ZnSnP2 solar cell with (Cd,Zn)S buffer layer: Analysis of recombination rates
Source abstract
Abstract
Abstract A ZnSnP 2 bulk crystal was prepared by flux method and cut into a ZnSnP 2 wafer with thickness of 200 µm, which was utilized as the absorber of a ZnSnP 2 solar cell with a Al/ZnO:Al/ZnO/(Cd,Zn)S buffer/ZnSnP 2 wafer/Cu structure. A 3.44%-efficient ZnSnP 2 solar cell was obtained. Moreover, we assessed performance of the ZnSnP 2 solar cell concentrating on main loss mechanisms limiting device efficiency. Based on investigations of the majority carrier barrier at ZnSnP 2 and the Cu back electrode, the barrier height is estimated to be 59 meV, which could limit the fill factor of the solar cell and should be decreased. In addition, voltage-independent recombination rates at the buffer/absorber interface ( R i 0 ), in the space-charge region ( R d 0 ), and in the quasi-neutral region ( R b 0 ) of the ZnSnP 2 solar cell were determined from illumination dependence of the open-circuit voltage. It was found that R d 0 is 2.65×10 13 cm −2 s −1 , much high than R i 0 + R b 0 of 1.2×10 9 cm −2 s −1 . The high R d 0 was attributed to the mechanical surface polish of the ZnSnP 2 wafer. It is thought that R b 0 should be lower than R i 0 because of the large ZnSnP 2 grain and non-optimized buffer/absorber interface. These findings suggested that R i 0 and R d 0 should be further decreased to enhance photovoltaic performance.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Chalcogenide Semiconductor Thin Films · Semiconductor materials and interfaces · Quantum Dots Synthesis And Properties
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (29)
Show source-provided references
1. Background and motivation for thin-film solar-cell development
2. Epitaxial thin film crystalline silicon solar cells on low cost silicon carriers
3. Potassium-induced surface modification of Cu(In,Ga)Se2 thin films for high-efficiency solar cells10.1038/nmat3789 ↗
4. Effects of heavy alkali elements in Cu(In,Ga)Se2 solar cells with efficiencies up to 22.6%10.1002/pssr.201600199 ↗
5. R. Kamada, T. Yagioka, S. Adachi, A. Handa, K.F. Tai, T. Kato, H. Sugimoto, New world record Cu(In,Ga)(Se,S)2 thin film solar cell efficiency beyond 22%, The 43rd IEEE Photovoltaic Specialists Conference 2016 pp. 1287–1291.10.1109/PVSC.2016.7749822 ↗
6. Characterization of defects in 9.7% efficient Cu2ZnSnSe4-CdS-ZnO solar cells10.1063/1.4826448 ↗
7. Device characteristics of CZTSSe thin-film solar cells with 12.6% efficiency10.1002/aenm.201301465 ↗
8. JR, Preparation and characteristics of ZnSnP210.1016/0022-3697(68)90132-7 ↗
9. The structure and properties of the semiconducting compound ZnSnP210.1002/pssb.19680290144 ↗
10. Fabrication of ZnSnP2 thin films by phosphidation10.1016/j.tsf.2015.04.020 ↗
11. Characterization of vacuum grown thin films of ZnSnP210.1016/0167-577X(87)90012-7 ↗
12. Theoretical photovoltaic conversion efficiencies of ZnSnP2, CdSnP2, and Zn1-xCdxSnP2 alloy
13. Band gap of sphalerite and chalcopyrite phases of expitaxial ZnSnP210.1063/1.3442917 ↗
14. Detail balance limit of efficiency of pn junction solar cells10.1063/1.1736034 ↗
15. Solar cells using bulk crystals of rare metal-free compound semiconductor ZnSnP2
16. ZnSnP2 thin-film solar cell prepared by phosphidation method under optimized Zn/Sn atomic ratio of its absorbing layer10.1016/j.cap.2017.02.005 ↗
17. Band offset at the heterojunction interfaces of CdS/ZnSnP2, ZnS/ZnSnP2, and In2S3/ZnSnP210.1063/1.4950882 ↗
18. Theoretical analysis of the effect of conduction band offset of window/CIS layers on performance of CIS solar cells using device simulation10.1016/S0927-0248(00)00266-X ↗
19. Thin-film Cu(In,Ga)(Se,S)2 -based solar cell with (Cd,Zn)S buffer layer and Zn1−xMgxO window layer10.1002/pip.2879 ↗
20. J. Song, S.S. Li, L. Chen, R. Noufi, T.J. Anderson, O.D. Crisalle, Investigation of CdZnS buffer layers on the performance of CuInGaSe2 and CuGaSe2 solar cells, The 4th World Conference on Photovoltaic Energy Conversion, 2006, pp. 534–537.10.1109/WCPEC.2006.279510 ↗
21. Bulk crystal growth and characterization of ZnSnP2 compound semiconductor by flux method10.1002/pssc.201400291 ↗
22. Interdependence of absorber composition and recombination mechanism in Cu(In,Ga)(Se,S)2 heterojunction solar cells10.1063/1.1467621 ↗
23. Analysis of heterointerface recombination by Zn1−xMgxO for window layer of Cu(In,Ga)Se2 solar cells10.1016/j.solener.2008.09.003 ↗
24. Growth and properties of the Cd1−xZnxS thin films for solar cell application10.1016/S0040-6090(03)00526-1 ↗
25. Loss mechanism in hydrazine-processed Cu2ZnSn(Se,S)4 solar cells10.1063/1.3522884 ↗
26. Thermally evaporated Cu2ZnSnS4 solar cells
27. A recombination analysis of Cu(In,Ga)Se2 solar cells with low and high Ga compositions10.1016/j.solmat.2014.01.047 ↗
28. Reformulation of solar cell physics to facilitate experimental separation of recombination pathways10.1063/1.4819728 ↗
29. First-principles study of point defects in chalcopyrite ZnSnP210.1103/PhysRevB.90.125202 ↗