Deposition pressure dependent structural and optoelectronic properties of ex-situ boron-doped poly-Si/SiOx passivating contacts based on sputtered silicon
Source abstract
Abstract
Abstract Among common methods to form polycrystalline silicon (poly-Si) films for passivating-contact solar cells, physical vapor deposition, in particular sputtering, is the safest one as it does not require any toxic gaseous precursors. One of the critical parameters to control the properties of sputtered silicon films is their deposition pressure. In this work, structural and optoelectronic characteristics of ex-situ boron-doped poly-Si/SiOx passivating contacts, formed from sputtered intrinsic amorphous silicon (a-Si) deposited at different pressures on top of SiOx/c-Si substrates and subjected to a high-temperature boron diffusion step, are investigated. The deposition rate and density of the as-deposited a-Si films increase with reducing pressure. Low-temperature photoluminescence spectra captured from the as-deposited samples at different pressures do not show typical emissions from hydrogenated a-Si. Meanwhile, their Fourier-transform infrared absorption spectra all show Si–H stretching modes, indicating that hydrogen had been initially incorporated into the chemical SiOx layers and eventually hydrogenated the a-Si/SiOx interfaces during the sputtering process. After the high-temperature boron-diffusion step, all hydrogen-related peaks disappear. Lower pressure films (1.5 and 2.5 mTorr) show more consistent improved performance after hydrogen treatments, compared to higher pressure films (4 and 5 mTorr). The resultant passivating contacts at 2.5 mTorr achieve a low single-side recombination current density Jo of ~9 fA/cm2, whereas their contact resistivity is still low at 15 mΩ cm2.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Silicon and Solar Cell Technologies · Thin-Film Transistor Technologies · Silicon Nanostructures and Photoluminescence
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (30)
Show source-provided references
1. Tunnel oxide passivating electron contacts as full-area rear emitter of high-efficiency p-type silicon solar cells10.1002/pip.2960 ↗
2. High efficiency n-type silicon solar cells with passivating contacts based on PECVD silicon films doped by phosphorus diffusion10.1016/j.solmat.2019.01.005 ↗
3. 26.1%-efficient POLO-IBC cells: quantification of electrical and optical loss mechanisms
4. 26%-efficient and 2 cm narrow interdigitated back contact silicon solar cells with passivated slits on two edges10.1016/j.solmat.2019.110021 ↗
5. n-Type polysilicon passivating contact for industrial bifacial n-type solar cells10.1016/j.solmat.2016.06.034 ↗
6. The application of poly-Si/SiOxcontacts as passivated top/rear contacts in Si solar cells10.1016/j.solmat.2016.09.015 ↗
7. Phosphorus diffused LPCVD polysilicon passivated contacts with in-situ low pressure oxidation10.1016/j.solmat.2018.06.039 ↗
8. Atmospheric pressure chemical vapor deposition of in-situ doped amorphous silicon layers for passivating contacts
9. Poly-Si/SiO x/c-Si passivating contact with 738 mV implied open circuit voltage fabricated by hot-wire chemical vapor deposition10.1063/1.5089650 ↗
10. Physical sputtering and sputter deposition (sputtering)
11. High-efficiency, flexible CdTe solar cells on ultra-thin glass substrates10.1063/1.4916634 ↗
12. CIGS solar cell with MBE-grown ZnS buffer layer10.1016/j.solmat.2008.11.047 ↗
13. Implementing transparent conducting oxides by DC sputtering on ultrathin SiOx/poly-Si passivating contacts10.1016/j.solmat.2019.109960 ↗
14. Building blocks for industrial, screen-printed double-side contacted POLO cells with highly transparent ZnO:Al layers
15. Spatially and spectrally resolved absorptivity: new approach for degradation studies in perovskite and perovskite/silicon tandem solar cells
16. 23% efficient p-type crystalline silicon solar cells with hole-selective passivating contacts based on physical vapor deposition of doped silicon films10.1063/1.5037610 ↗
17. Sub-bandgap luminescence from doped polycrystalline and amorphous silicon films and its application to understanding passivating-contact solar cells10.1021/acsaem.8b01561 ↗
18. Hydrogenation of phosphorus-doped polycrystalline silicon films for passivating contact solar cells10.1021/acsami.8b19989 ↗
19. Hydrogen-assisted defect engineering of doped poly-Si films for passivating contact solar cells10.1021/acsaem.9b01771 ↗
20. Hydrogenation mechanisms of poly‐Si/SiO x passivating contacts by different capping layers
21. Hydrogenation of polycrystalline silicon films for passivating contacts solar cells
22. Luminescence from poly-Si films and its application to study passivating-contact solar cells
23. Micro-photoluminescence spectroscopy on heavily-doped layers of silicon solar cells10.1002/pssr.201510049 ↗
24. Characterizing amorphous silicon, silicon nitride, and diffused layers in crystalline silicon solar cells using micro-photoluminescence spectroscopy10.1016/j.solmat.2015.11.006 ↗
25. Structural and optical characterization of pure Si-rich nitride thin films10.1186/1556-276X-8-31 ↗
26. Fourier transform infrared spectroscopy of annealed silicon-rich silicon nitride thin films10.1063/1.3021158 ↗
27. Structural and optical characteristics of in-situ sputtered highly oriented 15R-SiC thin films on different substrates10.1063/1.5006976 ↗
28. Influence of PECVD deposition temperature on phosphorus doped poly-silicon passivating contacts10.1016/j.solmat.2019.110348 ↗
29. Birkholz · 2005
30. Ohmic contacts for GaAs devices10.1016/0038-1101(67)90063-9 ↗