article·2007-02-07

Transitions of barium strontium titanate ferroelectric ceramics for different strontium content

A. Ioachim, M.I. Toacsăn, M.G. Banciu, L. Nedelcu, A. Dutu, S. Antohe, C. Berbecaru, L. Georgescu, G. Stoica, H.V. Alexandru

Publisher page

Abstract

Abstract Ceramic based barium strontium titanate (BST) solid solutions with the formula Ba 1 − x Sr x TiO 3 are very important candidates for a wide range of device applications. Several doped (Mn and Mg) and undoped samples were prepared by standard solid-state reaction. Special emphasis was put on compositions with x = 0.35 and 0.60, with high potential for applications. The samples were sintered at temperatures in the 1200 ÷ 1260 °C range. Structural X-ray diffraction analysis preformed confirms the perovskite structure. The dielectric parameters were investigated in a wide temperature range between − 150 and 150 °C. The temperature was cyclically changed in both directions, up and down, at a rate of less than 2 °C/min. Both permittivity and dielectric loss were measured at low frequencies, 1 kHz. The peak values of the permittivity are increasing from 2000 to 4000 with the sintering temperature increase. Moreover the dielectric parameters were measured at room temperature in microwave domain (1 ÷ 2 GHz). The Curie temperature of BST samples with x = 0.35 and x = 0.6 is in agreement with the Curie point dependence on Sr content, as we have previously reported.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Ferroelectric and Piezoelectric Materials · Microwave Dielectric Ceramics Synthesis · Multiferroics and related materials

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References

Reference metadata was not supplied for this record.