journal article·2023-03

Simultaneously improving the morphology and defect properties of CZTSSe film via hybrid grain-growth mechanism

Chao Gao, Wenbo Li, Xiaowei Zhou, Haoyu Xu, Qing Zhou, Haifeng Gao, Shumin Qin, Zeran Gao, Wei Yu

Publisher page

Abstract

Multi-layer crystallization and uncontrollable defects were the main factors that limiting the quality of Cu 2ZnSn(S,Se) 4 (CZTSSe) films. Here a hybrid crystallization strategy was proposed to simultaneously improve the morphology and defect properties of CZTSSe film. Firstly, we found the variation of the microstructures (constitution, chemical environment of the elements, etc.) in precursor films can greatly alter the grain-growths of CZTSSe films. Detailed characterizations revealed that the chemical environment of S in the precursor film may influence the S-to-Se substitution of the film during the selenization process. This can further affect the grain-growth mechanism and the properties of CZTSSe film. While the S-to-Se substitution of the film mainly occurred below 500°C, the NaSe x on the surface of the film could dominate the grain-growth (Na-mechanism). For this mechanism, the CZTSSe film exhibited bi-layer morphology and relatively high band-tail energy, but shallow-acceptor was detected in the film. The solar cells based on the CZTSSe films reached the efficiency of 10.6%. As a comparison, liquid phase could be generated when the S-to-Se substitution of the film shifted to higher temperature (>500°C). In this condition, the grain-growth would be dominated by the liquid phase (LP-mechanism). Such mechanism can eliminate the multi-layer crystallization and reduce the band-tail energy, but the surface properties of the CZTSSe film was deteriorated and the formation of shallow-acceptor in CZTSSe was inhibited. The fabricated solar cells achieved the efficiency of 10.3%. Based on the results above, a bi-layer precursor film contained sub-layers with different microstructures was proposed to regulate the crystallization of CZTSSe. The co-existence of different microstructures in the precursor film could induce a hybrid grain-growth mechanism for the CZTSSe film (e.g., the Na-mechanism worked on the surface while the LP-mechanism worked in the bottom simultaneously). Such grain-growth mechanism can yield CZTSSe film with uniform morphology and favorable defect properties. The CZTSSe solar cells based on the hybrid grain-growth mechanism achieved the best efficiency of 12.6%. The investigation in this paper would provide new solutions for the crystallization regulation on CZTSSe photovoltaic material.
Source: expertdata · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Chalcogenide Semiconductor Thin Films · Quantum Dots Synthesis And Properties · Copper-based nanomaterials and applications

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (31)

Show source-provided references
1. Current challenges and future prospects for a highly efficient (>20%) kesterite CZTS solar cell: a review10.1016/j.solmat.2019.03.001 ↗
2. Kesterite solar cells: insights into current strategies and challenges
3. Kesterite: new progress toward earth-abundant thin-film photovoltaic
4. Elemental de-mixing-induced epitaxial kesterite/CdS interface enabling 13%-efficiency kesterite solar cells10.1038/s41560-022-01132-4 ↗
5. Two‐step cooling strategy for synergistic control of CuZn and SnZn defects enabling 12.87% efficiency (Ag,Cu)2ZnSn(S,Se)4 solar cells
6. Device characteristics of CZTSSe thin-film solar cells with 12.6% efficiency10.1002/aenm.201301465 ↗
7. Analysis of failure modes in kesterite solar cells10.1021/acsaem.8b00194 ↗
8. Unveiling microscopic carrier loss mechanisms in 12% efficient Cu2ZnSnSe4 solar cells10.1038/s41560-022-01078-7 ↗
9. Defect engineering in earth‐abundant Cu 2 ZnSn(S,Se) 4 photovoltaic materials via Ga3+-doping for over 12% efficient solar cells10.1002/adfm.202010325 ↗
10. Defect engineering in multinary earth-abundant chalcogenide photovoltaic materials10.1002/aenm.201602366 ↗
11. Defect suppression in multinary chalcogenide photovoltaic materials derived from kesterite: progress and outlook10.1039/D0TA08202C ↗
12. Origin of band-tail and deep-donor states in Cu2ZnSnS4 solar cells and their suppression through Sn-poor composition10.1021/acs.jpclett.9b03227 ↗
13. On the origin of band-tails in kesterite10.1016/j.solmat.2017.11.005 ↗
14. Engineering solar cell absorbers by exploring the band alignment and defect disparity: the case of Cu- and Ag-based kesterite compounds10.1002/adfm.201502272 ↗
15. Persistent double-layer formation in kesterite solar cells: a critical review10.1021/acsami.0c10068 ↗
16. Real-time observation of Cu2ZnSn(S,Se)4 solar cell absorber layer formation from nanoparticle precursors10.1039/c3cp53373e ↗
17. Effect of Cu–Sn–Se liquid phase on grain growth and efficiency of CZTSSe solar cells10.1002/aenm.202070060 ↗
18. Influence of the reaction pathway on the defect formation in a Cu 2 ZnSnSe 4 thin film10.1021/acsami.1c01307 ↗
19. Defect control for 12.5% efficiency Cu2ZnSnSe4 kesterite thin-film solar cells by engineering of local chemical environment10.1002/adma.202005268 ↗
20. Phase-separation-induced crystal growth for large-grained Cu2ZnSn(S,Se)4 thin film10.1021/acsami.8b10749 ↗
21. Identifying the origin of the Voc deficit of kesterite solar cells from the two grain growth mechanisms induced by Sn2+ and Sn4+ precursors in DMSO solution10.1039/D0EE03702H ↗
22. Sn4+ precursor enables 12.4% efficient kesterite solar cell from DMSO solution with open circuit voltage deficit below 0.30 V10.1007/s40843-020-1408-x ↗
23. Controlled grain growth for high performance nanoparticle-based kesterite solar cells10.1021/acs.chemmater.6b02733 ↗
24. Growth mechanisms of co-evaporated kesterite: a comparison of Cu-rich and Zn-rich composition paths10.1002/pip.2296 ↗
25. Fisher
26. Sodium assisted sintering of chalcogenides and its application to solution processed Cu2ZnSn(S,Se)4 thin film solar cells10.1021/cm403504u ↗
27. Source and effects of sodium in solution-processed kesterite solar cells
28. The Na-Se (Sodium-Selenium) system10.1007/BF02665704 ↗
29. Adjusting the SnZn defects in Cu2ZnSn(S,Se)4 absorber layer via Ge4+ implanting for efficient kesterite solar cells10.1016/j.jechem.2021.02.011 ↗
30. Over 10% efficient pure CZTSe solar cell fabricated by electrodeposition with Ge doping10.1002/solr.202000059 ↗
31. Engineering of interface and bulk properties in Cu2ZnSn(S,Se)4 thin-film solar cells with ultrathin CuAlO2 intermediate layer and Ge doping10.1021/acsaem.1c03569 ↗