Comparative performance analysis of photo-supercapacitor based on silicon, dye-sensitized and perovskite solar cells: Towards indoor applications
Source abstract
Abstract
The rapid development of the Internet of Things (IoTs) demands self-powered indoor devices to supply continuous power. Thus, developing an efficient photo-storage device that is capable of harvesting and storing indoor light energy requires detailed performance analysis of suitable solar cells. Herein, a comparative study of the performance of photo-storage systems based on three different solar cell technologies in combination with symmetric non-volatile supercapacitors was performed. Considering the advantages of hybrid solar cells such as low-cost fabrication and high photovoltaic response under diffused light, perovskite solar cells (PSCs) and dye-sensitized solar cells (DSCs) were selected, and the photo-storage efficiencies were compared with crystalline silicon solar cells (crystalline Si–SCs) under outdoor (Xe light irradiation: 1–100 mW cm −2 ) and indoor white Light Emitting Diode (LED) (1–20 mW cm −2 ) illumination. Photovoltaic performance was compared using current-voltage (IV), maximum power point tracking (MPPT), and charging of supercapacitor, either directly or through a DC-DC converter. The highest efficiencies were observed with PSCs under low light intensity, using Xe light and white LED light conditions. Despite the anomalous hysteresis behavior, IV analysis of the PSCs showed efficiency above 12% under Xe light irradiation and above 20% using white LED lighting (extracted from the reverse scan and at light intensity intervals of 1–20 mW cm −2 ). The determination of real-time efficiencies at MPP for PSCs showed a temporary efficiency drop at each intensity under white LED light, which is more significant for longer illumination times. However, under low light-intensity, single PSCs showed only a slight average voltage drop of 800 to 700 mV in comparison with a considerable drop of 800 to 500 mV at MPP for two series-connected crystalline Si–SCs. In addition, single PSC was able to show better power delivery efficiencies (PDEs) and supply the required minimum operating voltage for the DC-DC boost converter at 1–20 mW cm −2 where two series solar cells are required for DSCs and crystalline Si–SCs. The overall efficiencies for the DC-DC boost converter charging dropped towards low intensities from 9 to 5% and 8.5 to 2.7% for PSCs and crystalline Si–SCs, respectively. This decrease was mainly due to the loss of converter efficiency at low input powers which could be negligible on large-scale solar cells. Furthermore, in direct charging, PSC provided over 8.5% stable overall efficiencies with about 80% storage efficiency under white LED light intensities ranging from 1 to 20 mW cm −2 at the areal discharge, and were able to maintain high overall peak efficiencies of 5.6 and 4.1% at high areal discharging currents of 18 and 30 mA cm −2 , respectively. This study demonstrates the suitability of photo-supercapacitor systems combining PSCs and carbon-based supercapacitors for continuous power-up of indoor high-current-requirement IoT devices.
Source: expertdata · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Perovskite Materials and Applications · Supercapacitor Materials and Fabrication · Advanced battery technologies research
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (35)
Show source-provided references
1. Perovskite indoor photovoltaics: opportunity and challenges10.1039/D1SC03251H ↗
2. HESS-based photovoltaic/batteries/supercapacitors: energy management strategy and DC bus voltage stabilization10.1016/j.solener.2021.01.048 ↗
3. Iodide electrolyte-based hybrid supercapacitor for compact photo-rechargeable energy storage system utilising silicon solar cells10.3390/en14092708 ↗
4. High-performance flexible energy storage and harvesting system for wearable electronics10.1038/srep26122 ↗
5. A new silicon p-n junction photocell for converting solar radiation into electrical power10.1142/9789814503464_0138 ↗
6. Solar cell efficiency tables (version 59)10.1002/pip.3506 ↗
7. Halide perovskite photovoltaics: background, status, and future prospects10.1021/acs.chemrev.8b00539 ↗
8. Perovskite solar cells with atomically coherent interlayers on SnO2 electrodes10.1038/s41586-021-03964-8 ↗
9. Perovskite photovoltaics for dim-light applications10.1002/adfm.201503448 ↗
10. Approaching high efficiency wide range silicon solar cells
11. Technology and market perspective for indoor photovoltaic cells10.1016/j.joule.2019.03.026 ↗
12. Integrating a photovoltaic storage system in one device: a critical review10.1002/pip.3093 ↗
13. Opportunities and challenges of lithium ion batteries in automotive applications10.1021/acsenergylett.0c02584 ↗
14. A portable and efficient solar-rechargeable battery with ultrafast photo-charge/discharge rate
15. Solar charging batteries: advances, challenges, and opportunities10.1016/j.joule.2018.04.006 ↗
16. A perspective of planar and flexible dual functioning devices
17. Supercapacitors: electrical characteristics, modeling, applications, and future trends10.1109/ACCESS.2019.2908558 ↗
18. Direct integration of a supercapacitor into the backside of a silicon photovoltaic device10.1063/1.4880211 ↗
19. An integrated device for both photoelectric conversion and energy storage based on free-standing and aligned carbon nanotube film10.1039/C2TA00113F ↗
20. High-efficiency monolithic photosupercapacitors: smart integration of a perovskite solar cell with a mesoporous carbon double-layer capacitor10.1002/solr.202100662 ↗
21. Integrated perovskite solar capacitors with high energy conversion efficiency and fast photo-charging rate10.1039/C7TA09099D ↗
22. Indoor light recycling: a new home for organic photovoltaics10.1039/C6TC03344J ↗
23. https://waf-e.dubudisk.com/anysolar.dubuplus.com/techsupport@anysolar.biz/O18Ae08/DubuDisk/www/Gen3/KXOB2514X1F%20DATA%20SHEET%20202007.pdf%60.
24. Hysteresis-free perovskite solar cells made of potassium-doped organometal halide perovskite10.1038/s41598-017-12436-x ↗
25. Graphite-type activated carbon from coconut shell: a natural source for eco-friendly non-volatile storage devices10.1039/D0RA09182K ↗
26. Theoretical analysis and characterization of the energy conversion and storage efficiency of photo-supercapacitors10.1016/j.solmat.2017.07.034 ↗
27. Characteristics of perovskite solar cells under low-illuminance conditions10.1021/acs.jpcc.6b05298 ↗
28. Incident angle and light intensity variation: a comparative impact study on perovskite, dye-sensitized and silicon heterojunction solar cells towards building-integrated applications10.1016/j.solmat.2018.11.020 ↗
29. Origin of the hysteresis in I–V curves for planar structure perovskite solar cells rationalized with a surface boundary-induced capacitance model10.1246/cl.150933 ↗
30. Determination of unique power conversion efficiency of solar cell showing hysteresis in the IV curve under various light intensities10.1038/s41598-017-10953-3 ↗
31. Light-induced performance increase of carbon-based perovskite solar module for 20-year stability10.1016/j.xcrp.2021.100648 ↗
32. The effect of temperature on the performance of dye-sensitized solar cells based on a propyl-methyl-imidazolium iodide electrolyte10.1016/j.solmat.2007.02.001 ↗
33. Hill climbing hysteresis of perovskite-based solar cells: a maximum power point tracking investigation10.1002/pip.2894 ↗
34. Highly efficient DC-DC boost converter implemented with improved MPPT algorithm for utility level photovoltaic applications10.1016/j.asej.2021.10.012 ↗
35. Recent research advances of self-discharge in supercapacitors: mechanisms and suppressing strategies10.1016/j.jechem.2020.09.041 ↗