journal article·2023-12-01Open access

Electrical microparticle acceleration by high-speed membrane deformation

D. Ichihara, R. Takata

AIP Advances· Volume 13· Issue 12

Abstract

In this study, we conducted experiments to explore the potential of a low-power exploding foil initiator for accelerating microparticles through high-speed membrane deformation. This involved the use of a conductive layer with a conversion section known as a “bridge,” which was positioned between the substrate and the cover layer. The application of pulsed electrical energy led to Joule heating at the bridge, while the vaporized gas generated impulsive loading, resulting in the deformation of the cover layer. According to the principles of energy conservation, 8.7% of the electrical input energy was converted into kinetic energy for the membrane. This deformation process achieved a velocity of 800 m/s, with a corresponding strain rate of 1.6 × 107 s−1. The applied impulse predominantly induced extension stresses in the cover layer rather than bending stresses. Under these conditions, a 17.5-µm radius polylactic acid bead was propelled and subsequently captured by a silicone gel layer, resembling human dermic skin. Considering factors such as particle clustering and deceleration due to air resistance during supersonic flight, assuming a normal incident angle, it was estimated that approximately half of the ejected particles could reach the human dermic layer, located 200 µm beneath the skin surface. These findings suggest that pulse discharge is a promising method for inducing high-speed membrane deformation, and the electrical microparticle accelerator holds potential for applications in needle-free drug delivery.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Electrohydrodynamics and Fluid Dynamics · Plant Surface Properties and Treatments · Nanomaterials and Printing Technologies

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Department of Aerospace Engineering, Nagoya University , Nagoya, Aichi 464-8603, Japan

Funding

Fusion Oriented REsearch for Disruptive Science and Technology

References (28)

Show source-provided references
1. Hypervelocity impact experiments in iron-nickel ingots and iron meteorites: Implications for the NASA psyche mission10.1029/2019je005927 ↗
2. Immunization without needles10.1038/nri1728 ↗
3. An improved biolistic delivery and analysis method for evaluation of DNA and CRISPR-Cas delivery efficacy in plant tissue10.1038/s41598-021-86549-9 ↗
4. A brief review on cold spray coating process10.1016/j.matpr.2020.01.482 ↗
5. Effect of sandblasting on the long-term performance of dental ceramics10.1002/jbm.b.30097 ↗
6. Energy conversion efficiency of electrical exploding foil accelerators10.1063/5.0061699 ↗
7. High strain rate deformation of layered nanocomposites10.1038/ncomms2166 ↗
8. High-velocity micro-projectile impact testing10.1063/5.0040772 ↗
9. Performance analysis of a new biolistic gun using high power laser irradiation10.1007/s00339-010-5835-5 ↗
10. Studying the high-rate deformation of soft materials via laser-induced membrane expansion10.1039/d2sm01392d ↗
11. System modeling and simulation of flyer acceleration and explosive detonation in exploding foil initiator10.1063/5.0155115 ↗
12. Extreme measurements with photonic doppler velocimetry (PDV)10.1063/5.0004363 ↗
13. Digital signal processing for velocity measurements in dynamical material’s behaviour studies10.1063/1.4866683 ↗
14. Rigid-plastic membrane response of thin plates under impulsive blast loads using the extended Hamilton principle10.1016/j.ijimpeng.2023.104624 ↗
15. Optimization of a diaphragm for a micro-shock tube-based drug delivery method10.3390/bioengineering4010024 ↗
16. Development of micro-shock wave assisted dry particle and fluid jet delivery system10.1007/s00253-012-4196-8 ↗
17. Material parameters in constitutive equation for plastic deformation at a high strain rate estimated by high-velocity microparticle collisions10.1007/s11665-022-07507-8 ↗
18. S. C. Schmidt , W. L.Seitz, and J.Wackerie, “An empirical model to compute the velocity histories of flyer driven by electrically exploding foils,” Technical Report No. LA-6809, Los Alamos Laboratory, 1977.10.2172/7308751 ↗
19. 1983 · 314
20. The London–van der Waals interaction energy between objects of various geometries10.1088/0953-8984/13/9/101 ↗
21. Capillary flow as the cause of ring stains from dried liquid drops10.1038/39827 ↗
22. Suppression of the coffee-ring effect by sugar-assisted depinning of contact line10.1038/s41598-018-35998-w ↗
23. Laser-driven high-velocity microparticle launcher in atmosphere and under vacuum10.1016/j.ijimpeng.2019.103465 ↗
24. A unified theory of penetration10.1016/0734-743x(87)90041-8 ↗
25. High-strain-rate behavior of a viscoelastic gel under high-velocity microparticle impact10.1007/s11340-020-00639-9 ↗
26. Particle drag and heat transfer in rocket nozzles10.2514/3.2714 ↗
27. Skin thickness dimensions in histological section measurement during late-fetal and neonatal developmental period: A systematic review10.1111/srt.12719 ↗
28. Needleless vaccine delivery using micro-shock waves10.1128/cvi.00494-10 ↗