journal article·2026-11

Early-stage oxidation of model austenitic stainless steel surface by water vapour

Sudharsan Sundar, Li Ma, Frédéric Wiame, Vincent Maurice, Philippe Marcus

Publisher page

Abstract

The (100)-oriented Fe-18Cr-13Ni model 304 stainless steel surface was exposed to water vapour at very low pressure to study the initial stages of oxidation at room temperature (RT) and 250 °C. In situ X-ray photoelectron spectroscopy (XPS) during exposure showed a 2.5 times increase in the initial rate of oxygen uptake upon temperature increase. Angle-resolved high-resolution core-level spectra, recorded at various steps of the reaction, revealed only oxidation of Fe and Cr, leaving Ni unreacted. Growth models, deduced from the careful analysis of spectral changes during water vapour exposure, allowed an estimation of the oxide film thickness and structure. According to these models, at the end of primary growth, the surface is covered with one monolayer of oxide/hydroxide (0.21±0.02 nm) at RT, while at 250 °C, the passive film is twice as thick, with a higher oxide:hydroxide ratio. Compared to O2 exposure experiments performed on the same alloy, water vapour reacted 104 times slower than oxygen. The large reduction in reaction rate is possibly due to the limited dissociation of water on the stainless steel surfaces. This insight improves our fundamental understanding behind the passive film formation mechanism contributing towards producing improved corrosion-resistant surfaces.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Hydrogen embrittlement and corrosion behaviors in metals · High-Temperature Coating Behaviors · Corrosion Behavior and Inhibition

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (40)

Show source-provided references
1. New insight on early oxidation stages of austenitic stainless steel from in situ XPS analysis on single-crystalline Fe–18Cr–13Ni10.1016/j.corsci.2018.06.001 ↗
2. Combined XPS/TEM study of the chemical composition and structure of the passive film formed on additive manufactured 17-4PH stainless steel10.1016/j.surfin.2020.100874 ↗
3. XPS and STM study of passive films formed on Fe-22Cr(110) single-crystal surfaces10.1149/1.1836616 ↗
4. Investigation of oxide film formation on 316L stainless steel in high-temperature aqueous environments10.1016/j.electacta.2011.04.127 ↗
5. XPS study of duplex stainless steel oxidized by oxygen atoms10.1016/j.corsci.2009.01.021 ↗
6. Growth process of passive films on austenitic stainless steels under wet-dry cyclic condition10.2355/isijinternational.52.1356 ↗
7. Passive films on stainless steels—chemistry, structure and growth10.1016/S0013-4686(02)00841-1 ↗
8. Passivity in metals and alloys10.1016/S0010-938X(79)80104-3 ↗
9. Passivity–the key to our metals-based civilization10.1351/pac199971060951 ↗
10. Cl-induced passivity breakdown in α-Fe2O3 (0001), α-Cr2O3 (0001), and their interface: A DFT study10.1016/j.jmst.2022.03.034 ↗
11. The history of the point defect model for the passive state: A brief review of film growth aspects10.1016/j.electacta.2010.11.005 ↗
12. In situ high-resolution microscopy on duplex stainless steels10.1149/1.1393564 ↗
13. The passivity of iron–chromium alloys10.1016/0010-938X(89)90060-7 ↗
14. Passivation mechanisms and pre-oxidation effects on model surfaces of FeCrNi austenitic stainless steel10.1016/j.corsci.2020.108483 ↗
15. Chloride-induced alterations of the passive film on 316L stainless steel and blocking effect of pre-passivation10.1016/j.electacta.2019.135159 ↗
16. On the origin of passive film breakdown and metastable pitting for stainless steel 316L10.1016/j.corsci.2024.111911 ↗
17. Protection of stainless steels by Mo against Cl attack: A dft study10.1021/acs.jpcc.4c08056 ↗
18. An xps and tof-sims study of the passive film formed on a model FeCrNiMo stainless steel surface in aqueous media after thermal pre-oxidation at ultra-low oxygen pressure10.1016/j.apsusc.2021.149435 ↗
19. Inhibition of initial surface oxidation by strongly bound hydroxyl species and Cr segregation: H2O and O2 adsorption on Fe–17Cr10.1016/j.susc.2009.08.006 ↗
20. A round robin on combined electrochemical and AES/ESCA characterization of the passive films on FeCr and FeCrMo alloys10.1016/0010-938X(88)90026-1 ↗
21. Passive film characterisation of duplex stainless steel using scanning Kelvin probe force microscopy in combination with electrochemical measurements10.1038/s41529-019-0071-8 ↗
22. Origin of nanoscale heterogeneity in the surface oxide film protecting stainless steel against corrosion10.1038/s41529-019-0091-4 ↗
23. The interaction of H2O molecules with iron films studied with MIES, UPS and XPS10.1016/j.susc.2012.02.002 ↗
24. A LEED-AES study of the initial stages of oxidation of Fe(001)10.1016/0039-6028(75)90413-6 ↗
25. A study of the initial reaction of water vapor with Fe(001) surface10.1016/0039-6028(77)90066-8 ↗
26. The mechanism of the oxidation and passivation of iron by water vapour—an electron spectroscopic study10.1016/0368-2048(77)80018-2 ↗
27. Initial oxidation stages on FeCr(100) and FeCr(110) surfaces10.1016/0039-6028(76)90408-8 ↗
28. XPS study of oxide nucleation and growth mechanisms on a model FeCrNiMo stainless steel surface10.1016/j.apsusc.2021.151681 ↗
29. CasaXPS: Processing software for XPS, AES, SIMS and more. http://www.casaxps.com/.
30. X-ray photoelectron spectroscopy studies of reactions on chromium metal and chromium oxide surfaces10.1016/j.elspec.2010.12.001 ↗
31. A consistent method for quantitative XPS peak analysis of thin oxide films on clean polycrystalline iron surfaces10.1016/S0169-4332(97)00167-0 ↗
32. Growth and characterisation of Cr2O3(0001) thin films on Cu(111)10.1016/j.susc.2005.06.097 ↗
33. Calculations of electron inelastic mean free paths. V. data for 14 organic compounds over the 50-2000 eV range10.1002/sia.740210302 ↗
34. Peak fitting of the chromium 2p XPS spectrum10.1016/0169-4332(95)00168-9 ↗
35. Resolving surface chemical states in XPS analysis of first row transition metals, oxides and hydroxides: Cr, Mn, Fe, Co and Ni10.1016/j.apsusc.2010.10.051 ↗
36. Atomic-scale view of water chemistry on nanostructured iron oxide films10.1021/acs.nanolett.4c03521 ↗
37. Chase · 1998 · 1529
38. Morphology and composition of nanoscale surface oxides on Fe–20Cr–18Ni{111} austenitic stainless steel10.1016/j.elspec.2006.12.002 ↗
39. Examination of the oxidation of iron by oxygen using x-ray photoelectron spectroscopy and QUASES™10.1016/j.susc.2004.06.210 ↗
40. Effects of hydrogen on disorder of passive films and pitting susceptibility of type 310 stainless steel10.1149/1.1344529 ↗