Low-cost flame synthesized La2/3Cu3Ti4O12 electro-ceramic and extensive investigation on electrical, impedance, modulus, and optical properties

An environmentally-friendly synthesis route and low-cost starting materials are more appropriate for the production of ceramic materials at the industry level. With this concern we prepared the La 2/3 Cu 3 Ti 4 O 12 (LCTO), which is isostructural of CaCu 3 Ti 4 O 12 (CCTO), using the low-cost TiO 2 instead of a high-cost of titanium source (titanium isopropoxide or titanium chloride) using a low-cost wet-chemical route. Although, there are lots of synthetic methods reported for LCTO fabrication in terms of duration, cheap reagents, energy consumption, feasibility, etc. The present method is far better than the others. The prepared ceramic samples were sintered at 1050 ° C/12 h and studied their structural, morphology and impedance, and modulus studies for further confirmation. The prepared LCTO ceramic shows the pure phase with the cubic type of morphology. The homogenous distribution of all the elements was observed through dispersive X-ray analysis. X-ray photoelectron spectroscopy studies revels that La is in +3 oxidation state, Cu is in a +2 oxidation state, and Ti is multiple (+3 and + 4) oxidation state. The LCTO ceramic displayed the very high dielectric constant (∼3852) and dielectric loss (0.322), at 1 kHz and at room temperature. Calculated the activation energy using the impedance and modulus data and it shows the superior to that of CCTO ceramic synthesized by the same method. The prepared samples exhibited Debye-type relaxation, which is evoked from the impedance and modulus studies. The calculated optical energy bandgap of LCTO (2.06 eV) is found to be lesser than that of the well-known structure of perovskites (BaTiO 3 (3.28 eV), PbTiO 3 (3.18 eV), LiNbO 3 (3.78 eV) and BiFeO 3 (2.67 eV) as well as structure of spinel CoCr 2 O 4 (3.10 eV) and LuFe 2 O 4 (2.18 eV)) materials.