Ni/Cu interface optimization via low-temperature dark annealing for enhancing open-circuit voltage and efficiency of mass-produced electroplated electrode TOPCon solar cells
Source abstract
Abstract
Electroplated copper electrode technology demonstrates broad application prospects in photovoltaic manufacturing due to its low cost, excellent conductivity, and simplified process. In tunnel oxide passivated contact (TOPCon) solar cells, electroplated copper electrodes are considered a viable alternative to traditional silver electrodes. However, practical applications indicate that copper-plated electrodes significantly improve the fill factor of the device, while the increase in open-circuit voltage and short-circuit current fall short of expectations, resulting in limited improvements in power conversion efficiency. Therefore, enhancing the open-circuit voltage of electroplated copper electrodes in TOPCon cells has become a key research focus. This paper proposes a low-temperature dark annealing post-processing method, aiming to improve the adhesion and contact performance of the Ni/Cu interface, reduce the recombination current density ( J 0 ), and thereby help restore the open-circuit voltage of the device. This method promotes beneficial atomic inter-diffusion at the Ni/Cu electrode interface through low-temperature thermal treatment of the TOPCon cell, significantly improving the contact quality and electrical performance. Through optimization, the low-temperature dark annealing technique maximally reduces the contact resistivity ( ρ c ) of electroplated Ni/Cu electrodes in TOPCon cells by approximately 2.7 mΩ cm 2 , thereby improving the power conversion efficiency by 1.02 % abs. This study not only validates the effectiveness of low-temperature dark annealing in improving electrode contact interface, but also provides a simple and process-compatible technical approach to further enhance the open-circuit voltage and short-circuit current of TOPCon cells, thus providing valuable insights for advancing the application of electroplated copper electrodes in efficient photovoltaic cells.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Silicon and Solar Cell Technologies · Nanomaterials and Printing Technologies · Copper-based nanomaterials and applications
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (39)
Show source-provided references
1. Degradation mechanism of TOPCon solar cells in an ambient acid environment10.1021/acsami.4c21774 ↗
2. Ultrathin self-assembled monolayer for effective silicon solar cell passivation10.1021/acsami.4c10257 ↗
3. Highly passivated TOPCon bottom cells for perovskite/silicon tandem solar cells10.1038/s41467-024-52309-2 ↗
4. Nanoscale SiOx tunnel oxide deposition techniques and their influence on cell parameters of TOPCon solar cells10.1007/s42341-021-00356-7 ↗
5. Green · 2025 · vol. 33 · 795
6. Economic evaluation of two-step metallization processes for silicon solar cells10.1016/j.egypro.2011.06.182 ↗
7. Challenges facing nickel‐plated metallisation for silicon photovoltaics: insights from integrated circuit technology development10.1002/pip.3062 ↗
8. Evolution of metal plating for silicon solar cell metallization10.1002/pip.2221 ↗
9. Review of the potential of the Ni/Cu plating technique for crystalline silicon solar cells10.3390/ma7021318 ↗
10. Optimal design of narrow line-width front contact grid pattern for silicon solar cells and low-cost fabrication of electroless nickel plated imprint lithography hard stamp10.1002/adem.201900734 ↗
11. Laser ablation and Ni/Cu plating approach for tunnel oxide passivated contacts solar cells with variate polysilicon layer thickness: gains and possibilities in comparison to screen printing10.1002/pssa.202000474 ↗
12. Direct contact electroplating sequence without initial seed layer for bifacial TOPCon solar cell metallization10.1109/JPHOTOV.2021.3051636 ↗
13. Interface oxides in femtosecond laser structured plated ni-cu-ag contacts for silicon solar cells10.1016/j.solmat.2017.03.016 ↗
14. Enabling savings in silver consumption and poly-Si thickness by integration of plated Ni/Cu/Ag contacts for bifacial TOPCon solar cells10.1016/j.solmat.2022.111889 ↗
15. A horizontal double-sided copper metallization technology designed for solar cell mass-production10.1002/pip.3863 ↗
16. Investigation on plated Ni/Cu contact for mono-crystalline silicon solar cells, Electron
17. The laser-damage repairing on the front surface of the N-type TOPCon solar cells with electroplated electrodes10.1016/j.solmat.2025.113437 ↗
18. Passivated rear contacts for high-efficiency n-type Si solar cells providing high interface passivation quality and excellent transport characteristics10.1016/j.solmat.2013.09.017 ↗
19. Impact of laser-induced oxidation on silicon wafer solar cells performance10.1109/JPHOTOV.2016.2535243 ↗
20. Thermal stability of copper-nickel and copper-nickel silicide contacts for Crystalline silicon10.1021/acsaem.8b00488 ↗
21. Ablation of SiN passivation layers on photovoltaic cells with femtosecond laser source10.2961/jlmn.2010.02.0005 ↗
22. The reduction of laser-damage on the rear surface of the N-type TOPCon solar cells with electroplating electrodes10.1016/j.mssp.2025.109433 ↗
23. Copper penetration in laser-doped selective-emitter silicon solar cells with plated nickel barrier layers10.1016/j.solmat.2014.07.026 ↗
24. Enhancing adhesion and reducing ohmic contact through nickel–silicon alloy seed layer in electroplating Ni/Cu/Ag10.3390/ma17112610 ↗
25. Barrier properties of electroplating nickel layer for copper metallization in silicon solar cells10.20964/2018.12.23 ↗
26. Effectiveness of tungsten addition on the performance of electroplated nickel diffusion barriers for copper metallization on textured silicon10.1016/j.tsf.2022.139122 ↗
27. Sze · 1981
28. The impact of substrate temperature on the adhesion strength of electroplated copper on an Al-Doped ZnO/Si System10.3390/ma17204953 ↗
29. Impact of metal contamination in silicon solar cells10.1002/adfm.201000849 ↗
30. Development of advanced hydrogenation processes for silicon solar cells via an improved understanding of the behaviour of hydrogen in silicon10.1002/pip.3240 ↗
31. Stability of Al2O3 and Al2O3/a-SiNx:H stacks for surface passivation of crystalline silicon10.1063/1.3264572 ↗
32. Book review: solar cells: operating principles
33. Würfel · 2016
34. Luque · 2011
35. Tunnel oxide passivated carrier-selective contacts based on ultra-thin SiO2 layers10.1016/j.solmat.2015.06.048 ↗
36. The theory of p-n junctions in semiconductors and p-n junction transistors10.1002/j.1538-7305.1949.tb03645.x ↗
37. Towards implementation of a nickel silicide process for CMOS technologies10.1016/S0167-9317(03)00380-0 ↗
38. Current invariant as fundamental relation between saturation currents and band gaps for semiconductor solar cells10.1016/j.solmat.2023.112619 ↗
39. Changes in concentrations of copper and nickel on boron-doped Czochralski-Grown silicon surface at room temperature10.1143/JJAP.48.051201 ↗