Evaluation of large-scale recycled seed for cast monocrystalline silicon: Defect multiplication mechanisms and feasibility
Source abstract
Abstract
Abstract The casting method is a low-cost technique to fabricate photovoltaic monocrystalline silicon wafers. The development of cast monocrystalline silicon (CM-Si) materials requires high quality and low cost. To further reduce CM-Si's cost, a large-scale recycled seed has become a focused topic. This work compared new seeds and a large-scale recycled seed in the same growth so that the experimental errors in the growth environment were eliminated. Detailed characterizations on defect distribution and performances have shown that seed recycling will generate extra initial defects. However, it becomes influential for solar cell performance only when defect concentration reaches a certain level. Finally, a related defect propagation mechanism was revealed for manufacturers to optimize industrial growth strategies.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Silicon and Solar Cell Technologies · Photovoltaic System Optimization Techniques · Advancements in Semiconductor Devices and Circuit Design
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (18)
Show source-provided references
1. Casting single crystal silicon: novel defect profiles from BP solar's mono2 TM wafers
2. Seed-assisted cast quasi-single crystalline silicon for photovoltaic application: towards high efficiency and low cost silicon solar cells10.1016/j.solmat.2012.02.024 ↗
3. The characteristics of sub-grains in the mono-like silicon crystals grown with directional solidification method
4. Structure and dislocation development in mono‐like silicon10.1002/pssa.201532105 ↗
5. Higher quality mono-like cast silicon with induced grain boundaries10.1016/j.solmat.2015.03.027 ↗
6. Effect of seed arrangements on the quality of n-type monolike silicon grown by directional solidification10.1021/acs.cgd.6b01317 ↗
7. The electrical properties of high performance multicrystalline silicon and mono-like silicon: material limitations and cell potential10.1016/j.solmat.2019.110059 ↗
8. Mono-like silicon growth using functional grain boundaries to limit area of multicrystalline grains10.1109/JPHOTOV.2013.2281730 ↗
9. SMART cast‐monocrystalline p‐type silicon passivated emitter and rear cells: efficiency benchmark and bulk lifetime analysis10.1002/solr.202000752 ↗
10. The potential of cast silicon10.1016/j.solmat.2020.110789 ↗
11. Investigation of iron contamination of seed crystals and its impact on lifetime distribution in Quasimono silicon ingots10.1016/j.jcrysgro.2015.08.004 ↗
12. Seed‐assisted growth of cast‐mono silicon for photovoltaic application: challenges and strategies10.1002/solr.201900486 ↗
13. Influencing factors on the formation of the low minority carrier lifetime zone at the bottom of seed-assisted cast ingots10.1016/j.jcrysgro.2014.05.015 ↗
14. About the origin of low wafer performance and crystal defect generation on seed‐cast growth of industrial mono‐like silicon ingots10.1002/pip.2344 ↗
15. Two-peak characteristic distribution of iron impurities at the bottom of cast quasi-single-crystalline silicon ingot10.1016/j.scriptamat.2012.12.033 ↗
16. The effect of diffusion barrier on minority carrier lifetime improvement of seed assisted cast silicon ingot10.1016/j.jcrysgro.2020.125684 ↗
17. Dislocation formation in seed crystals induced by feedstock indentation during growth of quasimono crystalline silicon ingots10.1016/j.jcrysgro.2016.08.037 ↗
18. Influence of dislocations on electrical properties of large grained polycrystalline silicon cells. II. Experimental results10.1063/1.344393 ↗