In-situ determination of moisture- and temperature-driven deflection of an encapsulated Si photovoltaic cell
Source abstract
Abstract
Module reliability and service lifetime are critical factors in improving photovoltaic system performance and reducing the levelized cost of electricity (LCOE). Soldering and lamination of the cell impart residual stresses that persist over time and superimpose additional loads during operation. This paper demonstrates the use of X-ray Topography (XRT) to image in-situ the dynamic response of a glass/backsheet mini-module upon drying at elevated temperature after saturation at humidity levels compatible with accelerated testing. The local water content in the encapsulant is also determined in-situ over time via Water Reflectometric Detection (WaRD), with diffusion of water in the front (glass side) and rear (backsheet side) resolved. As water diffuses out from the back of the glass/backsheet module, the cell curves towards the backsheet concomitantly. We find that the cell edges deflect 40 μm out-of-plane with respect to its center while the encapsulant dries, compared to ∼100 μm deflection when heating from 25 °C to 85 °C. The local cell deflections (changes in cell orientation) are correlated with the dynamic loss of water in the backside encapsulant. We conclude that the observed cell deflections are the result of hygroscopic stress induced by the encapsulant upon moisture outdiffusion. Therefore, the cell experiences a continually changing stress state and curvature dependent on local humidity and temperature. Depending on cell architecture and interconnection, this “breathing” mode of the cell may induce wear out and fatigue of the interconnects, affect the electrical connection of cracked pieces or cause failure near the interconnected edges of two cells.
Source: expertdata · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Silicon and Solar Cell Technologies · Photovoltaic System Optimization Techniques · Thin-Film Transistor Technologies
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (63)
Show source-provided references
1. Cole · 2017
2. From cells to laminate: probing and modeling residual stress evolution in thin silicon photovoltaic modules using synchrotron X-ray micro-diffraction experiments and finite element simulations10.1002/pip.2891 ↗
3. Thermal residual stress analysis of soldering and lamination processes for fabrication of crystalline silicon photovoltaic modules10.3390/en11123256 ↗
4. Effect of interconnect geometry on the evolution of stresses in a solar photovoltaic laminate during and after lamination10.1016/j.solmat.2018.07.026 ↗
5. In-plane residual stress map for solar PV module: a unified approach accounting the manufacturing process10.1109/JPHOTOV.2020.3029226 ↗
6. Investigation and analysis of thermo-mechanical degradation of fingers in a photovoltaic module under thermal cyclic stress conditions10.1016/j.solener.2018.10.009 ↗
7. Effect of operating temperature on degradation of solder joints in crystalline silicon photovoltaic modules for improved reliability in hot climates10.1016/j.solener.2018.06.007 ↗
8. The effect of laminate construction and temperature cycling on the fracture strength and performance of encapsulated solar cells
9. Stein · 2019
10. Köntges · 2014
11. Mean degradation rates in pv systems for various kinds of pv module failures
12. Solar cells micro crack detection technique using state-of-the-art electroluminescence imaging
13. CNN based automatic detection of photovoltaic cell defects in electroluminescence images10.1016/j.energy.2019.116319 ↗
14. Quantifying solar cell cracks in photovoltaic modules by electroluminescence imaging
15. Photographic diagnosis of crystalline silicon solar cells utilizing electroluminescence10.1007/s00339-008-4986-0 ↗
16. Machine learning prediction of defect types for electroluminescence images of photovoltaic panels10.1117/12.2528440 ↗
17. Accurate and robust crack detection using steerable evidence filtering in electroluminescence images of solar cells10.1016/j.optlaseng.2019.01.016 ↗
18. Automatic detection and evaluation of solar cell micro-cracks in electroluminescence images using matched filters
19. Solar cell cracks and finger failure detection using statistical parameters of electroluminescence images and machine learning10.3390/app10248834 ↗
20. Quantitative electroluminescence imaging analysis for performance estimation of PID-influenced PV modules10.1109/JPHOTOV.2018.2846665 ↗
21. Spatial and orientational distribution of cracks in crystalline photovoltaic modules generated by mechanical load tests10.1016/j.solmat.2011.06.032 ↗
22. Crack statistic of crystalline silicon photovoltaic modules
23. Electroluminescence image analysis of a photovoltaic module under accelerated lifecycle testing10.1364/AO.391957 ↗
24. Methods for in situ electroluminescence imaging of photovoltaic modules under varying environmental conditions10.1109/JPHOTOV.2020.3001723 ↗
25. Light- and elevated temperature-induced degradation impact on bifacial modules using accelerated aging tests, electroluminescence, and photovoltaic plant modeling10.1002/pip.3345 ↗
26. Stress and strain within photovoltaic modules using the finite element method: a critical review10.1016/j.rser.2021.111022 ↗
27. Numerical investigation on residual stress in photovoltaic laminates after lamination10.1007/s12206-015-0125-y ↗
28. Thermomechanics of PV modules including the viscoelasticity of EVA
29. Mechanical and thermomechanical assessment of encapsulated solar cells by finite-element-simulation
30. Viscoelastic material characterization and modeling of photovoltaic module packaging materials for direct finite-element method input10.1109/JPHOTOV.2020.3005086 ↗
31. Enabling the measurement of thermomechanical stress in solar cells and PV modules by confocal micro-Raman spectroscopy10.1016/j.solmat.2019.01.028 ↗
32. Stress mapping by confocal Raman spectroscopy on solar cells and modules
33. Thermomechanical stress analysis of PV module production processes by Raman spectroscopy and FEM simulation10.1016/j.egypro.2017.09.282 ↗
34. Synchrotron X-ray micro-diffraction – probing stress state in encapsulated thin silicon solar cells10.1016/j.proeng.2015.09.241 ↗
35. Probing stress and fracture mechanism in encapsulated thin silicon solar cells by synchrotron X-ray microdiffraction10.1016/j.solmat.2016.12.028 ↗
36. Thermomechanical residual stress evaluation in multi-crystalline silicon solar cells of photovoltaic modules with different encapsulation polymers using synchrotron X-ray microdiffraction10.1016/j.solmat.2019.01.016 ↗
37. Synchrotron X-ray topography for encapsulation stress/strain and crack detection in crystalline silicon modules10.1109/JPHOTOV.2016.2585022 ↗
38. Quantitative mapping of deflection and stress on encapsulated silicon solar cells10.1109/JPHOTOV.2017.2768959 ↗
39. Characterization of encapsulated solar cells by x-ray topography
40. Process induced deflection and stress on encapsulated solar cells
41. Quantitative determination of moisture content in solar modules by short-wave infrared Reflectometry10.1109/JPHOTOV.2019.2938108 ↗
42. Glass vs. Backsheet: deconvoluting the role of moisture in power loss in silicon photovoltaics with correlated imaging during accelerated testing10.1109/JPHOTOV.2021.3122878 ↗
43. Moisture ingress in photovoltaic modules: a review10.1016/j.solener.2021.06.055 ↗
44. Effects of different environmental and operational factors on the PV performance: a comprehensive review10.1002/ese3.1043 ↗
45. The effect of moisture on the degradation mechanism of multi-crystalline silicon photovoltaic module10.1016/j.microrel.2013.07.047 ↗
46. Imaging and micro-structural characterization of moisture induced degradation in crystalline silicon photovoltaic modules10.1016/j.solener.2019.11.037 ↗
47. Degradation by acetic acid for crystalline Si photovoltaic modules10.7567/JJAP.54.04DR04 ↗
48. Comparative investigation and analysis of delaminated and discolored encapsulant degradation in crystalline silicon photovoltaic modules10.1016/j.solener.2020.04.041 ↗
49. Raman spectroscopic analysis of encapsulants in aged photovoltaic modules10.1016/j.jphotochem.2021.113721 ↗
50. Accelerated testing and modeling of potential-induced degradation as a function of temperature and relative humidity10.1109/JPHOTOV.2015.2466463 ↗
51. Influence of polymer properties on potential induced degradation of PV-modules
52. Meng · 2019
53. Unsteady-state mass transfer
54. A simulation study of the stresses in crystalline silicon photovoltaic laminates during the soldering and lamination processes along the longitudinal direction10.1002/adem.201800986 ↗
55. Effect of encapsulants on the thermomechanical residual stress in the back-contact silicon solar cells of photovoltaic modules – a constrained local curvature model10.1016/j.solener.2019.02.028 ↗
56. Multi-wire interconnection of busbar-free solar cells10.1016/j.egypro.2014.08.109 ↗
57. Modelling and verification of mechanical stress induced by soldering of wires for multi busbar interconnection
58. Thermal stress and strain of solar cells in photovoltaic modules
59. Use of digital image correlation technique to determine thermomechanical deformations in photovoltaic laminates: measurements and accuracy10.1016/j.solmat.2010.03.028 ↗
60. Enabling measurement of PV module curvature: towards characterization of thermomechanical residual stresses
61. Low stress encapsulants? Influence of encapsulation materials on stress and fracture of thin silicon solar cells as revealed by synchrotron X-ray submicron diffraction10.1016/j.proeng.2015.09.230 ↗
62. Rashtchi · 2015
63. Measurement of moisture content in photovoltaic panel encapsulants using spectroscopic optical coherence tomography: a feasibility study