Strap grid tubular plate—a new positive plate for lead–acid batteries
Source abstract
Abstract
For almost a century now the tubular plate design has been based on cylindrical tubes and spines. The contact surface between the positive active mass (PAM) and the spine is small, which results in high polarisation of the plate at high discharge currents and low power output of the cell. In an attempt to eliminate these disadvantages, the shape of the tubes has been changed to flattened elliptic and the spines have been replaced by strap grids. The thickness of this new type of tubular plate, strap grid tubular plate (SGTP), is between 3 and 5 mm. Batteries with tubular plates of the new design (SGTP batteries) can be used in electric vehicle (EV) and photovoltaic (PV) system applications. This paper presents results of SGTP battery tests according to the European standards for EV, hybrid electric vehicle (HEV) and photovoltaic (PV) system batteries. SGTP batteries have a cycle life of 1000 ECE-15-EV cycles, 6000 ECE-HEV cycles and more than eight gross PV cycles. The optimum battery charge algorithm for VRLA batteries with strap grid tubular plates has been established and the mechanism of disintegration of the positive active mass has been disclosed. The following phenomena are responsible for the decline in capacity of the positive plates. First, when the PAM is built up of globules adhering closely to each other, a strong skeleton with thick aggregates (branches) with a membrane surface is formed. The surface layer of the branches impedes the access of H 2O and H 2SO 4 to their interior thus reducing the utilisation of the PAM. Besides, internal stresses are created in the aggregates, which cause them to crack. Secondly, when the PAM is built up of individual agglomerates with micropores in between, a porous mass with large surface is formed. The tubes keep the aggregates together and prolong the cycle life of the battery. During discharge, the contacts between the aggregates weaken and the capacity declines. Third, during discharge, the H 2SO 4 concentration in the pores of the plate inner layers (close to the straps) increases. In concentrated H 2SO 4 solution the solubility of PbSO 4 crystals decreases. This slows down the rate of oxidation of PbSO 4 to PbO 2. Some parts of the PbSO 4 crystals in the PAM of the charged plate remain unoxidised (residual sulphation). Thus, the capacity of the plate is lower. Strap corrosion is the phenomenon that may limit the cycle life of SGT plates.
Source: expertdata · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Advanced Battery Technologies Research · Electric and Hybrid Vehicle Technologies · Supercapacitor Materials and Fabrication
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (13)
Show source-provided references
1. Pavlov · J. Electrochem. Soc. · 1986 · 133 · 24110.1149/1.2108555 ↗
2. Takahashi · J. Electrochem. Soc. · 1986 · 130 · 214410.1149/1.2119542 ↗
3. Pavlov · J. Power Sources · 1995 · 53 · 910.1016/0378-7753(94)02152-S ↗
4. International standard IEC 61427 (1997).
5. Specification of test procedures for electric vehicle traction batteries, EUCAR, December 1996.
6. Specification of test procedures for hybrid electric vehicle traction batteries, EUCAR, October 1997.
7. Pavlov · J. Power Sources · 1993 · 42 · 7110.1016/0378-7753(93)80138-F ↗
8. Pavlov · J. Electrochem. Soc. · 1992 · 139 · 183010.1149/1.2069506 ↗
9. Vinal · J. Res. Natl. Bur. Stand. · 1939 · 22 · 5510.6028/jres.022.052 ↗
10. Danel · Electrochim. Acta · 1984 · 27 · 1643
11. Dimitrov · J. Power Sources · 2001 · 93 · 23410.1016/S0378-7753(00)00598-X ↗
12. Pavlov · J. Electrochem. Soc. · 1987 · 134 · 239010.1149/1.2100210 ↗
13. Pavlov · J. Power Sources · 1990 · 30 · 7710.1016/0378-7753(93)80065-W ↗