Effects on amorphous silicon photovoltaic performance from high-temperature annealing pulses in photovoltaic thermal hybrid devices
Source abstract
Abstract
There is a renewed interest in photovoltaic solar thermal (PVT) hybrid systems, which harvest solar energy for heat and electricity. Typically, a main focus of a PVT system is to cool the photovoltaic (PV) cells to improve the electrical performance, however, this causes the thermal component to under-perform compared to a solar thermal collector. The low temperature coefficients of amorphous silicon (a-Si:H) allow for the PV cells to be operated at higher temperatures and are a potential candidate for a more symbiotic PVT system. The fundamental challenge of a-Si:H PV is light-induced degradation known as the Staebler-Wronski effect (SWE). Fortunately, SWE is reversible and the a-Si:H PV efficiency can be returned to its initial state if the cell is annealed. Thus an opportunity exists to deposit a-Si:H directly on the solar thermal absorber plate where the cells could reach the high temperatures required for annealing. In this study, this opportunity is explored experimentally. First a-Si:H PV cells were annealed for 1 hour at 100\degreeC on a 12 hour cycle and for the remaining time the cells were degraded at 50\degreeC in order to simulate stagnation of a PVT system for 1 hour once a day. It was found that, when comparing the cells after stabilization at normal 50\degreeC degradation, this annealing sequence resulted in a 10.6% energy gain when compared to a cell that was only degraded at 50\degreeC.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Photovoltaic System Optimization Techniques · Solar Thermal and Photovoltaic Systems · solar cell performance optimization
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (37)
Show source-provided references
1. M.J.M. Pathak, J.M. Pearce, S.J. Harrison, Optimizing for solar energy applications with limited solar roof access: exergy analysis of solar thermal, photovoltaic, and hybrid photovoltaic thermal systems, to be published
2. Energy, exergy, and second law performance criteria
3. Performance and costs of a roof-sized PV/thermal array combined with a ground coupled heat pump10.1016/j.solener.2004.09.019 ↗
4. PV thermal systems: PV panels supplying renewable electricity and heat10.1002/pip.559 ↗
5. Energy, cost and LCA results of PV and hybrid PV/T solar systems10.1002/pip.590 ↗
6. Flat-plate PV-thermal collectors and systems: a review10.1016/j.rser.2005.12.012 ↗
7. A review on photovoltaic/thermal hybrid solar technology10.1016/j.apenergy.2009.06.037 ↗
8. R. Platz, D. Fischer, M.A. Zufferey, J.A.A. Selvan, A. Haller, A. Shah, Hybrid collectors using thin-film technology, in: 26th IEEE Photovoltaic Specialists Conference Proceedings, 1997, pp. 1293–1296.10.1109/PVSC.1997.654325 ↗
9. Energy performance of water hybrid PV/T collectors applied to combisystems of direct solar floor type10.1016/j.solener.2006.11.017 ↗
10. The yield of different combined PV-thermal collector designs10.1016/S0038-092X(03)00121-X ↗
11. P. Wormser, S. Strong, Evaluation of the potential for use of new thin film photovoltaic materials as selective surfaces for solar thermal absorbers in flat-plate combined photovoltaic/thermal collectors, ASHRAE Final Report #1109-RP, 2006, pp. 1–23.
12. E. Schweizer, A.G. Enecolo, LESO-PB, New generation of hybrid solar PV/T collectors. Final Report DIS 56360/16868, 2000, pp. 1–55.
13. Reversible conductivity changes in discharge-produced amorphous Si10.1063/1.89674 ↗
14. Development in understanding and controlling the Staebler–Wronski Effect in a-Si:H10.1146/annurev.matsci.31.1.47 ↗
15. Intrinsic and light induced gap states in a-Si:H materials and solar cells—effects of microstructure10.1016/j.tsf.2003.10.129 ↗
16. J. Deng, M.L. Albert, J.M. Pearce, R.W. Collins, C.R. Wronski, The nature of native and light induced defect states in i-layers of high quality a-Si:H solar cells derived from dark forward bias current–voltage characteristics, Materials Research Society Symposium Proceedings 862 (2005) A11.4, doi:10.1557/PROC-862-A11.410.1557/PROC-862-A11.4 ↗
17. Modeling of light-induced degradation of amorphous silicon solar cells10.1016/j.solmat.2007.08.010 ↗
18. C.R. Wronski, J.M. Pearce, R.J. Koval, X. Niu, A.S. Ferlauto, J. Koh, R.W. Collins, Light induced defect creation kinetics in thin film protocrystalline silicon materials and their solar cells, Materials Research Society Symposium Proceedings 715 (2002) A13.4.1–A13.4.12.
19. M.J.M. Pathak, K. Girotra, S.J. Harrison, J.M. Pearce, The effect of hybrid photovoltaic thermal device operating conditions on intrinsic layer thickness optimization of hydrogenated amorphous silicon solar cells, to be published.
20. J.M. Pearce, J. Deng, M.L. Albert, C.R. Wronski, R.W. Collins, Room temperature annealing of fast states from 1 sun illumination in protocrystalline Si:H materials and solar cells, in: 31st IEEE Photovoltaic Specialists Conference Proceedings (2005) 1536–1539.
21. Light-induced recovery of a-Si solar cells10.1016/0927-0248(94)90072-8 ↗
22. M.L. Albert, J. Deng, X..Niu, J.M. Pearce, R.W. Collins, C.R. Wronski, The creation and relaxation kinetics of light induced defects in a-Si:H located at different energies in the gap, Materials Research Society Symposium Proceedings 862 (2005) A13.2, doi:10.1557/PROC-862-A13.210.1557/PROC-862-A13.2 ↗
23. I. Pola, D. Chianese, L. Fanni, R. Radel, Analysis of annealing and degradation effects on a-Si modules Source; in: Proceedings of the 23rd European Photovoltaic Solar Energy Conference and Exhibition, 1–5 September 2008, Valencia, Spain, pp. 2301–2304.
24. Intrinsic and light induced gap states in a-Si:H materials and solar cells—effects of microstructure10.1016/j.tsf.2003.10.129 ↗
25. Light induced defect states in hydrogenated amorphous silicon centered around 1.05 and 1.2eV from the conduction band edge10.1063/1.1624637 ↗
26. J. Pearce, X. Niu, R. Koval, G. Ganguly, D. Carlson, R.W. Collins, C.R. Wronski, Contributions of DO and non-DO gap states to the kinetics of light induced degradation of amorphous silicon under 1 sun illumination, Materials Research Society Symposium Proceedings 664 (2001) A12.3, doi:10.1557/PROC-664-A12.310.1557/PROC-664-A12.3 ↗
27. R. Ruther, G. T-Mani, J. del Cueto, J. Adelstein, M.M. Dacoregio, B. von Roedern, Performance test of amorphous silicon modules in different climates—year three: higher minimum operating temperatures lead to higher performance levels, in: 31st IEEE Photovoltaic Specialists Conference Proceedings, 2005, pp. 1635–1638.10.1109/PVSC.2005.1488459 ↗
28. The potential of solar industrial process heat applications10.1016/S0306-2619(02)00176-9 ↗
29. P. Mahtani, N.P. Kherani, S. Zukotynski, The use of amorphous silicon in fabricating a photovoltaic-thermal system, in: Proceedings of the second Canadian Solar Buildings Conference, 2007, pp. 1–4
30. Industrial application of PV/T solar energy systems10.1016/j.applthermaleng.2006.11.003 ↗
31. D.L. King, J.A. Kratochvil, W.E. Boyson, Temperature coefficients for PV modules and arrays: measurement methods, difficulties, and results, in: 26th IEEE Photovoltaic Specialists Conference Proceedings, 1997, pp. 1183–1186.10.1109/PVSC.1997.654300 ↗
32. Thickness dependence of light induced degradation in a-Si:H solar cells10.1016/S0022-3093(05)80336-9 ↗
33. Development in understanding and controlling the Staebler–Wronski Effect in a-Si:H10.1146/annurev.matsci.31.1.47 ↗
34. A review of solar photovoltaic levelized cost of electricity10.1016/j.rser.2011.07.104 ↗
35. The influence of operation temperature on the output properties of amorphous silicon-related solar cells10.1016/j.solmat.2004.04.016 ↗
36. Ontario Fit Program, 〈http://fit.energyauthority.on.ca/quick-facts-table-0〉, 2010.
37. Ontario Energy Board, 〈http://www.ontarioenergyboard.ca/OEB/Consumers/Electricity/Electricity+Prices〉, 2008