Analysis of the effect of coupling coefficients on the slope of PDH-locked frequency discriminator
Source abstract
Abstract
The effects of the coupling coefficients on the reflected field and the error signal under various misalignments and near-axis conditions are analyzed, and some basic features of the error signal are investigated. According to the definition of traditional coupling efficiency, the relationship between the discriminator slope and the coupling efficiency under the condition of misalignment of waist radius and waist position is derived. The experimental results are in good agreement with the theoretical simulations, the error of the results measured by transmission is within 2%, and the error of the results measured by reflection is within 4%. It shows that the discriminator slope has different expressions under different approximation conditions. On this basis, a fast and simple method for measuring the discriminator slope is found.
Source: crossref · Quality: baseline
Research context
OpenAlex topics: Advanced Frequency and Time Standards · Advanced Fiber Laser Technologies · Atomic and Subatomic Physics Research
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
MOE Key Laboratory of TianQin Mission, TianQin Research Center for Gravitational Physics and School of Physics and Astronomy, Frontiers Science Center for TianQin, Gravitational Wave Research Center of CNSA, Sun Yat-sen University (Zhuhai Campus) 1 , Zhuhai 519082,
University of Chinese Academy of Sciences 2 , Beijing 100039,
Funding
National Key Research and Development Program of China
References (24)
Show source-provided references
1. Measurement of the 199Hg+ 5d96s22D5/2 electric quadrupole moment and a constraint on the quadrupole shift10.1103/physrevlett.94.163001 ↗
2. Frequency comparison of two high-accuracy Al+ optical clocks10.1103/physrevlett.104.070802 ↗
3. LIGO: The laser interferometer gravitational-wave observatory10.1088/0034-4885/72/7/076901 ↗
4. Two-color squeezing and sub-shot-noise signal recovery in doubly resonant optical parametric oscillators10.1103/physreva.42.556 ↗
5. Laser phase and frequency stabilization using an optical resonator10.1007/bf00702605 ↗
6. Thermal-noise-limited higher-order mode locking of a reference cavity10.1364/ol.43.001690 ↗
7. Coupling coefficients of an incident wave and the modes of a spherical optical resonator in the case of mismatching and misalignment10.1364/ao.23.001369 ↗
8. Characterization of high-finesse mirrors: Loss, phase shifts, and mode structure in an optical cavity10.1103/physreva.64.033804 ↗
9. Optical characterization of a fiber Fabry-Perot cavity: Precision measurement of intra-cavity loss, transmittance, and reflectance10.1364/oe.517403 ↗
10. Performance analysis of Drever-Hall laser frequency stabilization using a proportional+integral servo10.1109/3.563380 ↗
11. Notes on the Pound-Drever-Hall technique
12. An introduction to Pound–Drever–Hall laser frequency stabilization10.1119/1.1286663 ↗
13. Suppression of residual amplitude modulation effects in Pound–Drever–Hall locking10.1007/s00340-018-7021-y ↗
14. Characterization of electrical noise limits in ultra-stable laser systems10.1063/1.4971852 ↗
15. Power coupling losses for misaligned and mode-mismatched higher-order Hermite–Gauss modes10.1364/ol.426999 ↗
16. Precision measurement of ultralow losses of an asymmetric optical microcavity10.1364/ao.45.007628 ↗
17. Analysis of alignment requirements for off-axis resonant cavity based on coupling efficiency10.1364/ao.510901 ↗
18. Interferometer techniques for gravitational-wave detection10.1007/s41114-016-0002-8 ↗
19. Laser beams and resonators10.1364/ao.5.001550 ↗
20. 1986
21. Phase-sensitive reflection technique for characterization of a Fabry–Perot interferometer10.1364/ao.39.003638 ↗
22. Generation of squeezed vacuum state in the millihertz frequency band10.1038/s41377-024-01606-y ↗
23. Demonstration of channel multiplexing quantum communication exploiting entangled sideband modes10.1103/physrevlett.125.070502 ↗
24. Optimizing frequency noise calibration and manipulation in an active feedback control loop10.1016/j.optlastec.2024.110617 ↗