journal article·2024-10Open access

Auger-limited bulk lifetimes in industrial Czochralski-grown n-type silicon ingots with melt recharging

Afsaneh Kashizadeh, Rabin Basnet, Lachlan Black, Christian Samundsett, Chang Sun, Qian Jin, Yichun Wang, Hao Deng, Daniel Macdonald

Abstract

This study reports on the electronic properties of industrial phosphorus-doped n-type silicon ingots for photovoltaic applications grown using the Recharged Czochralski method. The electronic quality is assessed via carrier lifetime measurements, both directly on the ingots and on passivated wafers, and via implied open-circuit ( i V O C ), and implied maximum power point ( i V M P P ) voltages. The wafers are studied in the as-grown state, and after various high temperature steps, including Tabula Rasa , phosphorus diffusion gettering, and boron diffusion. The material exhibited very high bulk quality, with bulk lifetimes up to 8 ms at an injection level of 5 × 10 14 cm − 3 , and with i V O C (1-sun) values up to 750 mV , prior to any high temperature processing. A Tabula Rasa step did not significantly improve the wafer quality, indicating a low presence of oxygen-related defects in this material, consistent with the low interstitial oxygen content of below 5 × 10 17 cm − 3 . However, phosphorus diffusion gettering improved the wafer quality, especially towards the tail end of each ingot, and at lower injection levels near maximum power point. Phosphorus diffusion gettering increased the i V O C (1-sun) of the wafers by around 5 mV , approaching the Auger limit. Additionally, a boron diffusion step had minimal impact on the bulk lifetimes. Overall, our findings suggest that these RCz-grown n-type wafers exhibit very high quality, approaching the Auger limit near open-circuit, and are well-suited for high-efficiency solar cells without the need for additional high-temperature processing. • Assessing the material quality of n-type RCz industrial ingots, both directly on the ingot and on passivated wafers. • Bulk lifetimes of up to 8 ms and i V O C (1-sun) values up to 750 mV . • Low interstitial oxygen content of below 5 × 10 17 cm − 3 , low presence of oxygen-related defects. • Improvement of the wafer quality after gettering, particularly towards the bottom of each ingot, nearing the Auger limit. • No significant degradation after boron diffusion.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Silicon and Solar Cell Technologies · Thin-Film Transistor Technologies · Semiconductor materials and interfaces

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (33)

Show source-provided references
1. Vicari Stefani · 2023 · vol. 20
2. Equipment
3. The technical and economic viability of replacing n-type with p-type wafers for silicon heterojunction solar cells
4. Li · 2023
5. Effect of metal impurities concentration on electrical properties in N-type Recharged-Czochralski silicon
6. Fickett · 2001
7. Cost effective growth of silicon mono ingots by the application of a mobile recharge system in CZ-puller
8. Czochralski growth of silicon crystals
9. Cost effective growth of silicon mono ingots by the application of active crystal cooling in combination with large melt volumes in CZ-puller
10. Vaqueiro Contreras
11. Battle of the dopants: challenges and opportunities for n-TOPCon vs Ga-PERC technologies
12. Investigating wafer quality in industrial czochralski-grown gallium-doped p-type silicon ingots with melt recharging10.1002/solr.202300304 ↗
13. Imaging interstitial iron concentrations in boron-doped crystalline silicon using photoluminescence10.1063/1.2903895 ↗
14. Recombination activity of interstitial iron and other transition metal point defects in p- and n-type crystalline silicon10.1063/1.1812833 ↗
15. The impact of interstitial Fe contamination on n-type Cz-Silicon for high efficiency solar cells
16. The effect of oxide precipitates on minority carrier lifetime in n -type silicon10.1063/1.4936852 ↗
17. Interstitial oxygen imaging from thermal donor growth - a fast photoluminescence based method10.1016/j.solmat.2014.05.011 ↗
18. Detecting efficiency-limiting defects in Czochralski-grown silicon wafers in solar cell production using photoluminescence imaging10.1002/pssr.201105183 ↗
19. Onset of ring defects in n-type Czochralski-grown silicon wafers10.1063/5.0005899 ↗
20. Impact of pre-fabrication treatments on n-type UMG wafers for 21% efficient silicon heterojunction solar cells
21. Methods to improve bulk lifetime in n-type czochralski-grown upgraded metallurgical-grade silicon wafers10.1109/JPHOTOV.2018.2834944 ↗
22. Liu · 2022
23. Quasi-steady-state photoconductance bulk lifetime measurements on silicon ingots with deeper photogeneration10.1063/1.5086378 ↗
24. Contactless determination of current-voltage characteristics and minority-carrier lifetimes in semiconductors from quasi-steady-state photoconductance data10.1063/1.117723 ↗
25. Uncertainty in photoconductance lifetime measurements that use an inductive-coil detector
26. Thermal double donor annihilation and oxygen precipitation at around 650°C in Czochralski-grown Si: local vibrational mode studies10.1088/0953-8984/17/22/011 ↗
27. Reassessment of the intrinsic bulk recombination in crystalline silicon10.1016/j.solmat.2021.111467 ↗
28. On effective surface recombination parameters10.1063/1.4886595 ↗
29. Low surface recombination velocity by low-absorption silicon nitride on c-Si10.1109/JPHOTOV.2012.2215014 ↗
30. Silicon wafers for industrial n-type SHJ solar cells: bulk quality requirements, large-scale availability and guidelines for future developments10.1016/j.solmat.2021.111128 ↗
31. Tabula Rasa for n-Cz silicon-based photovoltaics10.1002/pip.3068 ↗
32. Understanding the origin of Tabula Rasa-induced defects in n-type Cz c-Si: the case of nitrogen atmosphere
33. Industrial czochralski n-type silicon wafers: gettering effectiveness and possible bulk limiting defects