Stabilization procedures for TOPCon PV modules after UV-induced degradation
Source abstract
Abstract
The study investigates the stabilization behavior of Tunnel Oxide Passivated Contact (TOPCon) photovoltaic (PV) cell technology following UV-induced degradation (UVID). It focuses on the after-effects of lab-induced UVID, particularly the drastic effects of power loss during dark storage after UV irradiation. To counteract these effects, which are considered as artifacts that do not affect the expected outdoor performance, the paper presents light soaking at 25 °C module temperature as reproducible stabilization procedure for module performance measurements. Considering the increasing market presence of TOPCon-based PV modules and recent reports of, in some cases tremendous extent, UVID in the lab, stabilization after UVID is highly relevant. The study further explores the development of degradation during dark storage over time, different conditions for light soaking, as well as the potential of other approaches: While the repeated flashing is in principle applicable for post UVID-stabilization, current injection procedures showed negligible effect. Interestingly, high-temperature treatment reduces the degradation during dark storage. In that, the study offers insights that may inspire cell-level investigations of degradation and stabilization and improve understanding of underlying mechanisms.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Photovoltaic System Optimization Techniques · Silicon and Solar Cell Technologies · Photovoltaic Systems and Sustainability
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (5)
Show source-provided references
1. Reliability of commercial TOPCon PV modules - an extensive comparative study
2. UV‐Induced degradation of industrial PERC, TOPCon, and HJT solar cells: the next big reliability challenge?10.1002/solr.202400628 ↗
3. UVID initiates metastability in the dark: how to properly measure unstable SI modules
4. International Electrotechnical Commission, IEC 61215-2:2021 Terrestrial Photovoltaic (PV) Modules – Design Qualification and Type Approval: Part 2: Test Procedures 2 (accessed 21 April 2021).
5. The effect of light soaking on crystalline silicon surface passivation by atomic layer deposited Al2O310.1063/1.4775595 ↗