journal article·2016-10-01Open access

Single-conductor co-planar quasi-symmetry unequal power divider based on spoof surface plasmon polaritons of bow-tie cells

Yongle Wu, Mingxing Li, Guangyou Yan, Li Deng, Yuanan Liu, Zabih Ghassemlooy

AIP Advances· Volume 6· Issue 10

Abstract

In this paper, the spoof surface plasmon polaritons (SSPPs) transmission line (TL) of periodical grooved bow-tie cells is proposed. The complex propagation constant and characteristic impedance of the SSPPs TLs and microstrip lines (MLs) are extracted using the analytical method of generalized lossy TL theory. The properties of the SSPPs TLs with different substrates and the same geometrical configuration are experimented. Then, for comparison, two ML counterparts are also experimented, which shows that the SSPPs TL is less sensitive to the thickness, dielectric constant and loss tangent of the chosen substrate below the cutoff frequency, compared with the ML ones. The single-conductor co-planar quasi-symmetry unequal power divider based on this SSPPs TL is presented in microwave frequencies. For experimental validation, the 0-dB, 2-dB, and 5-dB power dividers are designed, fabricated, and measured. Both simulated and measured results verify that the unequal power divider is a flexible option, which offers massive advantages including single-conductor co-planar quasi-symmetry structures, wide-band operation, and convenient implementations of different power-dividing ratios. Hence, it can be expected that the proposed unequal power dividers will inspire further researches on SSPPs for future design of novel planar passive and active microwave components, circuits and systems.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Microwave Engineering and Waveguides · Plasmonic and Surface Plasmon Research · Photonic and Optical Devices

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Beijing University of Posts and Telecommunications 1 Beijing Key Laboratory of Work Safety Intelligent Monitoring, School of Electronic Engineering, , P.O. Box. 282, 100876 Beijing, China

University of Electronic Science and Technology of China 2 School of Physical Electronics, , 610054 Chengdu, Sichuan, China

Beijing University of Posts and Telecommunications 3 Beijing Key Laboratory of Network System Architecture and Convergence, School of Information and Communication Engineering, , 100876 Beijing, China

Northumbria University 4 Optical Communications Research Group, NCRLab, Faculty of Engineering and Environment, , Newcastle upon Tyne NE1 8ST, United Kingdom

References (28)

Show source-provided references
1. Surface plasmon subwavelength optics10.1038/nature01937 ↗
2. Mimicking surface plasmons with structured surfaces10.1126/science.1098999 ↗
3. Terahertz surface plasmon-polariton propagation and focusing on periodically corrugated metal wires10.1103/PhysRevLett.97.176805 ↗
4. High-order modes of spoof surface plasmon polaritons on periodically corrugated metal surfaces10.2528/PIERM09062901 ↗
5. High-order modes of spoof surface plasmonic wave transmission on thin metal film structure10.1364/OE.21.031155 ↗
6. Conformal surface plasmons propagating on ultrathin and flexible films10.1073/pnas.1210417110 ↗
7. Broadband transition between microstrip line and conformal surface plasmon waveguide10.1088/0022-3727/47/31/315103 ↗
8. Odd-mode surface plasmon polaritons supported by complementary plasmonic metamaterial10.1038/srep09250 ↗
9. Dual-band trapping of spoof surface plasmon polaritons and negative group velocity realization through microstrip line with gradient holes10.1063/1.4935976 ↗
10. Highly-confined and low-loss spoof surface plasmon polaritons structure with periodic loading of trapezoidal grooves10.1063/1.4926770 ↗
11. Trapping of surface plasmon wave through gradient corrugated strip with underlayer ground and manipulating its propagation10.1063/1.4905675 ↗
12. Design and modeling of spoof surface plasmon modes-based microwave slow-wave transmission line10.1109/TMTT.2015.2422694 ↗
13. Smaller-loss planar SPP transmission line than conventional microstrip in microwave frequencies10.1038/srep23396 ↗
14. An ultra-wideband surface plasmonic filter in microwave frequency10.1063/1.4876962 ↗
15. A hybrid circuit for spoof surface plasmons and spatial waveguide modes to reach controllable band-pass filters10.1038/srep16531 ↗
16. Broadband frequency-selective spoof surface plasmon polaritons on ultrathin metallic structure10.1038/srep08165 ↗
17. Controlling rejections of spoof surface plasmon polaritons using metamaterial particles10.1364/OE.22.013940 ↗
18. Domino plasmons for subwavelength terahertz circuitry10.1364/oe.18.000754 ↗
19. A directional coupler based on spoof MIM plasmonic structures
20. Planar surface plasmonic waveguide devices based on symmetric corrugated thin film structures10.1364/OE.22.020107 ↗
21. Ultra-wideband surface plasmonic Y-splitter10.1364/OE.23.023270 ↗
22. Compact feeding network for array radiations of spoof surface plasmon polaritons10.1038/srep22692 ↗
23. Ku-band 200-W pulsed power amplifier based on waveguide spatially power-combining technique for industrial applications10.1109/TIE.2013.2284137 ↗
24. Novel parasitic micro strip arrays for low-cost active phased array applications10.1109/TAP.2013.2262071 ↗
25. Design and measurement of a doppler radar with new quadrature hybrid mixer for vehicle applications10.1109/TMTT.2010.2045568 ↗
26. 2012
27. A generalized lossy transmission-line model for tunable Graphene-based transmission lines with attenuation phenomenon10.1038/srep31760 ↗
28. Analytical design method of multiway dual-band planar power dividers with arbitrary power division10.1109/TMTT.2010.2086712 ↗