Long-term durability of transparent backsheets for bifacial photovoltaics: An in-depth degradation analysis
Source abstract
Abstract
Bifacial modules with a glass/transparent backsheet (G/CB) structure offer many advantages, such as lighter weight, smaller heat capacity, and higher anti-soiling ability, over their glass/glass (G/G) counterparts. However, compared to traditional opaque backsheets, transparent backsheets can be more susceptible to degradation because UV light can more easily go through the transparent outer layer into the backsheet core and inner layers. Therefore, a better understanding of the degradation mechanism and long-term durability of emerging transparent backsheets is needed. In this study, the G/CB laminated coupons constructed with silica glass, polyolefin elastomer encapsulant (POE) and three types of fluoropolymer-based transparent backsheets were subjected to accelerated weathering under ultraviolet (UV) light at 65 °C and 50% relative humidity (RH) for up to 3600 h with additional 200 thermal cycles. The maximum UV dose (1800 MJ/m 2 ) is equivalent to approximately 45 years of field exposure in Arizona, assuming a 12% albedo for reflected light on the backside of a PV module. The transmittance of the coupons was characterized by UV–visible spectroscopy periodically during UV exposure. Cross-sectional characterization of optical, chemical, and mechanical degradation was conducted on the transparent backsheets of the aged and unaged coupons using confocal fluorescence microscopy, microscale infrared spectroscopy, and nanoindentation, respectively. Results showed that superficial outer layer cracking occurred on coupons constructed with a polyvinyl fluoride (PVF)-based backsheet (G/CB1) at the end of the exposure.Local delamination appeared near a corner of the coupon with a polyvinylidene fluoride (PVDF)-based backsheet (G/CB2). However, the coupon containing a fluoroethylene vinyl ether (FEVE)/polyethylene terephthalate (PET)/ethylene-vinyl acetate (EVA)-based transparent backsheet (G/CB3) showed the greatest yellowing, as well as substantial backsheet cracking. Significant degradation was not only observed on the FEVE outer layer but also in the PET core layer of CB3. The depth-dependent degradation was seen in fluorescence, micro-IR and nanoindentation mapping of the aged CB3. This study suggests that, although the application of transparent backsheet is promising, careful considerations of the long-term UV durability are needed when designing and selecting backsheets for 50-year bifacial modules.
Source: expertdata · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Structural Analysis of Composite Materials · Thermal Radiation and Cooling Technologies · Solar Thermal and Photovoltaic Systems
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (24)
Show source-provided references
1. Floating photovoltaics could mitigate climate change impacts on water body temperature and stratification10.1016/j.solener.2021.01.076 ↗
2. Hiroshi
3. Parameterizing mismatch loss in bifacial photovoltaic modules with global deployment: a comprehensive study10.1016/j.apenergy.2021.117636 ↗
4. The value of module efficiency in lowering the levelized cost of energy of photovoltaic systems10.1016/j.rser.2011.07.125 ↗
5. Performance of bifacial PV arrays with fixed tilt and horizontal single-Axis tracking: comparison of simulated and measured data10.1109/JPHOTOV.2019.2924394 ↗
6. Accuracy of simulated data for bifacial systems with varying tilt angles and share of diffuse radiation10.1016/j.solener.2019.12.071 ↗
7. Outdoor evaluation of power output improvement of the bifacial module
8. Energy yield measurement of an elevated PV system on a white flat roof and a performance comparison of monofacial and bifacial modules10.1016/j.renene.2021.02.015 ↗
9. Vertically mounted bifacial photovoltaic modules: a global analysis10.1016/j.energy.2013.08.040 ↗
10. Potential induced degradation of N-type bifacial silicon solar cells: an investigation based on electrical and optical measurements10.1016/j.solmat.2017.04.007 ↗
11. Glass/glass photovoltaic module reliability and degradation: a review10.1088/1361-6463/ac1462 ↗
12. Survey of mechanical durability of PV backsheets
13. Transparent backsheets for bifacial photovoltaic (PV) modules: material characterization and accelerated laboratory testing
14. Development of testing methods to predict cracking in photovoltaic backsheets
15. 2020
16. Delamination behaviour of multi-layer films for PV encapsulation10.1016/j.solmat.2005.02.009 ↗
17. Characterizing photovoltaic backsheet adhesion degradation using the wedge and single cantilever beam tests, Part I: field Modules10.1016/j.solmat.2020.110669 ↗
18. The investigation of argon plasma surface modification to polyethylene: quantitative ATR-FTIR spectroscopic analysis10.1016/j.eurpolymj.2006.01.007 ↗
19. Photo-oxidation of poly(ethylene terephthalate) films intended for photovoltaic backsheet10.1002/app.48623 ↗
20. Photochemical degradation of poly(ethylene terephthalate)-modified copolymer10.1016/S0032-3861(99)00580-7 ↗
21. Fluorescence imaging analysis of depth-dependent degradation in photovoltaic laminates: insights to the failure10.1002/pip.3212 ↗
22. Depth profiling of degradation of multilayer photovoltaic backsheets after accelerated laboratory weathering: cross-sectional Raman imaging10.1016/j.solmat.2015.09.021 ↗
23. Aspects of poly(ethylene terephthalate) degradation for archival life and environmental degradation10.1016/0141-3910(91)90047-U ↗
24. Ehrenstein · 2004