Composition dependent characterization of copper indium diselenide thin film solar cells synthesized from electrodeposited binary selenide precursor stacks
Source abstract
Abstract
Abstract CuInSe2 solar cells were prepared from electrodeposited and annealed stacks of indium selenide and copper selenide on molybdenum (Mo/In2Se3/Cu–Se). In comparison to a simultaneous electrodeposition of all elements at once the electrodeposited binary selenide stack leads to larger grains and lattice coherence length if annealed under the same conditions (30 min at 550 °C). Absorbers with atomic Cu/In ratios 1 and their corresponding solar cells were characterized. An incomplete reaction in case of the Cu-poor precursor caused a Cu-deficient layer at the back contact of the absorber leading to the formation of a reverse electronic barrier reducing fill factor and short circuit current and thus the solar power conversion efficiency. Photoluminescence measurements showed a strongly compensated semiconductor for the Cu-poor absorber and an incomplete charge carrier collection was identified by quantum efficiency measurements under reverse bias. The reverse electronic barrier, the high compensation and the incomplete carrier collection could be avoided by Cu-rich growth conditions. The appearance of an excitonic transition in photoluminescence indicated a high semiconductor quality in this case. It was linked with a high quantum efficiency resulting in a local short-current density of 38.3 mA/cm2. Temperature-dependent JV measurements identified interface recombination as the limiting recombination loss mechanism for the Cu-rich grown solar cell reducing the open-circuit potential and decreasing the conversion efficiency. The solar cell prepared from the precursor with Cu/In≈1 had similar properties as the Cu-poor device without the reverse electronic barrier at the back contact but instead dominating interface recombination. It reached a best solar power conversion efficiency of 5.5%.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Chalcogenide Semiconductor Thin Films · Quantum Dots Synthesis And Properties · Copper-based nanomaterials and applications
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (47)
Show source-provided references
1. New world record efficiency for Cu(In,Ga)Se2 thin-film solar cells beyond 20%10.1002/pip.1078 ↗
2. Solution growth and electrodeposited CuInSe2 thin films10.1149/1.2119516 ↗
3. Electrodeposition of In–Se, Cu–Se, and Cu–In–Se thin films10.1149/1.1836548 ↗
4. Chalcopyrite thin film solar cells by electrodeposition10.1016/j.solener.2004.05.024 ↗
5. Controlling growth chemistry and morphology of single-bath electrodeposited Cu(In,Ga)Se2 thin films for photovoltaic application10.1149/1.2186764 ↗
6. Electrodeposited and selenized (CuInSe2) (CIS) thin films for photovoltaic applications10.1016/S0927-0248(97)00240-7 ↗
7. Low-cost deposition of CuInSe2 (CIS) films for CdS/CIS solar cells10.1016/S0927-0248(97)00250-X ↗
8. Deposition of smooth Cu(In,Ga)Se2 films from binary multilayers10.1016/S0040-6090(99)00848-2 ↗
9. Low cost methods for the production of semiconductor films for CuInSe2/CdS solar cells10.1016/0379-6787(87)90105-0 ↗
10. CuInSe2 thin films formed by selenization of Cu–In precursors10.1023/A:1004311527795 ↗
11. Reaction pathways to CuInSe2 formation from electrodeposited precursors10.1149/1.2044202 ↗
12. Characterization of CuInSe2 material and devices: comparison of thermal and electrochemically prepared absorber layers10.1088/0022-3727/41/8/085105 ↗
13. CuInSe2 formation by selenization of sequentially evaporated metallic layers10.1016/j.solmat.2004.05.019 ↗
14. N. Romeo, A. Bosio, S. Mazzamuto, D. Menossi, A. Romeo, CIGS thin films prepared by sputtering and selenization by using In2Se3, Ga2Se3 and Cu as sputtering targets, in: Proceedings of the 2010 35th IEEE Photovoltaic Specialists Conference (PVSC), 2010, pp. 000786–000788.10.1109/PVSC.2010.5617109 ↗
15. T.J. Anderson, S.S. Li, O.D. Crisalle, V. Craciun, Fundamental Materials Research and Advanced Process Development for Thin-Film CIS-Based Photovoltaics (Final Technical Report), 2 October 2001–30 September 2005, National Renewable Energy Laboratory (NREL), Golden, CO, 2006.10.2172/891600 ↗
16. Fabrication of CuInSe2 films and solar cells by the sequential evaporation of In2Se3 and Cu2Se binary compounds10.1016/S0927-0248(00)00382-2 ↗
17. J. Fischer, S. Siebentritt, P.J. Dale, Synthesis and characterization of CuInSe2 thin films by annealing of electrodeposited In2Se3/Cu and In2Se3/CuxSey Stacks, in: ECS Transactions, vol. 25, issue 15, October 4–October 9, 2009, Vienna, Austria, 2010, pp. 129–142.10.1149/1.3300430 ↗
18. R. Klenk, R. Menner, D. Cahen, H.W. Schock, Improvement of Cu(Ga,In)Se2 based solar cells by etching the absorber, in: Proceedings of 1990 21st IEEE Photovoltaic Specialists Conference (PVSC), 1990, pp. 481–486.10.1109/PVSC.1990.111670 ↗
19. Optimization of CBD CdS process in high-efficiency Cu(In,Ga)Se2-based solar cells10.1016/S0040-6090(01)01538-3 ↗
20. V. Depredurand, Y. Aida, J. Larsen, T. Eisenbarth, A. Majerus, S. Siebentritt, Surface treatment of CIS solar cells grown under Cu-excess, in: Proceedings of the 37th IEEE Proceeding, 2011, pp. 337.10.1109/PVSC.2011.6185953 ↗
21. High-efficiency CuInxGa1−xSe2 solar cells made from (InxGa1−x)2Se3 precursor films10.1063/1.112670 ↗
22. The Scherrer formula for X-ray particle size determination10.1103/PhysRev.56.978 ↗
23. Separation of particle size and lattice strain in integral breadth measurements10.1107/S0365110X66000628 ↗
24. Characterization of CuIn(Ga)Se2 Thin Films10.1002/(SICI)1521-396X(199807)168:1<163::AID-PSSA163>3.0.CO;2-T ↗
25. Do we really need another PL study of CuInSe2?10.1002/pssc.200404845 ↗
26. Siebentritt · 2006
27. Electronic properties of Cu(In,Ga)Se2 heterojunction solar cells – recent achievements, current understanding, and future challenges10.1007/s003390050984 ↗
28. Electronic properties of CuGaSe2-based heterojunction solar cells. Part I. Transport analysis10.1063/1.371903 ↗
29. Scheer · 2011
30. Würfel · 2007
31. Spectrally resolved photoluminescence studies on Cu(In,Ga)Se2 solar cells with lateral submicron resolution10.1016/j.tsf.2006.12.164 ↗
32. The phase relations in the Cu, In, Se system and the growth of CuInSe2 single crystals10.1016/0379-6787(86)90076-1 ↗
33. The crystal structures of CuInSe2 and CuInTe210.1016/0025-5408(92)90209-I ↗
34. Recrystallization of electrodeposited copper indium diselenide thin films in an atmosphere of elemental selenium10.1002/adma.19940060507 ↗
35. Influence of annealing conditions on the structural quality of CuInSe2 thin films10.1016/j.tsf.2007.12.024 ↗
36. One step electrodeposition of CuInSe2: improved structural, electronic, and photovoltaic properties by annealing under high selenium pressure10.1063/1.361446 ↗
37. WinPLOTR: a windows tool for powder diffraction pattern analysis10.4028/www.scientific.net/MSF.378-381.118 ↗
38. Pankove · 2010
39. Grain boundaries in Cu(In,Ga)(Se,S)2 thin-film solar cells10.1007/s00339-008-4978-0 ↗
40. Photosensitivity of thin-film structures based on CuIn3Se5 and CuIn5Se8 ternary semiconductor compounds10.1134/S106378500702006X ↗
41. Interdependence of absorber composition and recombination mechanism in Cu(In,Ga)(Se,S)2 heterojunction solar cells10.1063/1.1467621 ↗
42. Compositional trends of defect energies, band alignments, and recombination mechanisms in the Cu(In,Ga)(Se,S)2 alloy system10.1016/S0040-6090(03)00225-6 ↗
43. Feedback mechanism for the stability of the band gap of CuInSe210.1103/PhysRevB.86.045216 ↗
44. Thin-film solar cells: device measurements and analysis10.1002/pip.518 ↗
45. What limits the efficiency of chalcopyrite solar cells?10.1016/j.solmat.2010.12.014 ↗
46. Optical characterization of CuIn[1−x]Ga[x]Se2 alloy thin films by spectroscopic ellipsometry10.1063/1.1581345 ↗
47. Cu(InGa)Se2 thin film photovoltaic absorber formation by rapid thermal annealing of binary stacked precursors10.1016/j.tsf.2011.08.052 ↗