journal article·2023-08

Changes in ohmic shunts in Cu(In,Ga)Se2 devices during damp heat

Aldo Kingma, Frideriki Naziris, Louis Gersant-Poulain, Rémi Aninat, Klaas Bakker, Marcel Simor, Mirjam Theelen

Publisher page

Abstract

To increase the bankability of photovoltaics (PV), a more accurate prediction of the lifetime and degradation-rate of PV modules is required. In past studies, average degradation rates for different technologies have been derived from field data. However, in Cu(In,Ga)Se2 (CIGS) based PV, localized shunts are commonly found in modules coming out of the factory. Although the impact of such localized defects on initial module performance has been studied in the past, their evolution and impact on module performance upon aging remain mostly unknown. In this paper, it is demonstrated that exposure of CIGS devices to elevated temperatures and humidity can result in the partial or complete recovery of localized ohmic shunts. This was observed for three types of shunting defects, each on a different CIGS device characterized before and after damp heat exposure. In each device, the reduction in shunting after damp heat could be observed in illuminated lock-in thermography, photoluminescence and current-voltage measurements. For two of the devices, the positive effect of shunt reduction was counteracted by other degradation mechanisms, such as increase in series resistance of TCO or back contact, while a 4% absolute efficiency increase was observed in the third device. Our data suggests that the shunting is mainly reduced due to oxidation of the materials initially forming the shunting path. The combined effects of moisture degradation and shunt reduction may limit detectability of moisture ingress in electrical performance data. These results illustrate the added value of regular visual inspection and luminescence in quality control.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Photovoltaic System Optimization Techniques · Silicon and Solar Cell Technologies · Chalcogenide Semiconductor Thin Films

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (51)

Show source-provided references
1. 2022
2. Jackson · 2021
3. Fraunhofer · 2022
4. 2022
5. 2022
6. 2021
7. 2021
8. Photovoltaic degradation rates—an analytical review10.1002/pip.1182 ↗
9. Cozzi · World Energy Outlook · 2021 · 2021 · 1
10. Köntges · 2014
11. Compendium of photovoltaic degradation rates10.1002/pip.2744 ↗
12. Photovoltaic failure and degradation modes10.1002/pip.2866 ↗
13. Investigation of dominant failure mode(s) for field-aged crystalline silicon PV modules under desert climatic conditions10.1109/JPHOTOV.2014.2308720 ↗
14. Failure modes of crystalline Si modules
15. A comprehensive review on building integrated photovoltaic systems: emphasis to technological advancements, outdoor testing, and predictive maintenance10.1016/j.rser.2021.111946 ↗
16. Building integrated photovoltaics (BIPV): costs, benefits, risks, barriers and improvement strategy10.1080/15623599.2015.1117709 ↗
17. Building integrated photovoltaic products: a state-of-the-art review and future research opportunities10.1016/j.solmat.2011.12.016 ↗
18. Røyset · 2020 · vol. 208
19. Flexible design of building integrated thin‐film photovoltaics10.1002/pip.3568 ↗
20. Failure analysis of Cu(In,Ga)Se 2 photovoltaic modules: degradation mechanism of Cu(In,Ga)Se 2 solar cells under harsh environmental conditions10.1002/pip.2497 ↗
21. Physical and chemical degradation behavior of sputtered aluminum doped zinc oxide layers for Cu(In,Ga)Se2 solar cells10.1016/j.tsf.2013.10.149 ↗
22. The effect of damp heat-illumination exposure on CIGS solar cells: a combined XRD and electrical characterization study10.1016/j.solmat.2016.07.051 ↗
23. 2002 - Damp-heat induced sulfate formation in CIGS based thin film solar cells.pdf, (n.d.).
24. Coyle · 2009 · 1943
25. Life prediction for CIGS solar modules part 1: modeling moisture ingress and degradation10.1002/pip.1172 ↗
26. Kettle · Prog. Photovoltaics Res. Appl. · 2022 · 30 · 136510.1002/pip.3577 ↗
27. Statistical evaluation of PV system performance and failure data among different climate zones10.1016/j.renene.2019.02.135 ↗
28. Review of degradation and failure phenomena in photovoltaic modules10.1016/j.rser.2022.112160 ↗
29. Why do PV modules fail?
30. Error analysis of aged modules with cracked polyamide backsheets
31. Drivers for the cracking of multilayer polyamide-based backsheets in field photovoltaic modules: in-depth degradation mapping analysis10.1002/pip.3260 ↗
32. Encoder-Decoder semantic segmentation models for electroluminescence images of thin-film photovoltaic modules10.1109/JPHOTOV.2020.3041240 ↗
33. PV-AIDED : photovoltaic Artificial Intelligence Defect Identification . Multichannel encoder-decoder ensemble models for electroluminescence images of thin-film photovoltaic modules
34. Quantitative electroluminescence analysis of resistive losses in Cu(In, Ga)Se2 thin-film modules10.1016/j.solmat.2010.01.028 ↗
35. Group · 2019
36. Analysis of Cu(In,Ga)Se2 thin-film modules by electro-modulated luminescence10.1063/1.4942654 ↗
37. Electroluminescence and thermal imaging of large-area Cu(In, Ga)Se 2 modules
38. Re-investigation of preferential orientation of Cu(In,Ga)Se2 thin films grown by the three-stage process10.1002/pip.1079 ↗
39. Effect of the KF post-deposition treatment on grain boundary properties in Cu(In, Ga)Se 2 thin films10.1038/srep41361 ↗
40. In situ monitoring of the accelerated performance degradation of solar cells and modules: a case study for Cu(In,Ga)Se2 solar cells
41. Solar Energy Materials and Solar Cells Study of the physical and chemical origin of features observed in luminescence and thermography images of Cu(In,Ga)Se 210.1016/j.solmat.2021.111145 ↗
42. Scribing defects in CIGS modules
43. Material property changes in defects caused by reverse bias exposure of CIGS solar cells10.1109/JPHOTOV.2019.2940486 ↗
44. High-temperature degradation mechanism of Cu(In,Ga)Se2-based thin film solar cells
45. Lock-in thermography and related topics in photovoltaic research10.4028/www.scientific.net/MSF.725.115 ↗
46. Stability of CIGS solar cells under illumination with damp heat and dry heat: a comparison10.1016/j.solmat.2016.12.039 ↗
47. RF magnetron sputtered ZnO:Al thin films on glass substrates: a study of damp heat stability on their optical and electrical properties10.1016/j.solmat.2007.07.008 ↗
48. Materials Chemistry and Physics the influence of atmospheric species on the degradation of the Mo/MoSe2 back contact in CIGS solar cells Essential title page information10.1016/j.matchemphys.2021.125686 ↗
49. Influence of deposition pressure and selenisation on damp heat degradation of the Cu(In,Ga)Se2 back contact molybdenum10.1016/j.surfcoat.2014.05.001 ↗
50. Defect detection in photovoltaic modules using electroluminescence imaging
51. A review on emerging barrier materials and encapsulation strategies for flexible perovskite and organic photovoltaics10.1002/aenm.202101383 ↗