Influence of Ge/(Ge+Sn) composition ratio in Cu2Sn1-xGexS3 thin-film solar cells on their physical properties and photovoltaic performances
Source abstract
Abstract
Abstract Effect of Ge/(Ge + Sn) composition ratio of Cu2Sn1-xGexS3 (CTGS) films is examined. The CTGS films are fabricated by sulfurization of the 700-nm-thick Cu–SnS2/Ge stacked precursors on Mo-coated soda-lime glass (SLG) substrates. It is revealed that the thickness of Ge precursor (Ge thickness) from 0 to 420 nm enhances the Ge/(Ge + Sn) composition ratio in the CTGS thin films from 0 to about 0.58, thereby increasing bandgap energy (Eg) from approximately 0.97 (Cu2SnS3: CTS) to 1.23 eV (CTGS), respectively. Not only does Ge precursor act as Ge source to form the CTGS films but also it prevents the formation of undesirable MoS2 secondary phase. In addition, the CTGS solar cells with a structure of SLG/Mo/CTGS/CdS/ZnO/ZnO:Al/Ni/Al are fabricated with the Ge thickness from 0 to 420 nm. It is found that the optimized Ge thickness of 200 nm resulting in the Ge/(Ge + Sn) composition ratio of about 0.32 eliminates the excessive MoS2 secondary phase and increases the Eg, thereby increasing conversation efficiency (η) to 5.6% of the CTGS solar cell, higher than that (3.6%) of the CTS solar cell. However, the η is reduced when the Ge thickness over 200 nm because CTGS quality observed by Urbach energy is deteriorated and the conduction band offset at the CdS/CTGS interface demonstrates the large cliff type heterostructure, thus increasing the open-circuit voltage deficit.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Chalcogenide Semiconductor Thin Films · Quantum Dots Synthesis And Properties · Semiconductor materials and interfaces
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (43)
Show source-provided references
1. Background and motivation for thin-film solar-cell development
2. Epitaxial thin film crystalline silicon solar cells on low cost silicon carriers
3. Detailed balance limit of efficiency of p-n junction solar cells10.1063/1.1736034 ↗
4. Modeled performance of polycrystalline thin film tandem solar cells10.1002/pip.419 ↗
5. Oxygenated CdS buffer layers enabling high open-circuit voltages in earth-abundant Cu2BaSnS4 thin-film solar cells10.1002/aenm.201601803 ↗
6. Earth-abundant orthorhombic BaCu2Sn(SexS1-x)4 (x ≈ 0.83) thin film for solar energy conversion10.1021/acsenergylett.6b00324 ↗
7. Polycrystalline Cu2O photovoltaic devices incorporating Zn(O,S) window layers10.1016/j.solmat.2016.10.049 ↗
8. Heterojunction solar cell with 2% efficiency based on a Cu2O substrate10.1063/1.2194315 ↗
9. Organometal perovskite light absorbers toward a 20% efficiency low-cost solid-state mesoscopic solar cell10.1021/jz400892a ↗
10. A mixed-cation lead mixed-halide perovskite absorber for tandem solar cells10.1126/science.aad5845 ↗
11. Monolithic CIGS-Perovskite tandem cell for optimal light harvesting without current matching10.1021/acsphotonics.6b00929 ↗
12. High-performance photovoltaic perovskite layers fabricated through intramolecular exchange10.1126/science.aaa9272 ↗
13. Solar cell efficiency tables (version 54)10.1002/pip.3171 ↗
14. Efficiency, stable and scalable perovskite solar cells using poly(3-hexylthiophene)10.1038/s41586-019-1036-3 ↗
15. Evaluation of external efficiency of a 12.35% tandem solar cell comprising dye-sensitized and CIGS solar cells10.1016/j.solmat.2011.07.038 ↗
16. Study and enhance the photovoltaic properties of narrow-bandgap Cu2SnS3 solar cell by p-n junction interface modification10.1016/j.jcis.2012.03.015 ↗
17. Cd-free Cu(In,Ga)(S,Se)2 thin-film solar cell with record efficiency of 23.35%10.1109/JPHOTOV.2019.2937218 ↗
18. Device characteristics of CZTSSe thin-film solar cells with 12.6% efficiency10.1002/aenm.201301465 ↗
19. Investigation of carrier recombination of Na-doped Cu2SnS3 solar cell for its improved conversion efficiency of 5.1%10.1016/j.solmat.2019.110261 ↗
20. Germanium and indium
21. Photovoltaic characteristic of thin films of Cu2SnS310.1016/0165-1633(87)90019-0 ↗
22. Thin film solar cells based on the ternary compound Cu2SnS310.1016/j.tsf.2012.05.085 ↗
23. Non-toxic, earth-abundant 2% efficient Cu2SnS3 solar cell based on tetragonal films direct-coated from single metal-organic precursor solution10.1016/j.solmat.2013.02.017 ↗
24. Sulfurization temperature dependences of photovoltaic properties in Cu2SnS3-based thin-film solar cells10.7567/JJAP.53.05FW13 ↗
25. Energy level diagram around Ge-rich grain boundaries in Cu2Sn1-xGexS3 (CTGS) thin-film solar cells10.1016/j.solmat.2014.11.024 ↗
26. Cu2Sn1-xGexS3 solar cells fabricated with a graded bandgap structure
27. Wide band gap Cu(In,Ga)Se2 solar cells with improved energy conversion efficiency10.1002/pip.2244 ↗
28. Investigation of correlation between open-circuit voltage deficit and carrier recombination rates in Cu(In,Ga)(S,Se)2-based thin-film solar cells10.1063/1.5023828 ↗
29. Structures of Cu(In,Ga)(S,Se)2 solar cells for minimizing open-circuit voltage deficit: Investigation of carrier recombination rates10.1002/pip.3137 ↗
30. Effect of Ga content on defect states in CuIn1-xGaxSe2 photovoltaic devices10.1063/1.1485301 ↗
31. Carrier collection in Cu(In,Ga)Se2 solar cells with graded band gaps and transparent ZnO:Al back contacts10.1016/j.solmat.2006.12.014 ↗
32. Influence of Na in Cu2SnS3 film on its physical properties and photovoltaic performances10.1016/j.tsf.2017.06.044 ↗
33. Admittance spectroscopy of Cu2ZnSnS4 based thin film solar cells10.1063/1.4726042 ↗
34. Effects of Mo back-contact annealing on surface potential and carrier transport in Cu2ZnSnS4 thin film solar cells10.1039/C6RA22563B ↗
35. Effects of Na and MoS2 on Cu2ZnSnS4 thin-film solar cell10.1002/pip.2500 ↗
36. Na role during sulfurization of NaF/Cu/SnS2 stacked precursor for formation of Cu2SnS3 thin film as absorber of solar cell10.1016/j.apsusc.2017.04.099 ↗
37. Characteristics of Zn1-xMgxO:B and its application as transparent conductive oxide layer in Cu(In,Ga)(S,Se)2 solar cells with and without CdS buffer layer10.1016/j.solener.2019.04.029 ↗
38. Earth-abundant and low-cost CZTS solar cell on flexible molybdenum foil10.1039/C4RA02064B ↗
39. Band tailing and efficiency limitation in kesterite solar cells, Appl
40. Solution processed single-phase Cu2SnS3 films: structure and photovoltaic performance10.1039/C7SE00150A ↗
41. Influence of Cu(Ge + Sn) composition ratio on photovoltaic performances of Cu2Sn1-xGexS3 solar cell10.1016/j.solener.2017.04.025 ↗
42. Cu2SnS3 and Cu4SnS4 thin films via chemical deposition for photovoltaic application10.1149/1.3384660 ↗
43. Investigation of the sulferization process of Cu2SnS3 thin films and estimation of band offsets of Cu2SnS3-related solar cell structure10.1002/pssc.201400294 ↗