Influence of unintentional H2O introduction in sputtering chamber on ITO films and HJT solar cells
Source abstract
Abstract
In this study, we investigated the effect of H 2 O partial pressure on the chemical characteristic and optoelectrical properties of the indium tin oxide (ITO) films and the performance and stability of heterojunction (HJT) solar cells. The H 2O with varying partial pressure from 2.72 × 10 −5 Pa to 8.38 × 10 −5 Pa is obtained from the residual gas in the magnetron sputtering device chamber. With the H 2O partial pressure raises, the resistivity of ITO films increases from 3.6 × 10 −4 Ω·cm to 5.3 × 10 −4 Ω·cm, and the effective total transmittance improves slightly in the near-infrared region. The efficiency of HJT solar cells with ITO films deposited at high H 2O partial pressure is lower due to the deterioration of fill factor ( FF), even though the short circuit current ( I sc) increased. Thus, the maximum HJT solar cell efficiency of 25.30% is achieved at low H 2O partial pressure. In addition, the performance of HJT solar cells under a nitrogen environment without illumination was tracked. It is observed that the high cell efficiency obtained with low H 2O partial pressure has a larger degradation, which is mainly derived from the FF degradation.
Source: expertdata · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Silicon and Solar Cell Technologies · Thin-Film Transistor Technologies · Chalcogenide Semiconductor Thin Films
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (35)
Show source-provided references
1. 25.11% efficiency silicon heterojunction solar cell with low deposition rate intrinsic amorphous silicon buffer layers10.1016/j.solmat.2020.110643 ↗
2. Power conversion efficiency of 25.26% for silicon heterojunction solar cell with transition metal element doped indium oxide transparent conductive film as front electrode10.1002/pip.3565 ↗
3. Development of high efficiency rear-emitter n-type silicon heterojunction solar cells
4. High-efficiency silicon heterojunction solar cells: materials, devices and applications10.1016/j.mser.2020.100579 ↗
5. Infrared light management in high-efficiency silicon heterojunction and rear-passivated solar cells10.1063/1.4772975 ↗
6. Hydrogen-doped In2O3 for silicon heterojunction solar cells: identification of a critical threshold for water content and rf sputtering power10.1016/j.solmat.2020.110844 ↗
7. High mobility transparent conductive oxides for silicon heterojunction solar cells deposited by rotatable magnetrons
8. Surface scattering effect on the electrical mobility of ultrathin Ce doped In2O3 film prepared at low temperature10.1016/j.matlet.2018.04.102 ↗
9. High electron mobility W-doped In₂O₃ thin films by pulsed laser deposition10.1063/1.2048829 ↗
10. The sputter deposition of broadband transparent and highly conductive cerium and hydrogen co-doped indium oxide and its transfer to silicon heterojunction solar cells10.1002/pip.3388 ↗
11. Effective mass of high-mobility In2O3-based transparent conductive oxides fabricated by solid-phase crystallization
12. Carrier transport in polycrystalline transparent conductive oxides: a comparative study of zinc oxide and indium oxide10.1016/j.tsf.2007.05.084 ↗
13. Environmental stability of high-mobility indium-oxide based transparent electrodes10.1063/1.4935125 ↗
14. Effect of front TCO on the performance of rear-junction silicon heterojunction solar cells: insights from simulations and experiments10.1016/j.solmat.2019.01.047 ↗
15. Investigation of In2O3:SnO2 films with different doping ratio and application as transparent conducting electrode in silicon heterojunction solar cell10.1016/j.solmat.2021.111404 ↗
16. Electrical properties of In2O3 single crystals doped with metallic donor impurity10.1143/JJAP.23.127 ↗
17. In-Sn oxide bilayer transparent conductive film by DC magnetron sputtering for silicon heterojunction solar cells10.1109/JPHOTOV.2020.3048259 ↗
18. Oxygen incorporation in thin films of In2O3: Sn prepared by radio frequency sputtering10.1063/1.1287603 ↗
19. Effect of ambient combinations of argon, oxygen, and hydrogen on the properties of DC magnetron sputtered indium tin oxide films10.1063/1.4906566 ↗
20. Effect of oxygen and hydrogen flow ratio on indium tin oxide films in rear-junction silicon heterojunction solar cells10.1016/j.solener.2021.12.007 ↗
21. Low resistivity transparent indium tin oxide (ITO) films sputtered at room temperature with H2O addition10.1557/PROC-424-341 ↗
22. Electron scattering and doping mechanisms in solid-phase-crystallized In2O3:H prepared by atomic layer deposition10.1021/acsami.5b04420 ↗
23. Structural and electrical properties of hydrogen-doped In2O3 films fabricated by solid-phase crystallization10.1016/j.jnoncrysol.2007.09.076 ↗
24. Hydrogen doping in indium oxide: an ab initio study10.1103/PhysRevB.80.193202 ↗
25. High-mobility hydrogenated indium oxide without introducing water during sputtering10.1016/j.egypro.2016.07.083 ↗
26. Effect of the crystallinity of indium tin oxide on the charge transfer at the interfaces and the performances of flexible organic light emitting diodes10.1002/pssa.201431550 ↗
27. X-ray photoelectron spectroscopy investigation of ion beam sputtered indium tin oxide films as a function of oxygen pressure during deposition10.1116/1.574109 ↗
28. X-ray photoelectron spectroscopy of surface-treated indium-tin oxide thin films10.1016/S0009-2614(99)01233-6 ↗
29. Characterization of indium-tin oxide interfaces using X-ray photoelectron spectroscopy and redox processes of a chemisorbed probe molecule: effect of surface pretreatment conditions10.1021/la011101t ↗
30. The key of ITO films with high transparency and conductivity: grain size and surface chemical composition
31. Hydrogen-doped In2O3 as high-mobility transparent conductive oxide10.1143/JJAP.46.L685 ↗
32. Effect of humidity on optical and electrical properties of Zr-doped In2O3 and a new structure for transparent electrode of silicon heterojunction solar cell10.1016/j.solener.2019.12.017 ↗
33. High-mobility hydrogen-doped In2O3 transparent conductive oxide for a-Si:H/c-Si heterojunction solar cells10.1016/j.solmat.2008.09.047 ↗
34. In2O3-Based transparent conducting oxide films with high electron mobility fabricated at low process temperatures10.1002/pssa.201700506 ↗
35. Effect of residual water vapor on the performance of indium tin oxide film and silicon heterojunction solar cell10.1016/j.solener.2020.04.086 ↗