Towards In-reduced photovoltaic absorbers: Evaluation of zinc-blende CuInSe2-ZnSe solid solution
Source abstract
Abstract
Abstract We have synthesized CuInSe 2 -ZnSe (CZISe) thin films by two-step sequential process and tested its potential for photovoltaic application. The material exhibits a high absorption coefficient (>10 5 cm −1 at wavelength lower than 800 nm) and a direct band gap around 1.2 eV, being an excellent candidate for absorber in thin film solar cells. The power and temperature dependent photoluminescence properties were similar to chalcopyrite and kesterite type materials. In a first optimization round, we have studied the influence of Cu content on the structural and electrical properties of CZISe. The optimum range of Cu/(Zn+In) ratio was identified that yielded the best performance of solar cells. The champion cell demonstrated an efficiency of 7.6% with an open circuit voltage as high as 520 mV, corroborating the possible high interest of this alloy for the development of sustainable, cost-efficient and critical raw materials reduced thin film photovoltaic technologies.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Chalcogenide Semiconductor Thin Films · Quantum Dots Synthesis And Properties · Copper-based nanomaterials and applications
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (39)
Show source-provided references
1. Optimization of CdS buffer layer for high-performance Cu2ZnSnSe4 solar cells and the effects of light soaking: elimination of crossover and red kink10.1002/pip.2589 ↗
2. Large efficiency improvement in Cu2ZnSnSe4 solar cells by introducing a superficial Ge nanolayer10.1002/aenm.201501070 ↗
3. Overcoming efficiency limitation of SnS-based solar cells10.1002/aenm.201400496 ↗
4. Fabrication of Cu2SnS3 thin films by sulfurization of evaporated Cu-Sn precursors for solar cells10.1002/pssc.201200866 ↗
5. Device characteristics of CZTSSe thin-film solar cells with 12.6% efficiency10.1002/aenm.201301465 ↗
6. Employing Si solar cell technology to increase efficiency of ultra-thin Cu(In,Ga)Se2 solar cells10.1002/pip.2527 ↗
7. Improved rear surface passivation of Cu(In,Ga)Se2 Solar Cells: a combination of an Al2O3 rear surface passivation layer and nanosized local rear point contacts10.1109/JPHOTOV.2013.2287769 ↗
8. Investigation of CuInZnSe2 thin films for solar cell applications10.1016/j.tsf.2005.01.063 ↗
9. Synthesis of (CuInS2) 0.5 (ZnS) 0.5 alloy nanocrystals and their use for the fabrication of Solar Cells via selenization10.1021/cm501017z ↗
10. Structural aspects of adamantine like multinary chalcogenides10.1016/j.tsf.2006.12.100 ↗
11. Crystallographic and optical properties of CuInSe2-ZnSe system10.7567/JJAP.53.05FW07 ↗
12. Electronic band gap of Zn2x(CuIn)1−xX2 solid solution series (X=S, Se, Te)10.1016/j.jallcom.2005.07.014 ↗
13. Preparation and investigation of (CuInSe2)x(2ZnSe)1−x and (CuInTe2)x(2ZnTe)1−x solid solution crystals10.1002/crat.200310186 ↗
14. A low-temperature order-disorder transition in Cu2ZnSnS4 thin films10.1063/1.4863685 ↗
15. The band gap of Cu2ZnSnSe4: effect of order-disorder10.1063/1.4896315 ↗
16. CuInSe2 for photovoltaic application10.1063/1.349175 ↗
17. Thin-film solar cells: an overview10.1002/pip.541 ↗
18. Inhibiting the absorber/Mo-back contact decomposition reaction in Cu2ZnSnSe4 solar cells: the role of a ZnO intermediate nanolayer10.1039/c3ta11419h ↗
19. Comparison of lift-off processes and rear-surface characterization of Cu(In,Ga)Se2 thin films for solar cells10.1016/j.jcrysgro.2008.09.136 ↗
20. Influence of compositionally induced defects on the vibrational properties of device grade Cu2ZnSnSe4 absorbers for kesterite based solar cells10.1063/1.4913262 ↗
21. Composition dependence of the Raman A1 mode and additional mode in tetragonal Cu–In–Se thin films10.1088/0268-1242/19/10/006 ↗
22. Vibrational and crystalline properties of polymorphic CuInC2 (C= Se,S) chalcogenides10.1103/PhysRevB.71.054303 ↗
23. Raman spectra of CuInSe2 thin films prepared by chemical spray pyrolysis10.1143/JJAP.36.L1394 ↗
24. Secondary phase formation in Zn-rich Cu2ZnSnSe4-based solar cells annealed in low pressure and temperature conditions10.1002/pip.2473 ↗
25. Raman scattering and infrared reflectance in 2H-MoSe210.1143/JPSJ.49.1069 ↗
26. Optical properties and grain boundary effects in CuInSe210.1116/1.571928 ↗
27. Excitation-power dependence of the near-band-edge photoluminescence of semiconductors10.1103/PhysRevB.45.8989 ↗
28. Excitation-dependent emission in Mg-, Be-, Cd-, and Zn implanted GaAs10.1063/1.323631 ↗
29. Photoluminescence study of potential fluctuations in thin layers of Cu(In0.75Ga0.25)(SySe1−y)210.1063/1.2180429 ↗
30. Deep defects in Cu2ZnSn(S,Se)4 solar cells with varying Se content10.1103/PhysRevApplied.5.024004 ↗
31. Radiative transitions in highly doped and compensated chalcopyrites and kesterites: the case of Cu2ZnSnS410.1103/PhysRevB.90.235202 ↗
32. Lux-Steiner, Radiative recombination via intrinsic defects in CuxGaySe210.1063/1.1357786 ↗
33. Compositional investigation of potassium doped Cu (In, Ga) Se2 solar cells with efficiencies up to 20.8%10.1002/pssr.201409040 ↗
34. Thoughts on the microstructure of polycrystalline thin film CuInSe2 and its impact on material and device performance10.1016/0379-6787(91)90034-M ↗
35. Depth profile of the lattice constant of the Cu-poor surface layer in (Cu2Se)1- x(In2Se3)x evidenced by grazing incidence X-ray diffraction10.1016/S0022-3697(03)00074-X ↗
36. Chalcopyrite/defect chalcopyrite heterojunctions on the basis of CuInSe210.1063/1.353020 ↗
37. Raman scattering analysis of electrodeposited Cu(In,Ga)Se2 solar cells: impact of ordered vacancy compounds on cell efficiency10.1063/1.4890970 ↗
38. The path towards a high-performance solution-processed kesterite solar cell10.1016/j.solmat.2010.11.028 ↗
39. J.Abushama, R.Noufi, S.Johnston, S.Ward, X. Wu, in: Proceedings of the 31st IEEE photovoltaics Specialists Conference and Exhibition pp. 299–302, 2005.