journal article·2022-02

Defect-induced pyrochlore Pr2Zr2O7 cathode rich in oxygen vacancies for direct ammonia solid oxide fuel cells

Fulan Zhong, Shiqing Yang, Chongqi Chen, Huihuang Fang, Kongfa Chen, Chen Zhou, Li Lin, Yu Luo, Chaktong Au, Lilong Jiang

Publisher page

Abstract

Abstract In this study, pyrochlore Pr2B2O7 oxides (B Zr, ZrSn, Sn, PZO/PZSO/PSO) and perovskite (B Ti, PTO) were prepared as direct ammonia solid oxide fuel cell (DA-SOFC) cathode with oxygen reduction reaction activity induced by B-site cationic defects. Compared with PTO, the pyrochlore PBO with unoccupied 8a-oxygen sites are high in inherent oxygen vacancies (ca. 12.5%), leading to enhanced migration of lattice oxygen. Among the n-type semiconductors, PZO is with a more negative flat-band potential and is more effective in terms of overcoming energy barriers. As a result, the conductivity of PZO is two orders of magnitude higher than that of PTO at 800 °C. The oxygen transport performance reveals that the surface exchange coefficient of PZO is about one order of magnitude higher than that of La0.7Sr0.3MnO3-δ at 900 °C. Owing to high conductivity, fast oxygen transport, and matched thermal expansion coefficient, an anode-supported DA-SOFC using the PZO-based cathode can offer a maximum power density of 0.25 W cm−2 at 600 °C and 1.22 W cm−2 at 800 °C, operating continuously over 100 h without obvious degradation. The electrochemical performance is 2.3 folds higher than those of SOFCs using other PBO-based cathode, and higher than most reported SOFCs with the cathodes using A-site Pr.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Advancements in Solid Oxide Fuel Cells · Electronic and Structural Properties of Oxides · Nuclear materials and radiation effects

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (58)

Show source-provided references
1. Solid oxide fuel cells (SOFCs): a review of an environmentally clean and efficient source of energy10.1016/S1364-0321(02)00014-X ↗
2. Solid oxide fuel cell (SOFC) performance evaluation, fault diagnosis and health control: a review10.1016/j.jpowsour.2021.230058 ↗
3. Ammonia as an effective hydrogen carrier and a clean fuel for solid oxide fuel cells10.1016/j.enconman.2020.113729 ↗
4. Comparative study on the performance of a SDC-based SOFC fueled by ammonia and hydrogen10.1016/j.jpowsour.2007.05.002 ↗
5. Direct utilization of ammonia in intermediate-temperature solid oxide fuel cells, Electrochem
6. An ammonia fuelled SOFC with a BaCe0.9Nd0.1O3-δ thin electrolyte prepared with a suspension spray10.1016/j.jpowsour.2007.03.059 ↗
7. Comparative study of ammonia-fueled solid oxide fuel cell systems10.1002/fuce.201600165 ↗
8. Development of lanthanum strontium cobalt ferrite perovskite electrodes of solid oxide fuel cells–A review10.1016/j.ijhydene.2019.01.212 ↗
9. Structure and electrical properties of La1−xSrxCo1−yFeyO3. Part 1. The system La0.8Sr0.2Co1−yFeyO310.1016/0167-2738(94)00244-M ↗
10. Thermal expansion behavior and chemical compatibility of BaxSr1-xCo1-yFeyO3-δ with 8YSZ and 20GDC
11. Potential of pyrochlore structure materials in solid oxide fuel cell applications10.1016/j.ceramint.2020.10.012 ↗
12. Crystal and magnetic structure of the Bi2RuMnO7 pyrochlore: a potential new cathode for solid oxide fuel cells10.1016/j.jpowsour.2013.08.125 ↗
13. A2B2O7 pyrochlore compounds: a category of potential materials for clean energy and environment protection catalysis10.1016/j.jre.2020.01.002 ↗
14. Synthesis and characterization of R2MnTiO7 (R=Y and Er) pyrochlores oxides10.1016/j.materresbull.2013.05.003 ↗
15. The effect of homovalent A-site substitutions on the ionic conductivity of pyrochlore-type Gd2Zr2O710.1016/j.jpowsour.2008.09.106 ↗
16. Phase composition and disorder in La2(Sn,Ti)2O7 ceramics: new insights from NMR crystallography10.1021/acs.jpcc.6b06962 ↗
17. High ionic conductivity in the pyrochlore-type Gd2-yLayZr2O7 solid solution (0 ≤ y ≤ 1)10.1016/j.ssi.2008.07.015 ↗
18. Doped PrMnO3 perovskite oxide as a new cathode of solid oxide fuel cells for low temperature operation10.1149/1.2048606 ↗
19. Electrical conductivity and dielectric properties of rare earth ions (Ce3+, Pr3+ and Eu3+) doped in zinc sodium phosphate glass10.1016/j.jnoncrysol.2021.120933 ↗
20. Studies on order - disorder transition, lattice expansion and ionic conductivity in aliovalent cation substituted Sm2Zr2O7 System10.1016/j.jssc.2017.08.011 ↗
21. Effect of structure and thermodynamic stability on the response of lanthanide stannate pyrochlores to ion beam irradiation10.1021/jp055266c ↗
22. Room-temperature magnetoelectric coupling in nanocrystalline nanocrystalline Pr2Ti2O710.1016/j.physb.2013.08.047 ↗
23. The structural transformation from the pyrochlore structure, A2B2O7, to the fluorite structure, AO2, studied by Raman spectroscopy and defect chemistry modeling10.1006/jssc.2000.9142 ↗
24. Structure, Raman spectra and defect chemistry modelling of conductive pyrochlore oxides10.1016/S0167-2738(00)00417-3 ↗
25. Structural stability and anharmonicity of Pr2Ti2O7: Raman spectroscopic and XRD studies10.1021/acs.inorgchem.6b01873 ↗
26. Electronic structure of layered ferroelectric high-k titanate Pr2Ti2O710.1016/j.jssc.2012.02.033 ↗
27. Thermal expansion and conductivity of RE2Sn2O7 (RE=La, Nd, Sm, Gd, Er and Yb) pyrochlores10.1016/j.scriptamat.2013.05.030 ↗
28. Oxygen transport, thermal and electrochemical properties of NdBa0.5Sr0.5Co2O5+δ cathode for SOFCs10.1016/j.jeurceramsoc.2018.01.022 ↗
29. A New Family of Mo-Doped SrCoO3 perovskites for application in reversible solid state electrochemical cells10.1021/cm300255r ↗
30. Evaluation of the La2Ni1-xCuxO4+δ system as SOFC cathode material with 8YSZ and LSGM as electrolytes10.1016/j.ssi.2008.01.099 ↗
31. Sm0.5Sr0.5CoO3 cathodes for low-temperature SOFCs10.1016/S0167-2738(02)00131-5 ↗
32. Preparation of NdBaCo2O5+δ-Ce0.9Gd0.1O1.95 composite cathode by in situ sol-mixing method and its high-temperature electrochemical properties10.1016/j.jallcom.2021.160901 ↗
33. Praseodymium 3d- and 4d-core photoemission spectra of Pr2O310.1103/PhysRevB.44.5465 ↗
34. Kinetic and structural studies of oxygen availability of the mixed oxides Pr1-xMxOy (M=Ce, Zr)10.1557/JMR.1996.0247 ↗
35. Effect of Pr3+/Pr4+ ratio on the oxygen ion transport and thermomechanical properties of the pyrochlore and fluorite phases in the ZrO2-Pr2O3 system10.1016/j.ijhydene.2016.02.152 ↗
36. Electronic and chemical properties of nanostructured cerium dioxide doped with praseodymium10.1021/jp045828c ↗
37. Thermochemical behavior and transport properties of Pr-substituted SrTiO3 as potential solid oxide fuel cell anode10.1016/j.jpowsour.2013.07.019 ↗
38. Novel Y2-xPrxRu2O7 (x=0-2) pyrochlore oxides prepared using a soft chemistry route and their electrical properties10.1111/j.1551-2916.2010.03666.x ↗
39. Characterization and evaluation of double perovskites LnBaCoFeO5+δ (Ln=Pr and Nd) as intermediate-temperature solid oxide fuel cell cathodes10.1016/j.jpowsour.2013.05.187 ↗
40. The Pr promotion effect on oxygen storage capacity of Ce-Pr oxides studied using a TAP reactor10.1016/j.apcata.2007.06.023 ↗
41. Manganese-lanthanum oxides modified with silver for the catalytic combustion of methane10.1016/j.jcat.2004.07.022 ↗
42. Ni/Ln2Zr2O7 (Ln=La, Pr, Sm and Y) catalysts for methane steam reforming: on the effects of A site replacement10.1039/C7CY00004A ↗
43. Photoelectrochemical characterization of n-type and p-type thin-film nanocrystalline Cu2ZnSnSe4 photocathodes10.1016/j.jece.2014.11.018 ↗
44. Nb/Se Co-doped BiOI nanomaterials with exposed (110) facets for enhanced visible-light-driven photocatalytic activity10.1039/D1CC01336J ↗
45. Effect of semiconducting properties of oxide-based compounds on oxygen reduction activity in acidic media10.1149/09809.0457ecst ↗
46. Effect of non-stoichiometry and synthesis temperature on the structure and conductivity of Ln2+xM2-xO7-x/2 (Ln=Sm-Gd; M=Zr, Hf; x=0-0.286)10.1016/j.ssi.2006.11.001 ↗
47. Probing oxygen vacancy effect on oxygen reduction reaction of the NdBaCo2O5+δ cathode for solid oxide fuel cells10.1016/j.jpowsour.2020.228017 ↗
48. A novel facile strategy to suppress Sr segregation for high-entropy stabilized La0·8Sr0·2MnO3-δ cathode10.1016/j.jpowsour.2020.228959 ↗
49. Preparation and electrochemical performance of Pr2Ni0.6Cu0.4O4 cathode materials for intermediate-temperature solid oxide fuel cells10.1016/j.jpowsour.2010.11.106 ↗
50. PrNi0.6Co0.4O3-Ce0.8Sm0.2O1.9 composite cathodes for intermediate temperature solid oxide fuel cells10.1016/j.jpowsour.2011.10.025 ↗
51. Pr4Ni3O10+δ : a new promising oxygen electrode material for solid oxide fuel cells10.1016/j.jpowsour.2016.03.012 ↗
52. Highly active self-assembled hybrid catalyst with multiphase heterointerfaces to accelerate cathodic oxygen reduction of intermediate- temperature solid oxide fuel cells10.1016/j.ceramint.2019.12.233 ↗
53. Synthesis of Pr2CuO4 powders by using a glycine-nitrate combustion method for cathode application in intermediate-temperature solid oxide fuel cells10.1016/j.ceramint.2015.03.182 ↗
54. Surface exchange and bulk diffusivity of LSCF as SOFC cathode: electrical conductivity relaxation and isotope exchange characterizations10.1149/2.044304jes ↗
55. Effects of crystallographic orientation on the oxygen exchange rate of La0.7Sr0.3MnO3 thin films10.1016/j.ssi.2011.05.004 ↗
56. Characterization of LSM-YSZ composite electrode by ac impedance spectroscopy
57. A highly efficient multi-phase catalyst dramatically enhances the rate of oxygen reduction10.1016/j.joule.2018.02.008 ↗
58. Performance and reaction process of Ba1−xCo0.7Fe0.2Nb0.1O3-δ cathode for intermediate-temperature solid oxide fuel cell10.1016/j.jallcom.2021.161158 ↗