journal article·2011-01

Effect of loading on long term performance of single junction amorphous silicon modules

K. Astawa, T.R. Betts, R. Gottschalg

Publisher page

Abstract

The long-term behaviour of photovoltaic modules governs their economic feasibility. Amorphous silicon devices experience an initial degradation which is partially reversible due to thermal annealing. This degradation is commonly investigated using indoor light-soaking setups, typically leaving the devices open circuited. Alternatively, devices would be placed outdoors and in most cases are left open circuited as well. The outdoor exposure is closer to realistic performance as the devices will experience continuously changing environments as well as seasonal annealing and degradation cycles. However in both cases, the loading is not as it would be in realistic operation, where devices are operating at the maximum power point. The aim of this study is to verify if the practice of keeping modules at Voc is appropriate for outdoor measurements. The differences in the long term behaviour of the devices due to different loading strategies are investigated for open circuit, short circuit, fixed resistor loading, and MPPT. It is investigated for single junctions with more than 1 year outdoor exposure. It is shown that one needs to at least load the modules resistively to achieve realistic degradation rates, as the degradation at Voc overestimates by 23% and at Isc underestimates by 7.69% relative to the MPPT condition.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Thin-Film Transistor Technologies · Silicon and Solar Cell Technologies · Photovoltaic System Optimization Techniques

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (8)

Show source-provided references
1. Reversible conductivity changes in discharge-produced amorphous silicon10.1063/1.89674 ↗
2. J. Zhu, et al., Effects of different data collection strategies on outdoor performance measurements and degradation. In: Proceedings of the 24th European Photovoltaic Solar Energy Conference, Hamburg, Germany, 2009.
3. Stability of n–i–p amorphous solar cells10.1063/1.92865 ↗
4. Field and laboratory studies of the stability of amorphous silicon solar cells and modules10.1016/S0960-1481(00)00045-8 ↗
5. Performance of single junction a-Si under varying conditions in filed
6. Uncertainty in Photovoltaic performance parameter—dependence on location and material10.1016/j.solmat.2009.02.003 ↗
7. K. Astawa, T.R. Betts, and R. Gottschalg. Effect of operating condition on degradation of amorphous silicon solar modules. In: Photovoltaic Science, Application and Technology/ PVSAT-4. International Solar Energy Society, University of Bath, Bath, UK , 2008.
8. Thin-film solar cells: device measurement and analysis10.1002/pip.518 ↗