journal article·2023-07Open access

Influence of the precursor composition on the resulting absorber properties and defect concentration in Cu2ZnSnSe4 absorbers

David Nowak, Fabien Atlan, Devendra Pareek, Maxim Guc, Alejandro Perez-Rodriguez, Victor Izquierdo-Roca, Levent Gütay

Abstract

In this paper the influence of composition variations during the growth of Cu2ZnSnSe4 (CZTSe) layers on defect concentrations and final absorber properties is analyzed. The samples are prepared from sputtered metallic and alloyed Zn/Cu–Sn/(Sn)/Zn precursors. The variation of sputtered Sn content facilitates different forms for the embedded Sn (Cu3Sn, Cu6Sn5, elemental Sn). The predominating formation reaction during the subsequent annealing is tuned by the ratio of the alloys and the overall chemical composition in the precursor. During the high temperature stage of CZTSe formation the layer undergoes an in-process composition shift (Sn content variation), after which the final absorber composition is reached. As all absorbers are reaching a comparable end composition, in this paper the influence of the different precursor compositions and corresponding reaction pathways on the resulting defects and optoelectronic properties of the absorbers are addressed. Spectroscopic investigations were used to extract the defect configuration of the absorbers. The results are complemented with device performance measurements. Preferable precursor compositions leading to lower defect concentration and improved photoluminescence quantum-yield is identified. The obtained Urbach energy and VOC deficit are among the most promising results measured in our laboratories.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Chalcogenide Semiconductor Thin Films · Quantum Dots Synthesis And Properties · Copper-based nanomaterials and applications

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (42)

Show source-provided references
1. Germanium alloyed kesterite solar cells with low voltage deficits10.1021/acs.chemmater.5b04806 ↗
2. Vapor-phase incorporation of Ge in CZTSe absorbers for improved stability of high-efficiency kesterite solar cells10.3390/app12031376 ↗
3. Steep sulfur gradient in CZTSSe solar cells by H2S-assisted rapid surface sulfurization10.1039/D1RA00494H ↗
4. Ab initio calculation of the detailed balance limit to the photovoltaic efficiency of single p-n junction kesterite solar cells10.1063/5.0049143 ↗
5. Numerical simulation of CZTSe based solar cells using different back surface field layers: improvement and comparison10.1007/s11664-020-08712-8 ↗
6. Status of materials and device modelling for kesterite solar cells10.1088/2515-7655/ab2dda ↗
7. Solar cell efficiency tables (Version 61)10.1002/pip.3646 ↗
8. Origin of the low conversion efficiency in Cu2ZnSnS4 kesterite solar cells: the actual role of cation disorder10.1039/D1EE00260K ↗
9. Insights into interface and bulk defects in a high efficiency kesterite-based device10.1039/D0EE02004D ↗
10. Identifying the origin of the Voc deficit of kesterite solar cells from the two grain growth mechanisms induced by Sn2+ and Sn4+ precursors in DMSO solution10.1039/D0EE03702H ↗
11. Defect control for 12.5% efficiency Cu2ZnSnSe4 kesterite thin-film solar cells by engineering of local chemical environment10.1002/adma.202005268 ↗
12. Efficient and composition‐tolerant kesterite Cu2ZnSn(S, Se)4 solar cells derived from an in situ formed multifunctional carbon framework10.1002/aenm.202102298 ↗
13. High efficiency Cu2ZnSn(S,Se)4 solar cells with shallow LiZn acceptor defects enabled by solution‐based Li post‐deposition treatment10.1002/aenm.202003783 ↗
14. Ge bidirectional diffusion to simultaneously engineer back interface and bulk defects in the absorber for efficient CZTSSe solar cells10.1002/adma.202202858 ↗
15. Band-gap-graded Cu2ZnSn(S,Se)4 drives highly efficient solar cells10.1039/D1EE03134A ↗
16. Influence of compositionally induced defects on the vibrational properties of device grade Cu2ZnSnSe4 absorbers for kesterite based solar cells10.1063/1.4913262 ↗
17. Defect characterisation in Cu2ZnSnSe4 kesterites via resonance Raman spectroscopy and the impact on optoelectronic solar cell properties10.1039/C9TA03625C ↗
18. Point defects, compositional fluctuations, and secondary phases in non-stoichiometric kesterites10.1088/2515-7655/ab4a25 ↗
19. Physical routes for the synthesis of kesterite10.1088/2515-7655/ab281c ↗
20. Compositional paradigms in multinary compound systems for photovoltaic applications: a case study of kesterites10.1039/C5TA02000J ↗
21. Cu-Rich precursors improve kesterite solar cells10.1002/aenm.201300543 ↗
22. Tuning of precursor composition and formation pathway of kesterite absorbers using an in‐process composition shift: a path toward higher efficiencies?10.1002/solr.202100237 ↗
23. Reaction pathway for efficient Cu2ZnSnSe4 solar cells from alloyed Cu-Sn precursor via a Cu-rich selenization stage
24. Potential of CZTSe solar cells fabricated by an alloy-based processing strategy10.1515/zna-2019-0136 ↗
25. Resilient and reproducible processing for CZTSe solar cells in the range of 10%10.1002/pip.3063 ↗
26. Modifications of the CZTSe/Mo back-contact interface by plasma treatments
27. The effect of excess selenium on the opto-electronic properties of Cu2ZnSnSe4 prepared from Cu–Sn alloy precursors10.1039/C9RA02779C ↗
28. Secondary phase formation in Zn-rich Cu2ZnSnSe4 -based solar cells annealed in low pressure and temperature conditions10.1002/pip.2473 ↗
29. CZTSe solar cells developed on polymer substrates: effects of low-temperature processing10.1002/pip.2945 ↗
30. The long-wavelength edge of photographic sensitivity and of the electronic Absorption of Solids [810.1103/PhysRev.92.1324 ↗
31. Effect of Se addition on optical and electrical properties of chalcogenide CdSSe thin films10.1016/j.spmi.2015.10.044 ↗
32. Anion distributions and phase transitions in CuS1-xSex(x = 0-1) studied by Raman spectroscopy10.1006/jssc.1993.1242 ↗
33. Infrared and Raman spectra of the IV-VI compounds SnS and SnSe10.1103/PhysRevB.15.2177 ↗
34. Raman scattering studies of SnS2 and SnSe210.1088/0022-3719/10/8/035 ↗
35. Secondary phase and Cu substitutional defect dynamics in kesterite solar cells: impact on optoelectronic properties10.1016/j.solmat.2016.01.029 ↗
36. Influence of precursor thin films stacking order on the properties of Cu2ZnSnS4 thin films fabricated by electrochemical deposition method10.1016/j.spmi.2014.10.022 ↗
37. Precursor stack ordering effects in Cu2ZnSnSe4 thin films prepared by rapid thermal processing10.1021/jp503699r ↗
38. Stability of Cu2ZnSnSe4/CdS heterojunction based solar cells under soft post-deposition thermal treatments10.1016/j.solmat.2022.112046 ↗
39. Device characteristics of an 11.4% CZTSe solar cell fabricated from sputtered precursors10.1002/aenm.201703295 ↗
40. Impact of alloying duration of an electrodeposited Cu/Sn/Zn metallic stack on properties of Cu2ZnSnS4 absorbers for thin-film solar cells10.1002/pip.2638 ↗
41. Cu6Sn5 binary phase as a precursor material of the CZTSe compound: optimization of the synthesis process, physical properties and its performance as an absorbing material in a solar cell10.1016/j.mssp.2021.106016 ↗
42. Kinetics and phase analysis of kesterite compounds: influence of chalcogen availability in the reaction pathway10.1016/j.mtla.2022.101509 ↗