Magnetoelectric, magnetodielectric effect and dielectric, magnetic properties of microwave-sintered lead-free x(Co0.9Ni0.1Fe2O4)-(1-x)[0.5(Ba0.7Ca0.3TiO3)-0.5(BaZr0.2Ti0.8O3)] particulate multiferroic composite

Abstract Materials with two distinct (magnetostrictive-ferroelectric) phases, i.e., x (Co0·9Ni0·1Fe2O4) -(1-x) [0.5 (Ba0·7Ca0·3TiO3) −0.5 (BaZr0·2Ti0·8O3)], combined at ratios of 10:90, 20:80, 30:70, and 40:60 were prepared using a hydroxide coprecipitation method. These multiferroic composites were subjected to sintering via the hybrid microwave sintering technique at 1200 °C for 20 min. Ni-substituted CFO exhibited excellent magnetic properties at room temperature, with Ms ≈ 80 emu/g, μB ≈ 3.37, Mr ≈ 19.05 emu/g, and Hc ≈ 599 Oe, as well as a high value of the magnetostriction coefficient (λ12 ≈ −118 ppm). The magnetostrictive-ferroelectric crystal phases in each composite were confirmed via X-ray diffraction analysis. The highest value of the linear magneto-electric coefficient was α = 21.6 mV/cm-Oe at a frequency of 1 kHz for the 40CNFO-60(BCT-BZT) composite, and a similar sample had the highest value of the magnetodielectric coefficient, which was approximately 3.3% at f = 1 kHz with an applied magnetic field of 1 T. The typical ferromagnetic and ferroelectric nature of each composite was confirmed by M − H and P–E hysteresis loops, respectively at room temperature. Two anomalies were observed in the temperature-dependent dielectric permittivity one at ~140 °C and another above 500 °C confirming the coexistence of two materials with distinct transition points, i.e., BCT-BZT and CNFO, respectively.