journal article·2017-03-01Open access

Kinetics of the permanent deactivation of the boron-oxygen complex in crystalline silicon as a function of illumination intensity

Verena Steckenreiter, Dominic C. Walter, Jan Schmidt

AIP Advances· Volume 7· Issue 3

Abstract

Based on contactless carrier lifetime measurements performed on p-type boron-doped Czochralski-grown silicon (Cz-Si) wafers, we examine the rate constant Rde of the permanent deactivation process of the boron-oxygen-related defect center as a function of the illumination intensity I at 170°C. While at low illumination intensities, a linear increase of Rde on I is measured, at high illumination intensities, Rde seems to saturate. We are able to explain the saturation by assuming that Rde increases proportionally with the excess carrier concentration Δn and take the fact into account that at sufficiently high illumination intensities, the carrier lifetime decreases with increasing Δn and hence the slope of Δn(I) decreases, leading to an apparent saturation. Importantly, on low-lifetime Cz-Si samples no saturation of the deactivation rate constant is observed for the same illumination intensities, proving that the deactivation is stimulated by the presence of excess electrons and not directly by the photons.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Silicon and Solar Cell Technologies · Semiconductor materials and interfaces · Thin-Film Transistor Technologies

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Institute for Solar Energy Research Hamelin (ISFH) 1 , Am Ohrberg 1, D-31860 Emmerthal, Germany

Leibniz Universität Hannover 2 Department of Solar Energy, Institute of Solid-State Physics, , Appelstraße 2, D-30607 Hannover, Germany

Funding

Bundesministerium für Wirtschaft und Energie · Gottfried Wilhelm Leibniz Universität Hannover

References (19)

Show source-provided references
1. Investigation of photon and thermal induced changes in silicon solar cells
2. On the degradation of Cz-silicon solar cells
3. Investigation of carrier lifetime instabilities in CZ-grown silicon
4. Structure and transformation of the metastable boron- and oxygen-related defect center in crystalline silicon10.1103/physrevb.69.024107 ↗
5. A new approach to prevent the negative impact of the metastable defect in boron doped Cz silicon solar cells
6. Investigations on the long time behavior of the metastable boron–oxygen complex in crystalline silicon10.1002/pip.779 ↗
7. Deactivation of the boron–oxygen recombination center in silicon by illumination at elevated temperature10.1002/pssr.200802009 ↗
8. Further investigations on the avoidance of boron-oxygen related degradation by means of regeneration
9. Cleaning solutions based on hydrogen peroxide for use in silicon semiconductor technology10.1155/2011/579427 ↗
10. Effective surface passivation of crystalline silicon using ultrathin Al2O3 films and Al2O3/SiNx stacks10.1002/pssr.200903272 ↗
11. Comparison of the thermal stability of single Al2O3 layers and Al2O3/SiNx stacks for the surface passiviation of silicon10.1016/j.egypro.2011.06.141 ↗
12. Effect of rapid thermal annealing on recombination centres in boron-doped Czochralski-grown silicon10.1063/1.4863674 ↗
13. Influence of hydrogen effusion from hydrogenated silicon nitride layers on the regeneration of boron-oxygen related defects in crystalline silicon10.1063/1.4833243 ↗
14. Electrical and thermal properties of the metastable defect in boron-doped Czochralski silicon (Cz-Si)
15. Measurement of the emitter saturation current by a contactless photoconductivity decay method
16. Contactless determination of current–voltage characteristics and minoritycarrier lifetimes in semiconductors from quasi-steady-state photoconductance data10.1063/1.117723 ↗
17. Dynamic carrier lifetime imaging of silicon wafers using an infrared-camera-based approach10.1063/1.2972122 ↗
18. Permanent deactivation of boron-oxygen recombination centres in silicon10.1002/pssb.201600082 ↗
19. Of apples and oranges: Why comparing BO regeneration rates requires injection level correction