Response of a quartz crystal microbalance to a localized heat source: The case of MeV ion irradiation
Source abstract
Abstract
Quartz crystal microbalances (QCMs) are capable of detecting mass changes down to 10 pg cm − 2 s − 1 , but thermal and stress effects must be accounted for, even when SC-cut (stress-compensated) crystals are used. In this study, we examine the compatibility of two measurement techniques: A high-sensitivity quartz crystal microbalance (QCM) and ion beam analysis (IBA). When used hand in hand, IBA can complement the information obtained from a QCM by providing element-specific data. Our results show that the QCM operation is strongly influenced by the power dissipation of the ion beam. Since QCM operation requires thermal equilibrium, IBA should be performed after the QCM measurements. Large frequency changes occur during irradiation and the thermal relaxation after irradiation. We model these effects, which are due to both the direct temperature effect on the frequency and the influence of thermal stress. The frequency response has a fast and a slow component. The fast frequency change (within ≈ 1 s) is related to the inhomogeneous temperature distribution in the quartz plate, while the slow component is due to the low thermal conductivity between the quartz crystal and the holder. Further effects such as the influence of the beam damage on the crystal frequency are discussed. • Local MeV ion irradiation on a quartz crystal microbalance leads to a reversible fast response, a reversible slow response and a persistent frequency change. • The fast response is due to thermal stress induced by local heating. • The slow response is due to global heating of the quartz platelet as a whole. • The persistent frequency change is comparably small and is attributed to a combination of thermal desorption and radiation damage.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Acoustic Wave Resonator Technologies · Ion-surface interactions and analysis · Solid-state spectroscopy and crystallography
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (59)
Show source-provided references
1. Verwendung von Schwingquarzen zur Wägung dünner Schichten und zur Mikrowägung10.1007/BF01337937 ↗
2. Progress in monitoring thin film thickness by use of quartz crystals10.1016/0040-6090(89)90907-3 ↗
3. Sensors based on piezoelectric resonators10.1016/0924-4247(95)00846-2 ↗
4. Epitaxial metallic β-Nb2N films grown by MBE on hexagonal SiC substrates10.7567/APEX.8.085501 ↗
5. Movable holder for a quartz crystal microbalance for exact growth rates in pulsed laser deposition10.1063/5.0007643 ↗
6. Sputtering measurements using a quartz crystal microbalance as a catcher10.1016/j.nimb.2016.11.039 ↗
7. Erosion, screening, and migration of tungsten in the JET divertor10.1088/1741-4326/ab2aef ↗
8. Plasma–wall interaction studies within the EUROfusion consortium: Progress on plasma-facing components development and qualification10.1088/1741-4326/aa796e ↗
9. Challenges for plasma-facing components in nuclear fusion10.1063/1.5090100 ↗
10. A highly sensitive quartz-crystal microbalance for sputtering investigations in slow ion–surface collisions10.1063/1.1149979 ↗
11. Sputter yields of rough surfaces: Importance of the mean surface inclination angle from nano- to microscopic rough regimes10.1016/j.apsusc.2021.151204 ↗
12. Comparative study regarding the sputtering yield of nanocolumnar tungsten surfaces under Ar+ irradiation
13. Sputtering yield reduction for nano-columnar W surfaces under D ion irradiation
14. Ion-induced erosion of tungsten surfaces studied by a sensitive quartz-crystal-microbalance technique10.1016/j.jnucmat.2009.01.279 ↗
15. Space weathering on airless bodies10.1002/2016JE005128 ↗
16. Sputtering of water ice films: A re-assessment with singly and doubly charged oxygen and argon ions, molecular oxygen, and electrons10.1016/j.icarus.2017.03.018 ↗
17. Szabo · 2017
18. Sputter yields of the lunar surface: Experimental validation and numerical modelling of solar wind sputtering of Apollo 16 soils10.1038/s43247-025-02546-0 ↗
19. A high temperature dual-mode quartz crystal microbalance technique for erosion and thermal desorption spectroscopy measurements10.1063/5.0012028 ↗
20. Rutherford backscattering spectrometry10.1016/0042-207X(87)90327-7 ↗
21. Elastic recoil detection10.1088/0034-4885/56/7/002 ↗
22. Ion beam tools for nondestructive in-situ and in-operando composition analysis and modification of materials at the Tandem Laboratory in Uppsala10.1088/1748-0221/17/04/P04011 ↗
23. In-situ, real-time investigation of the formation of oxygen-containing rare-earth hydrides by combining a quartz crystal microbalance and ion beam analysis10.1016/j.mtla.2023.101675 ↗
24. Quartz resonator frequency shifts arising from electrode stress
25. An analysis of doubly rotated quartz resonators utilizing essentially thickness modes with transverse variation10.1121/1.393190 ↗
26. Frequency change of quartz crystal resonator caused during ion beam etching10.1143/JJAP.46.4647 ↗
27. Piezoelectric Resonators and Their Applications
28. SIGMA: A Set-up for In-situ Growth, Material modification and Analysis by ion beams10.1016/j.nimb.2019.11.007 ↗
29. SRIM – The stopping and range of ions in matter (2010)10.1016/j.nimb.2010.02.091 ↗
30. New development in freefem++
31. 1988
32. NIST-JANAF thermochemical tables
33. The thermal conductivity of insulators and semiconductors10.1080/00107518608211003 ↗
34. Measurement of the thermal conductivity of stainless steel AISI 304L up to 550 K10.1023/A:1025069405106 ↗
35. Normal spectral emissivity of gold, platinum, and tungsten10.1007/BF00861593 ↗
36. Thickness vibrations of doubly rotated crystal plates under initial deformations10.1109/T-UFFC.1987.26999 ↗
37. Frequency shift calculations for quartz resonators
38. Possibility of the existence of a topological defect in dynamic deformation of the free-standing ultrathin silicon wafer during MeV ion irradiation10.1063/5.0077180 ↗
39. Evaluation of mechanisms for low-dose frequency shifts in crystal oscillators10.1109/TNS.1986.4334621 ↗
40. Fundamental mode SC-cut resonators
41. C. Breakdown. Electric breakdown of solid dielectrics10.1039/tf946420a078 ↗
42. BVA-type quartz oscillator for spacecraft
43. Results from Gamma ray and proton beam radiation testing of quartz resonators10.1109/TNS.1984.4333488 ↗
44. Effects of reactor irradiation on thickness shear crystal resonators
45. Energy spectrum of neutrons from thermal fission of U23510.1103/PhysRev.87.1037 ↗
46. Opportunities and limitations for ion beams in radiation effects studies: Bridging critical gaps between charged particle and neutron irradiations10.1016/j.scriptamat.2017.06.041 ↗
47. Ionizing vs collisional radiation damage in materials: Separated, competing, and synergistic effects in Ti3SiC210.1016/j.actamat.2019.05.015 ↗
48. Electron irradiation damage in quartz10.1080/00337577408232044 ↗
49. Electron irradiation damage in natural quartz grains10.1007/BF00308226 ↗
50. Temperature measurements during high flux ion beam irradiations10.1063/1.4941720 ↗
51. SIMNRA, a simulation program for the analysis of NRA, RBS and ERDA10.1063/1.59188 ↗
52. Acoustic wave analysis of the operation of quartz-crystal film-thickness monitors10.1063/1.1656066 ↗
53. Investigation of film-thickness determination by oscillating quartz resonators with large mass load10.1063/1.1660931 ↗
54. General one-dimensional treatment of the layered piezoelectric resonator with two electrodes10.1121/1.395453 ↗
55. Layered piezoelectric resonators with an arbitrary number of electrodes (general one-dimensional treatment)10.1121/1.401915 ↗
56. Renton · 2005
57. Nonuniformly heated anisotropic plates: I. Mechanical distortion and relaxation10.1109/T-SU.1974.29811 ↗
58. Elastic and piezoelectric constants of alpha-quartz10.1103/PhysRev.110.1060 ↗
59. Quartz resonator frequency shifts computed using the finite element method10.1002/nme.1620360303 ↗