Influence of surface structure of n-type single-crystalline Si solar cells on potential-induced degradation
Source abstract
Abstract
Abstract Potential-induced degradation (PID) in photovoltaic (PV) modules based on n-type single-crystalline Si solar cells (a bifacial cell, interdigitated back contact cells, and a hetero junction (HJ) cell) was experimentally investigated by applying high voltages to the modules. The power output of a PV module with an n-type bifacial-front junction (FJ) Si solar cell decreased by about 17% by applying −1000 V at 85 °C for 10 min, whereas no degradation was observed by applying +1000 V at 85 °C for 10 min. The spectrum of external quantum efficiency and transient absorption kinetics of the module after PID tests indicated that surface charge recombination between electron and hole on the Si cell was enhanced. PID in n-type Si PV modules can be approximately explained by surface polarization enhancing front surface recombination on Si cells, which corresponds to a loss of passivation effect by a silicon nitride (SiN x ) layer. On the other hand, no PID was observed in a PV module with an n-type bifacial-rear junction (RJ) Si solar cell and a commercial PV module based on an HJ cell by applying both positive and negative voltages. High conductive layers of transparent conductive oxide (TCO) on the top of HJ Si solar cells would significantly effective to suppress PID in n-type Si PV modules.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Silicon and Solar Cell Technologies · Photovoltaic System Optimization Techniques · Thin-Film Transistor Technologies
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (36)
Show source-provided references
1. S. Pingel, O. Frank, M. Winkler, S. Daryan, T. Geipel, H. Hoehne, J. Berghold, Potential induced degradation of solar cells and panels, in: Proceedings of the 35th IEEE Photovoltaic Specialists Conference (IEEE PVSC), Honolulu, HI, USA, 2010, pp. 2817–2822.10.1109/PVSC.2010.5616823 ↗
2. P. Hacke, M. Kempe, K. Terwilliger, S. Glick, N. Call, S. Johnston, S. Kurtz, I. Bennett, M. Kloos, Characterization of multicrystalline silicon modules with system bias voltage applied in damp heat, in: Proceedings of the 25th European Photovoltaic Solar Energy Conference and Exhibition (EU PVSEC) and 5th World Conference on Photovoltaic Energy Conversion (WCPEC), Valencia, Spain, 2010, pp. 3760–3765.
3. P. Hacke, K. Terwilliger, R. Smith, S. Glick, J. Pankow, M. Kempe, S. Kurtz, I. Bennett, M. Kroos, System voltage potential-induced degradation mechanisms in PV modules and methods for test, in: Proceedings of the 37th IEEE PVSC, Seattle, WA, USA, 2011, pp. 814–820.10.1109/PVSC.2011.6186079 ↗
4. P. Saint-Cast, H. Nagel, D. Wagenmann, J. Schön, P. Schmitt, C. Reichel, S.W. Glunz, M. Hofmann, J. Rentsch, R. Preu, Potential-induced degradation on cell level: the inversion model, in: Proceedings of the 28th EU PVSEC, Paris, France, 2013, pp. 789–792.
5. M. Schütze, M. Junghänel, O. Friedrichs, R. Wichtendahl, M. Scherff, J. Müller, P. Wawer, Investigations of potential induced degradation of silicon photovoltaic modules, in: Proceedings of the 26th EU PVSEC, Hamburg, Germany, 2011, pp. 3097–3102.10.1109/PVSC.2011.6186080 ↗
6. H. Nagel, A. Metz, K. Wangemann, Crystalline Si solar cells and modules featuring excellent stability against potential-induced degradation, in: Proceedings of the 26th EU PVSEC, Hamburg, Germany, 2011, pp. 3107–3112.
7. A. Raykov, H. Hahn, K.-.H. Stegemann, M. Kutzer, O. Storbeck, H. Neuhaus, W. Bergholz, Towards a root cause model for potential-induced degradation in crystalline silicon photovoltaic cells and modules, in: Proceedings of the 28th EU PVSEC, Paris, France, 2013, pp. 2998–3002.
8. M. Martin, R. Krause, H. Eckert, M. Pfeifer, D. Kohake, Investigation of potential induced degradation for various module manufactures and technologies, in: Proceedings of the 27th EU PVSEC, Frankfurt, Germany, 2012, pp. 3394–3398.
9. On the mechanism of potential-induced degradation in crystalline silicon solar cells10.1002/pssr.201206276 ↗
10. Micro structural root cause analysis of potential induced degradation in c-Si solar cells10.1016/j.egypro.2012.07.020 ↗
11. Microstructural analysis of crystal defects leading to potential-induced degradation (PID) of Si solar cells10.1016/j.egypro.2013.05.042 ↗
12. The role of stacking faults for the formation of shunts during potential-induced degradation of crystalline Si solar cells10.1002/pssr.201307090 ↗
13. Potential-induced degradation (PID): introduction of a novel test approach and explanation of increased depletion region recombination10.1109/JPHOTOV.2014.2300238 ↗
14. Explanation of potential-induced degradation of the shunting type by Na decoration of stacking faults in Si solar cells10.1016/j.solmat.2013.06.015 ↗
15. Sodium decoration of PID-s crystal defects after corona induced degradation of bare silicon solar cells10.1016/j.egypro.2015.07.055 ↗
16. High voltage stress impact on p type crystalline silicon PV module10.4236/epe.2013.57049 ↗
17. Effect of humidity and temperature on the potential-induced degradation10.1002/pip.2238 ↗
18. M. Kambe, K. Hara, K. Mitarai, S. Takeda, M. Fukawa, N. Ishimaru, M. Kondo, PID-free c-Si PV module using aluminosilicate chemically strengthened glass, in: Proceedings of the 28th EU PVSEC, Paris, France, 2013, pp. 2861–2864.
19. Investigation on antireflection coating for high resistance to potential-induced degradation10.7567/JJAP.53.03CE01 ↗
20. Plasma-enhanced chemical-vapor deposition of silicon nitride film for high resistance to potential-induced degradation10.7567/JJAP.54.08KD12 ↗
21. Crystalline Si photovoltaic modules based on TiO2-coated cover glass against potential-induced degradation10.1039/C4RA06791F ↗
22. Crystalline Si photovoltaic modules functionalized by a thin polyethylene film against potential and damp-heat-induced degradation10.1039/C4RA13360A ↗
23. Relationship between cross-linking conditions of ethylene vinyl acetate and potential induced degradation for crystalline silicon photovoltaic modules10.7567/JJAP.54.08KG01 ↗
24. R. Swanson, M. Cudzinovic, D. DeCeuster, V. Desai, J. Jürgens, N. Kaminar, W. Mulligan, L. Rodrigues-Barbosa, D. Rose, D. Smith, A. Terao, K. Wilson, The surface polarization effect in high-efficiency silicon solar cells, in: Technical Digests of the 15th International Photovoltaic Science & Engineering Conference (PVSEC-15), Shanghai, China, 2005, pp. 410–411.
25. Potential-induced degradation at interdigitated back contact solar cells10.1016/j.egypro.2014.08.015 ↗
26. Potential-induced degradation for encapsulated n-type IBC solar cells with front floating emitter10.1016/j.egypro.2015.07.050 ↗
27. Potential-induced degradation in photovoltaic modules based on n-type single crystalline Si solar cells10.1016/j.solmat.2015.04.037 ↗
28. Development of a femtosecond diffuse reflectance spectroscopic system, evaluation of its temporal resolution, and applications to organic powder systems10.1063/1.1148668 ↗
29. Charge carrier dynamics of standard TiO2 catalysts revealed by femtosecond diffuse reflectance spectroscopy10.1021/jp984162h ↗
30. Changes in the current density–voltage and external quantum efficiency characteristics of n-type single-crystalline silicon photovoltaic modules with a rear-side emitter undergoing potential-induced degradation10.1016/j.solmat.2016.03.003 ↗
31. S. Pingel, S. Janke, O. Frank, Recovery methods for modules affected by potential induced degradation (PID), in: Proceedings of the 27th EU PVSEC, Frankfurt, Germany, 2012, pp. 3379–3383.
32. Determination of front surface recombination velocity of silicon solar cells using the short-wavelength spectral response10.1016/j.solmat.2007.04.018 ↗
33. Potential-induced degradation of Cu(In,Ga)Se2 photovoltaic modules10.7567/JJAP.54.08KC13 ↗
34. J. Kapur, A. Bennett, J. Norwood, B. Hamzavytehrany, I. Kueppenbender, Tailoring ionomer encapsulants as low cost solution to potential induced degradation, in: Proceedings of the 28th EU PVSEC, Paris, France, 2013, pp. 476–479.
35. S.-.H. Schulze, A. Apel, R. Meitzner, M. Schak, C. Ehrich, J. Schneider, Influence of polymer properties on potential induced degradation of PV-modules, in: Proceedings of the 28th EU PVSEC, Paris, France, 2013, pp. 503–507.
36. C.G. Reid, S.A. Ferrigan, J.I.F. Martinez, J.T. Woods, Contribution of PV encapsulant composition to reduction of potential induced degradation (PID) of crystalline silicon PV cells, in: Proceedings of the 28th EU PVSEC, Paris, France, 2013, pp. 3340–3346.