow-bandgap Cu(In,Ga)(S,Se)2 for tandem photovoltaics10.1038/s43246-024-00706-x ↗
7. Study of the effect of gallium grading in Cu(In,Ga)Se210.1016/S0040-6090(99)00845-7 ↗
8. Highly efficient narrow-bandgap Cu(In,Ga)Se2 solar cells with enhanced open-circuit voltage for tandem application10.1038/s41467-024-45344-6 ↗
9. T.G. Erickson, A study of the creation and characterization of nitrogen doped CuInSe2 (CIS:N), as a potential improved back contact material for CdTe and Cu(InxGa1−x)Se2 photovoltaic cells, M.S. Thesis, University of Illinois at Urbana–Champaign, 2016. https://hdl.handle.net/2142/92675.
10. Nitrogen doped chalcopyrites as contacts to CdTe photovoltaics
11. Influence of nitrogen doping on the defect formation and surface properties of TiO2 rutile and anatase10.1103/PhysRevLett.96.026103 ↗
12. Nitrogen implantation for molecular beam deposited CuInSe2 thin films10.1063/1.106239 ↗
13. Regulating charge migration in CuInSe2/N-doped carbon nanorod arrays via interfacial engineering for boosting photoelectrochemical water splitting
14. Homojunction diode of CuInSe2 thin film fabricated by nitrogen implantation10.1063/1.355296 ↗
15. Effect of N2 gas fractions on structural, optical and electrical properties of Cu3N thin films deposited by reactive RF magnetron sputtering
16. Exploring the role of nitrogen doping in tuning the bandgap and electrical properties of sol-gel-synthesized anatase TiO2 nanoparticles10.1016/j.optmat.2025.116851 ↗
17. XPS depth profile analysis of Zn3N2 thin films grown at different N2/Ar gas flow rates by RF magnetron sputtering10.1186/s11671-016-1769-y ↗
18. N. Valdes, J.W. Lee, W. Shafarman, Comparison of Ag and Ga alloying in low-bandgap CuInSe2-based solar cells, Sol. Energy Mater. Sol. Cells. 195 (2029) 155–159. DOI: 10.1016/j.solmat.2019.02.022.10.1016/j.solmat.2019.02.022 ↗
19. Yttrium-doped CuInSe2 solar cells: higher conversion efficiency and promising candidate for top cell of tandem cell10.1016/j.solener.2024.112390 ↗
20. Study of the structural and optical properties of CuInSe2 thin films obtained by RF sputtering as a function of the deposition temperature10.18257/raccefyn.3225 ↗
21. Wagner · 1979
22. Single-crystal CuInSe2 analysis by high-resolution XPS10.1116/1.1247638 ↗
23. Single-graded CIGS with narrow bandgap for tandem solar cells,10.1080/14686996.2018.1444317 ↗
24. Optical and structural study of CuSe and CuSe/In thin films10.1088/1742-6596/480/1/012024 ↗
25. Facile microwave-assisted synthesis of klockmannite CuSe nanosheets and their exceptional electrical properties
26. Modeling of reactive sputtering—history and development10.3390/ma16083258 ↗
27. CuInSe2 thin films produced by rf sputtering in Ar/H2 atmospheres10.1063/1.339135 ↗
28. Fabrication of p-type CuInSe2 thin film by MBD using ECR excited nitrogen ion source10.1557/PROC-268-145 ↗
29. Fabrication of Cu(In,Ga)Se2 thin films by sputtering from a single quaternary chalcogenide target10.1002/pip.1001 ↗