Investigation on temperature dependence of recent high-efficiency silicon solar modules
Source abstract
Abstract
The temperature dependence of photovoltaic modules varies with temperature and irradiance. For recent high-efficiency solar modules such as silicon heterojunction (SHJ) solar modules and tunneling oxide passivated contact (TOPCon) solar modules, it is not clear how their temperature dependence changes with temperature and irradiance. In this study, the temperature dependence of SHJ and TOPCon solar modules was studied by measuring I–V curves with the irradiance ranging from 200 to 1000 W/m 2 and temperature ranging from 25 to 75 °C. The passivated emitter and rear cell (PERC) solar modules were measured as a reference. The results indicate that the temperature dependence of short-circuit current ( I sc) for the three modules is almost invariable with temperature and irradiance. The temperature dependence of open-circuit voltage ( V oc) and maximum power ( P m) decreasees with the increasing module temperature, and increasees with the increasing irradiance. It can be observed that the absolute magnitude of ( ∂ P m / ∂ T ) / P m for SHJ is the smallest, which is more obvious at high irradiance. An interesting finding is that the temperature dependence of fill factor ( FF) for SHJ solar module increases with increasing irradiance, which is opposite to PERC and TOPCon solar modules. This phenomenon is related to the temperature dependence of series resistance. In addition, the temperature dependence is not linear at low temperature and irradiance. The obtained results in this paper can provide useful insight into predicting performance ratio of PERC, SHJ and TOPCon solar modules.
Source: expertdata · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Photovoltaic System Optimization Techniques · Silicon and Solar Cell Technologies · solar cell performance optimization
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (49)
Show source-provided references
1. General temperature dependence of solar cell performance and implications for device modelling10.1002/pip.496 ↗
2. New analytical approach for modelling effects of temperature and irradiance on physical parameters of photovoltaic solar module10.1016/j.enconman.2018.09.054 ↗
3. Solar cell parameters extraction based on single and double-diode models: a review10.1016/j.rser.2015.11.051 ↗
4. Improvement and validation of a model for photovoltaic array performance10.1016/j.solener.2005.06.010 ↗
5. Effect of temperature on ideality factor for PERC monofacial crystalline silicon solar module
6. Investigation on bifaciality factor and ideality factor of PERC bifacial solar module under different irradiances
7. Study of temperature coefficients for parameters of photovoltaic cells10.1155/2018/5945602 ↗
8. An experimental analysis of illumination intensity and temperature dependency of photovoltaic cell parameters10.1016/j.apenergy.2013.05.025 ↗
9. Accurate performance rating of photovoltaic modules under outdoor test conditions10.1016/j.solener.2018.12.002 ↗
10. Experimental analysis of the single diode model parameters dependence on irradiance and temperature10.1016/j.solener.2021.01.067 ↗
11. Temperature dependence of I–V characteristics and performance parameters of silicon solar cell10.1016/j.solmat.2008.07.010 ↗
12. Open circuit voltage temperature coefficients vs. concentration: theory, indoor measurements, and outdoor measurements10.1063/1.4753855 ↗
13. Measurement of temperature coefficient of photovoltaic modules in field and comparison with laboratory measurements
14. Temperature dependence of the limiting efficiency of bifacial silicon solar cells
15. Comparative study on fill factor of PERC Silicon Solar cells and Al-BSF Silicon solar cells under non-standard test conditions
16. On the temperature dependence of photovoltaic module electrical performance: a review of efficiency/power correlations10.1016/j.solener.2008.10.008 ↗
17. Potential-induced degradation: recombination behavior, temperature coefficients and mismatch losses in crystalline silicon photovoltaic power plant10.1016/j.solener.2019.06.023 ↗
18. Silicon solar cells with reduced temperature sensitivity10.1049/el:19820066 ↗
19. Comparison of the temperature coefficients of the basic I-V parameters for various types of solar cells
20. Reduced temperature coefficients for recent high‐performance silicon solar cells10.1002/pip.4670020305 ↗
21. On the variability of the temperature coefficients of mc-Si solar cells with irradiance10.1016/j.egypro.2016.07.002 ↗
22. Temperature dependence of photovoltaic cells, modules and systems
23. Assessment on the variation of temperature coefficients of photovoltaic modules with solar irradiance10.1016/j.solener.2022.08.052 ↗
24. Temperature coefficients and operating temperature verification for passivated emitter and rear cell bifacial silicon solar module10.1109/JPHOTOV.2020.2974289 ↗
25. Physics of the temperature coefficients of solar cells10.1016/j.solmat.2015.03.025 ↗
26. Theoretical temperature dependence of solar cell parameters10.1016/0379-6787(86)90020-7 ↗
27. Improvements and gaps in the empirical expressions for the fill factor of modern industrial solar cells
28. Temperature dependence of solar cell performance—an analysis10.1016/j.solmat.2012.02.019 ↗
29. Temperature-dependent modeling of silicon solar cells—eg, n i, recombination, and VOC10.1109/JPHOTOV.2017.2651822 ↗
30. Reduced temperature sensitivity of multicrystalline silicon solar cells with low ingot resistivity
31. Experimental assessment of temperature coefficient theories for silicon solar cells10.1109/JPHOTOV.2015.2489864 ↗
32. Voltage-dependent temperature coefficient of the I–V curves of crystalline silicon photovoltaic modules10.1109/JPHOTOV.2017.2766529 ↗
33. Investigation of temperature coefficients of PV modules through field measured data10.1016/j.solener.2021.06.013 ↗
34. Temperature coefficients of degraded crystalline silicon photovoltaic modules at outdoor conditions10.1002/pip.3396 ↗
35. Development status of high-efficiency HIT solar cells10.1016/j.solmat.2010.04.030 ↗
36. Obtaining a higher Voc in HIT cells10.1002/pip.646 ↗
37. Unraveling the passivation mechanisms of c-Si/SiOx/poly-Si contacts
38. Temperature-dependent performance of silicon solar cells with polysilicon passivating contacts
39. Temperature and illumination dependence of silicon heterojunction solar cells with a wide range of wafer resistivities10.1002/pip.3657 ↗
40. Amorphous/crystalline silicon interface passivation: ambient-temperature dependence and implications for solar cell performance10.1109/JPHOTOV.2015.2397602 ↗
41. Temperature dependence of amorphous/crystalline silicon heterojunction solar cells10.1143/JJAP.47.814 ↗
42. Temperature dependence of photoconversion efficiency in silicon heterojunction solar cells: theory vs experiment10.1063/1.4953384 ↗
43. Reassessment of silicon heterojunction cell performance under operating conditions
44. The impact of silicon solar cell architecture and cell interconnection on energy yield in hot & sunny climates10.1039/C7EE00286F ↗
45. Investigation on temperature coefficients of three types photovoltaic module technologies under Thailand operating condition10.1016/j.proeng.2012.01.1282 ↗
46. Temperature dependence measurements and performance analyses of high-efficiency interdigitated back-contact, passivated emitter and rear cell, and silicon heterojunction photovoltaic modules10.7567/JJAP.57.08RG18 ↗
47. Analysis of temperature coefficients of bifacial crystalline silicon PV modules10.1109/JPHOTOV.2018.2834625 ↗
48. Illumination-dependent temperature coefficients of the electrical parameters of modern silicon solar cell architectures10.1016/j.nanoen.2022.107221 ↗
49. 2009