On the preparation of n-type SnS:Cu using chemical spray pyrolysis for photovoltaic application: Effect of annealing
Source abstract
Abstract
Abstract Thin films of n-type copper doped tin sulfide (SnS:Cu) are deposited employing Chemical Spray Pyrolysis (CSP) technique and effect of post deposition annealing of the films in vacuum as well as in air is evaluated. Structural characterization through X-ray diffraction proved that annealing aided formation of polycrystalline films with orthorhombic structure and preferential orientation of grains along (111) plane, a direction greatly advantageous for PV applications. Raman spectrum of the films had two peaks (at 96 cm −1 and 224 cm −1 ) belonging only to that of SnS. The band gap of as-prepared films is around ~1.5 eV which changed slightly on annealing. Surface analysis of SnS:Cu films using atomic force microscopy showed the roughness of vacuum annealed samples to be much lower than that of air annealed samples and confirming all the films to be crack free and devoid of pinholes. Chemical analyses with X-ray photoelectron spectroscopy gives the binding energies of Sn3d 5/2 at 485.5 eV and S2p 3/2 at 161.1 eV, confirming the formation of SnS with Sn 2+ and S −2 state. The hot probe measurements revealed their n-type nature, which was affirmed by Hall measurements too. Appreciable hike in conductivity is obtained through Cu-doping; however annealing could not produce any notable effect on conductivity.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Chalcogenide Semiconductor Thin Films · Quantum Dots Synthesis And Properties · Copper-based nanomaterials and applications
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (23)
Show source-provided references
1. Optimization of parameters of chemical spray pyrolysis technique to get n and p-type layers of SnS10.1016/j.tsf.2010.01.040 ↗
2. Optical properties of thermally evaporated SnS thin films10.1016/S0925-3467(02)00030-7 ↗
3. Influence of grain size on the band-gap of annealed SnS thin films10.1016/j.tsf.2013.09.089 ↗
4. Characterization of SnS films prepared by constant-current electro-deposition10.1016/j.tsf.2005.11.028 ↗
5. Structural and optical properties of SnS semiconductor films produced by chemical bath deposition10.1088/0022-3727/42/24/245408 ↗
6. Structure and photoconductive properties of dip-deposited SnS and SnS 2 thin films and their conversion to tin dioxide by annealing in air10.1016/S0040-6090(99)00276-X ↗
7. Tin sulphide thin films synthesised using a two step process10.1016/j.egypro.2012.02.045 ↗
8. Atomic layer deposition of tin monosulfide thin films10.1002/aenm.201100330 ↗
9. Molecular beam epitaxy growth of high quality p-doped SnS van der Waals epitaxy on a graphene buffer layer10.1063/1.4709732 ↗
10. Fabrication of CdS/SnS heterostructured device using successive ionic layer adsorption and reaction deposited SnS10.1016/j.tsf.2010.12.151 ↗
11. Photoelectrochemical characteristics of brush plated tin sulfide thin films10.1016/S0927-0248(02)00366-5 ↗
12. Antimony-doped tin(II) sulfide thin films10.1021/cm3024988 ↗
13. Annealing influence over structural and optical properties of sprayed SnS thin films10.1016/j.optmat.2013.04.034 ↗
14. SnS homojunction nanowire-based solar cells10.1039/c2jm32116e ↗
15. Thin film deposition using spray pyrolysis10.1007/s10832-005-0870-x ↗
16. Photovoltaic properties of SnS based solar cells10.1016/j.solmat.2006.06.012 ↗
17. G.G. Ninan, V.G. Rajeshmon, C.S. Kartha, K.P. Vijayakumar, Cu doping: An effective method for improving optoelectronic properties of sprayed SnS thin films, in: AIP Conference Proceedings, 2014, pp. 1440–1442. 〈http://dx.doi.org/10.1063/1.4872989〉.10.1063/1.4872989 ↗
18. Effect of deposition time on structural, electrical, and optical properties of SnS thin films deposited by chemical bath deposition10.1016/j.apsusc.2010.07.104 ↗
19. Effect of annealing temperature and doping with Cu on physical properties of cadmium oxide thin films10.1016/j.jmrt.2013.02.004 ↗
20. Effect of annealing on structural, optical and electrical properties of pulse electrodeposited tin sulfide films10.1016/j.mssp.2012.07.003 ↗
21. Preparation of nanostructured Cu2 SnS3 photocatalysts by solvothermal method
22. Development of sulphurized SnS thin film solar cells10.1016/j.cap.2015.01.022 ↗
23. Structural evolution of multilayer SnS/Cu/ZnS stack to phase-pure Cu2ZnSnS4 thin films by thermal processing10.1149/2.0171503jss ↗