article·2024-09-07Open access

Characterization of MoS2:Nb sputtered thin films. An application as hole transport layer in Cu2ZnSnS4/Si tandem solar cells

Claudia Malerba, Matteo Valentini, Francesca Menchini, Daniele Mirabile Gattia, E. Salza, A. Mittiga

Abstract

• Sputtered MoS 2 :Nb films are investigated as infrared-transparent contacts. • The influence of sputtering pressure on the MoS 2 :Nb films properties is discussed. • Despite Nb-doping, a n-type conductivity is found and discussed. • The high work function (≈5 eV) makes the films suitable as hole transport layer. • MoS2 films are tested in single Cu2ZnSnS4 and tandem Cu2ZnSnS4/c-Si solar cells. MoS 2 :Nb films deposited by radio-frequency magnetron sputtering are investigated in view of their application in infrared (IR)-transparent contacts for tandem photovoltaic devices. This material is already known to give a good electrical contact with p-type chalcogenide semiconductors, which are typically grown onto opaque molybdenum metallic contacts and a MoS 2 layer spontaneously forms at the back interface during the on-top semiconductor growth. Our study explores a different approach, which involves the direct growth of IR-transparent MoS 2 :Nb films via sputtering inside complete photovoltaic devices, like Cu 2 ZnSnS 4 (CZTS)-based single junction solar cells and CZTS/Si tandem devices. Films deposited at different sputtering pressures are compared by analysing their microstructure, morphology, chemical composition, optical and electrical properties. The effects of post-deposition sulfurization treatments are also investigated. We find that MoS 2 :Nb films deposited at around 0.1 Pa exhibit compactness but show a notable sulfur deficit ([S]/[Mo]≈1.4), a significant sub-bandgap optical absorptance and lack of crystallinity. Increasing the Ar pressure to 1 Pa raises the [S]/[Mo] ratio to 2.2, yielding crystalline films with good IR-transparency, although with a porous morphology. Despite 0.5 wt% Nb-doping of the sputtering target, the as-deposited films demonstrate n-type conductivity likely due to uncontrolled impurities and intrinsic defects. Ultraviolet Photoemission Spectroscopy measurements suggest that films’ work function higher than 5 eV can be obtained with a post-deposition sulfurization, making these materials suitable as Hole Transport Layer in photovoltaic applications. A similar increase in work function is expected in the CZTS/MoS 2 junctions, since the sputtered MoS 2 :Nb films undergo a sulfurization process needed to obtain the overlying polycrystalline CZTS absorber. CZTS solar cells produced with sputtered MoS 2 and Transparent Conductive Oxides contacts on glass substrates, despite plagued by severe adhesion problems, show the potentiality to give efficiencies comparable to reference devices with standard Mo back contact. Fabrication of CZTS/Si tandem devices on textured silicon bottom cells yields a maximum efficiency of 4.4 %, primarily hindered by the low quality of the CZTS film on textured substrates. Nonetheless, optoelectronic characterizations based on both spectrophotometric and quantum efficiency measurements confirm a good IR transparency of the MoS 2 -based intermediate contacts and the desired electrical behaviour.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Chalcogenide Semiconductor Thin Films · Semiconductor materials and interfaces · Quantum Dots Synthesis And Properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References

Reference metadata was not supplied for this record.