Optical and electrical properties of In-doped Cu2ZnSnSe4
Source abstract
Abstract
Cu2ZnSnSe4 (CZTSe) is a very promising material as absorber layer for low cost and earth abundant thin film solar cells. Currently in this technology we can find indium in different layers, including the transparent window layer In2O3:SnO2 (ITO), and the In2S3/CdS double emitter, both used in high effi ciency devices. Therefore, during devices fabrication processes, In could be a potential contaminant and consequently, it is very interesting to investigate its possible impact in the solar cells performance. Besides this, a key factor in the control of material properties lies in the doping. Extrinsic doping has been barely studied for CZTSe and among the possible doping elements, In is one of the most interesting candidates, because it has the possibility to occupy either Sn or Cu/Zn positions. In this work we investigate the indium doping of CZTSe thin films. For this purpose, CZTSe was synthesized by a sequential process with different nominal In concentrations ranging from 0 to 2.6 10^20 cm^-3 . We demonstrate that In is uniformly introduced in CZTSe, not affecting the main ele ments distribution, but impacting in the Na quantity at the surface. Drastic changes on the morphology are observed, where the increasing indium concentration leads to the formation of a bilayer structure. Efficiencies in the range of 7–7.5% or 8.5–9.2% were obtained for In concentrations below 2.6 10^19 cm^-3 for pure CZTSe and CZTSe:Ge respectively, decreasing for further doping levels mainly due to the deterioration of the fill factor, while the other optoelectronic parameters are less affected. We propose a phenomenological model supported by the complete electrical characterization of the material and devices, showing that a conductive phase deteriorates the properties of the system that we associate to the possible presence of mixed Sn-oxides and In-oxides
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Chalcogenide Semiconductor Thin Films · Quantum Dots Synthesis And Properties · Copper-based nanomaterials and applications
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (27)
Show source-provided references
1. Kesterites—a challenging material for solar cells10.1002/pip.2156 ↗
2. Kësterite thin films for photovoltaics: a review10.1051/epjpv/2012008 ↗
3. Development of a selective chemical etch to improve the conversion efficiency of Zn-rich Cu2ZnSnS4 solar cells10.1021/ja301373e ↗
4. Cu2ZnSnSe4 thin-film solar cells by thermal co-evaporation with 11.6% efficiency and improved minority carrier diffusion length10.1002/aenm.201401372 ↗
5. 8.2% pure selenide kesterite thin-film solar cells from large-area electrodeposited precursors
6. High efficiency Cu2ZnSn(S,Se)4 solar cells by applying a double In2S3/CdS emitter10.1002/adma.201402373 ↗
7. Effects of potassium doping on solution processed kesterite Cu2ZnSnS4 thin film solar cells10.1063/1.4903500 ↗
8. Photocarrier dynamics in undoped and Na-doped Cu2ZnSnS4 single crystals revealed by ultrafast time-resolved terahertz spectroscopy10.7567/APEX.8.062303 ↗
9. Sodium doping effects on the crystalline and electrical properties of Cu2ZnSnSe4 thin films10.1016/j.solener.2015.02.033 ↗
10. Rational defect passivation of Cu2ZnSn(S,Se)4 photovoltaics with solution-processed Cu2ZnSnS4:Na nanocrystals10.1021/ja407202u ↗
11. The influence of Na on low temperature growth of CIGS thin film solar cells on polyimide substrates10.1016/j.tsf.2008.10.085 ↗
12. High efficiency low temperature grown Cu(In,Ga)Se2 thin film solar cells on flexible substrates using NaF precursor layers10.1002/pip.1064 ↗
13. Raman scattering analysis of Cu-poor Cu(In,Ga)Se2 cells fabricated on polyimide substrates: effect of Na content on microstructure and phase structure10.1016/j.tsf.2010.12.177 ↗
14. Combinatorial exploration of the effects of intrinsic and extrinsic defects in Cu2ZnSn(S,Se)410.1109/JPHOTOV.2014.2361053 ↗
15. Giraldo · Adv. Energy Mater. · 2015 · 5 · 150107010.1002/aenm.201501070 ↗
16. Electrical conduction and mobility enhancement in p-type In-doped Cu2ZnSnSe4 bulks10.7567/JJAP.53.035801 ↗
17. Neuschitzer · Progress Photovolt. Res. Appl. · 2015 · 23 · 166010.1002/pip.2589 ↗
18. Neuschitzer · Chem. Mater. · 2015 · 27 · 527910.1021/acs.chemmater.5b01473 ↗
19. In-situ XRD study of alloyed Cu2ZnSnSe4–CuInSe2 thin films for solar cells10.1016/j.tsf.2014.11.061 ↗
20. Influence of sodium on the growth of polycrystalline Cu(In,Ga)Se2 thin films10.1016/S0040-6090(99)00777-4 ↗
21. Na in selenized Cu(In,Ga)Se2 on Na-containing and Na-free glasses: distribution, grain structure, and device performances10.1016/S0040-6090(00)01028-2 ↗
22. Radiative recombination in Cu2ZnSnSe4 monograins studied by photoluminescence spectroscopy10.1016/j.tsf.2008.11.024 ↗
23. Defect studies in Cu2ZnSnSe4 and Cu2ZnSn(Se0.75S0.25)4 by admittance and photoluminescence spectroscopy10.1016/j.mssp.2013.02.009 ↗
24. The impact of sodium on the sub-bandgap states in CZTSe and CZTS10.1063/1.4916635 ↗
25. Gilmore · 2003
26. Effects of sodium incorporation in co-evaporated Cu2ZnSnSe4 thin-film solar cells10.1063/1.4802972 ↗
27. Understanding the beneficial role of grain boundaries in polycrystalline solar cells from single-grain-boundary scanning probe microscopy10.1002/adfm.200500396 ↗