First quadrant phototransistor behavior in CuInSe2 photovoltaics
Source abstract
Abstract
Abstract Temperature-dependent current voltage measurements on a CuInSe 2 (CIS) solar cell are described and analyzed in detail. At relatively low temperatures, the device is shown to exhibit operation as a phototransistor, evidenced by light flux dependent current in the first quadrant of the current/voltage curve prior to the onset of a high differential resistance region of the curve. The phototransistor behavior is not restricted to light with short wavelengths (such as would stimulate the front contact materials—CdS and ZnO), and has a similar sensitivity to light over a wide range of intensities. Other aspects of the device operation are analyzed including observation of a photoconductive shunt and series differential resistance component, neither of which requires short wavelength light to be observable, a non-light-sensitive diode reverse-saturation current, and characterization of the back diode in the device. It is argued that the presence of an effective back diode also requires a bias voltage to develop across that diode under a variety of operating conditions that could reduce the open circuit voltage of the device. The potential for characterization of minority carrier properties in the device absorber layer through further controlled study of phototransistor behavior in the devices is noted.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Chalcogenide Semiconductor Thin Films · Quantum Dots Synthesis And Properties · Copper-based nanomaterials and applications
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (11)
Show source-provided references
1. New world record efficiency for Cu(In,Ga)Se2 thin-film solar cells beyond 20%10.1002/pip.1078 ↗
2. Detailed balance limit of efficiency of p–n junction solar cells10.1063/1.1736034 ↗
3. W.N. Shafarman, J.E. Phillips, Direct current–voltage measurements of the Mo/CuInSe2 contact on operating solar cells, in: Proceedings of the Conference Record of the Twenty Fifth IEEE Photovoltaic Specialists Conference, Washington, DC, USA, 13–17 May, 1996, pp. 917–919.10.1109/PVSC.1996.564278 ↗
4. Light induced changes in the electrical behavior of CdTe and Cu(In,Ga)Se2 solar cells10.1016/S0040-6090(01)01507-3 ↗
5. Effects of the Au/CdTe back contact on IV and CV characteristics of Au/CdTe/CdS/TCO solar cells10.1063/1.363946 ↗
6. Y. Liu, D. Heinzel, A. Rockett, A revised version of the AMPS simulation code, in: Proceedings of Institute of Electrical and Electronics Engineers Inc., Honolulu, HI, United states, pp. 1943–1947.
7. Photoemission study on the formation of Mo contacts to CuInSe210.1063/1.351775 ↗
8. T. Loher, C. Pettenkofer, W. Jaegermann, Electronic properties of intimate Mo and CdS junctions in-situ formed on CuInSe2 (011) cleavage planes, in: Proceedings of IEEE, New York, NY, USA, 1994, pp. 295–298.
9. Thin-film solar cells: device measurements and analysis10.1002/pip.518 ↗
10. Where does photocurrent flow in polycrystalline CdS?10.1063/1.1923157 ↗
11. Bulk and metastable defects in CuIn1−xGaxSe2 thin films using drive-level capacitance profiling10.1063/1.1633982 ↗