journal article·2011-12

Solvent additives for tuning the photovoltaic properties of polymer–fullerene solar cells

Antonietta De Sio, Thomas Madena, Ralph Huber, Jürgen Parisi, Shany Neyshtadt, Felix Deschler, Enrico Da Como, Salvatore Esposito, Elizabeth von Hauff

Publisher page

Abstract

Abstract We use solvent additives as a simple method to tune the photovoltaic performance of poly-3-hexylthiophene (P3HT) and [6,6]-phenyl-C61-butyric acid methyl ester (PCBM) bulk heterojuncton solar cells. 1,2-dichlorobenzene (oDCB) was used as the reference solvent; chlorobenzene (CB) and 1,2,3,4-tetrahydronaphthalene (THN) were used as additives to influence film formation. An increase in the short circuit current and the power conversion efficiency of solar cells with blends cast from mixed solvents was observed. Blends prepared with THN, the highest boiling point solvent, resulted in the best device performance, while blends prepared with the pure reference solvent resulted in the lowest photocurrent. In-plane investigations of the morphology using transmission electron microscopy (TEM) revealed improved phase segregation for blends prepared with mixed solvents, and increased crystallinity in the P3HT phase is demonstrated using atomic force microscopy (AFM) coupled with Kelvin probe force microscopy (KPFM). Optical modeling reveals that the increase in the photocurrent is not due to changes in the optical properties of the blends. Electrical characterization reveals that the electron mobilities decrease slightly in blends cast from mixed solvents, corresponding to a decrease in the fill factor and an increase in P3HT crystallinity observed at the surface of the blend. The increase in the photovoltaic performance is discussed in terms of increased charge separation at the donor–acceptor interface due to increased ordering in the P3HT phase induced by the solvent additives.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Organic Electronics and Photovoltaics · Conducting polymers and applications · Thin-Film Transistor Technologies

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (52)

Show source-provided references
1. Roll-to-Roll Processing of Thin-Film Organic Semiconductors
2. Polymer photovoltaic cell: enhanced efficiencies via a network of internal donor–acceptor heterojunctions10.1126/science.270.5243.1789 ↗
3. 6.5% efficiency of polymer solar cells based on poly(3-hexylthiophene) and indene-C 60 bisadduct by device optimization10.1002/adma.201001339 ↗
4. Polymer solar cells with enhanced open-circuit voltage and efficiency10.1038/nphoton.2009.192 ↗
5. For the bright future-bulk heterojunction polymer solar cells with power conversion efficiency of 7.4%10.1002/adma.200903528 ↗
6. Charge transfer excitons in polymer–fullerene blends: the role of morphology and polymer chain conformation10.1002/adfm.200901398 ↗
7. Charge photogeneration in organic solar cells10.1021/cr900271s ↗
8. Relating the morphology of poly(p-phenylene vinylene)/methanofullerene blends to solar cell performance10.1002/adfm.200305049 ↗
9. 2.5% efficient organic solar cells10.1063/1.1345834 ↗
10. Efficiency limiting morphological factors of MDMO-PPV:PCBM plastic solar cells10.1016/j.tsf.2005.12.071 ↗
11. Effects of postproduction treatment on plastic solar cells10.1002/adfm.200390011 ↗
12. A strong regioregularity effect in self-organizing conjugated polymer films and high-efficiency polythiophene:fullerene solar cells10.1038/nmat1574 ↗
13. Influence of solvent mixing on the morphology and performance of solar cells based on polyfluorene copolymer/fullerene blends10.1002/adfm.200500339 ↗
14. Recent progress in polymer solar cells: manipulation of polymer:fullerene morphology and the formation of efficient inverted polymer solar cells10.1002/adma.200802854 ↗
15. Solvent mixtures for improving device efficiency of polymer photovoltaic devices10.1063/1.2898153 ↗
16. Effects of fullerene solubility on the crystallization of poly(3-hexylthiophene) and performance of photovoltaic devices10.1016/j.orgel.2009.07.016 ↗
17. Improved performance of polymer bulk heterojunction solar cells through the reduction of phase separation via solvent additives10.1002/adma.200903677 ↗
18. Method for increasing the photoconductive response in conjugated polymer–fullerene composites10.1063/1.2408661 ↗
19. Efficiency enhancement in low-bandgap polymer solar cells by processing with alkane dithiols10.1038/nmat1928 ↗
20. Processing additives for improved efficiency from bulk heterojunction solar cells10.1021/ja710079w ↗
21. Substituting the postproduction treatment for bulk-heterojunction solar cells using chemical additives10.1016/j.orgel.2008.05.021 ↗
22. Controlling Morphology in Polymer–Fullerene Mixtures10.1002/adma.200701519 ↗
23. Morphology and growth kinetics in poly(butylene terephthalate)/polyarylates based on bisphenol A isophthalate10.1002/1521-3935(20020101)203:2<294::AID-MACP294>3.0.CO;2-# ↗
24. Crystallization and melting behavior of poly(ether ether ketone)/poly(aryl ether sulfone) blends10.1002/app.13012 ↗
25. Three-dimensional nanoscale organization of bulk heterojunction polymer solar cells10.1021/nl8014022 ↗
26. The relation between open-circuit voltage and the onset of photocurrent generation by charge-transfer absorption in polymer–fullerene bulk heterojunction solar cells10.1002/adfm.200800056 ↗
27. Nanoscale morphology of high-performance polymer solar cells10.1021/nl048120i ↗
28. High-efficiency solution processable polymer photovoltaic cells by self-organization of polymer blends10.1038/nmat1500 ↗
29. Effects of solvent mixtures on the nanoscale phase separation in polymer solar cells10.1002/adfm.200701459 ↗
30. Kelvin probe force microscopy study of conjugated polymer/fullerene organic solar cells10.1143/JJAP.44.5370 ↗
31. Scanning kelvin probe microscopy on bulk heterojunction polymer blends10.1002/adfm.200801283 ↗
32. Imaging the carrier photogeneration in nanoscale phase segregated organic heterojunctions by kelvin probe force microscopy10.1021/nl101001d ↗
33. Morphology evolution via self-organization and lateral and vertical diffusion in polymer–fullerene solar cell blends10.1038/nmat2102 ↗
34. Structural complexities in the active layers of organic electronics10.1146/annurev-chembioeng-073009-100851 ↗
35. Improving the reproducibility of P3HT:PCBM solar cells by controlling the PCBM/cathode interface10.1021/jp9082163 ↗
36. Charge transport and recombination in bulk heterojunction solar cells studied by the photoinduced charge extraction in lineary increasing voltage technique10.1063/1.1882753 ↗
37. New method of drift mobility evaluation in μc-Si:H, basic idea and comparison with time-of-flight
38. Charge carrier mobility in regioregular poly(3-hexylthiophene) probed by transient conductivity techniques: a comparative study
39. A review of charge transport and recombination in polymer/fullerene organic solar cells10.1002/pip.791 ↗
40. Charge carrier extraction by linearly increasing voltage: analytic framework and ambipolar transients10.1063/1.3516392 ↗
41. Influence of Co-solvents on the performance of polymer/polymer solar cells10.1166/jno.2010.1086 ↗
42. Effect of interchain interactions on the absorption and emission of poly(3-hexylthiophene)10.1103/PhysRevB.67.064203 ↗
43. Effect of annealing of poly(3-hexylthiophene)/fullerene bulk heterojunction composites on structural and optical properties10.1016/j.tsf.2005.09.093 ↗
44. An interior, trust region approach for nonlinear minimization subject to bounds10.1137/0806023 ↗
45. On the convergence of reflective Newton methods for large scale nonlinear minimization subject to bounds10.1007/BF01582221 ↗
46. Blanc · Comptes Rendus De L Academie Des Sciences Paris · 1967 · 264B · 634
47. Blanc · Comptes Rendus De L Academie Des Sciences · 1967 · 265B · 1044
48. Optical Constants of Metals
49. Heavens · 1991
50. Compositional and electric field dependence of the dissociation of charge transfer excitons in alternating polyfluorene copolymer/fullerene blends10.1021/ja8012598 ↗
51. Correlation between charge transfer, exciton recombination and photocurrent in polymer–fullerene solar cells10.1063/1.3462298 ↗
52. Self-organized buffer layers in organic solar cells10.1002/adma.200792876 ↗