Performance enhancement of a photovoltaic module using phase change material nanoemulsion as a novel cooling fluid
Source abstract
Abstract
Abstract Maintaining a suitable temperature for the photovoltaic (PV) module is of great significance but a challenge. Herein, a low-supercooling phase change material (PCM) nanoemulsion was developed as a promising coolant for use in the PV module thermal management system. OP35E was used as the paraffinic PCM and the phase change characteristics and thermophysical properties of the as-prepared PCM nanoemulsions were investigated. It is shown that OP35E-nanoemulsions possess a melting point of roughly 34 °C and ignorable supercooling. The apparent specific heats of low-supercooling OP35E-nanoemulsions are 2.29–3.29 times that of water at the phase transition range, and its viscosities is slightly higher than that of water. Furthermore, the thermal management performance of water and OP35E-nanoemulsions on PV modules was evaluated. Compared with water, the PV module temperature further reduced by 5.3% when employing 20 wt% OP35E-nanoemulsion. More importantly, using 10 wt% and 20 wt% OP35E-nanoemulsions only required less than 50% of the pumping power consumption of the water-cooling system to reduce the PV module temperature to the same. On the contrary, owing to the lower apparent specific heat caused by the futile latent heat, the OP35E-nanoemulsion with large supercooling exhibited the worst thermal management performance with the highest PV module temperature and pumping power consumption, and lowest output power. Therefore, the outstanding characteristics and better cooling performance than water of the low-supercooling nanoemulsions make them show great potential in the PV module thermal management system as a novel kind of heat transfer fluids with improved specific heat.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Solar Thermal and Photovoltaic Systems · Phase Change Materials Research · Photovoltaic System Optimization Techniques
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (39)
Show source-provided references
1. Recent advancements in PV cooling and efficiency enhancement integrating phase change materials based systems – a comprehensive review10.1016/j.solener.2019.11.075 ↗
2. A year-round study of a photovoltaic thermal system integrated with phase change material in Shanghai using transient model10.1016/j.enconman.2020.112657 ↗
3. Using phase change materials in photovoltaic systems for thermal regulation and electrical efficiency improvement: a review and outlook10.1016/j.rser.2014.12.003 ↗
4. Numerical and experimental study on temperature control of solar panels with form-stable paraffin/expanded graphite composite PCM10.1016/j.enconman.2017.07.046 ↗
5. A review on photovoltaic/thermal hybrid solar technology10.1016/j.apenergy.2009.06.037 ↗
6. Review of photovoltaic module cooling methods and performance evaluation of the radiative cooling method10.1016/j.rser.2018.12.051 ↗
7. Heat transfer characteristics and performance evaluation of water-cooled PV/T system with cooling channel above PV panel10.1016/j.renene.2018.03.023 ↗
8. Performance enhancement of a building-integrated photovoltaic module using phase change material10.1016/j.energy.2017.10.090 ↗
9. Thermal management and uniform temperature regulation of photovoltaic modules using hybrid phase change materials-nanofluids system10.1016/j.renene.2019.05.130 ↗
10. Phase change materials and nano-enhanced phase change materials for thermal energy storage in photovoltaic thermal systems: a futuristic approach and its technical challenges10.1016/j.rser.2020.110341 ↗
11. Experimental investigation of solar photovoltaic panel integrated with phase change material and multiple conductivity-enhancing-containers10.1016/j.energy.2020.118047 ↗
12. A review on recent advancements in photovoltaic thermal techniques10.1016/j.rser.2017.03.075 ↗
13. Water/MWCNT nanofluid based cooling system of PVT: experimental and numerical research10.1016/j.renene.2018.01.014 ↗
14. Exergetic advancement of photovoltaic/thermal systems (PV/T): a review10.1016/j.rser.2018.08.053 ↗
15. Experimental effect of high mass flow rate and volume cooling on performance of a water-type PV/T collector10.1016/j.solener.2019.07.024 ↗
16. Photovoltaic thermal collectors: experimental analysis and simulation model of an innovative low-cost water-based prototype10.1016/j.energy.2019.04.140 ↗
17. Improving photovoltaics efficiency by water cooling: modelling and experimental approach10.1016/j.energy.2017.04.164 ↗
18. Application of nanofluids and fluids in photovoltaic thermal system: an updated review10.1016/j.solener.2020.01.015 ↗
19. Theoretical investigation of the energy performance of a novel MPCM (Microencapsulated Phase Change Material) slurry based PV/T module10.1016/j.energy.2015.05.040 ↗
20. Experimental study of using both ZnO/water nanofluid and phase change material (PCM) in photovoltaic thermal systems10.1016/j.solmat.2016.11.032 ↗
21. Nanofluid based photovoltaic thermal systems integrated with phase change materials: numerical simulation and thermodynamic analysis10.1016/j.enconman.2019.112384 ↗
22. Experimental investigation of the energy performance of a novel Micro-encapsulated Phase Change Material (MPCM) slurry based PV/T system10.1016/j.apenergy.2015.11.053 ↗
23. Performance evaluation of a novel solar photovoltaic–thermal collector with dual channel using microencapsulated phase change slurry as cooling fluid10.1016/j.enconman.2017.04.089 ↗
24. Numerical study of a novel miniature compound parabolic concentrating photovoltaic/thermal collector with microencapsulated phase change slurry10.1016/j.enconman.2017.10.005 ↗
25. Numerical study on energy and exergy performances of a microencapsulated phase change material slurry based photovoltaic/thermal module10.1016/j.enconman.2019.01.029 ↗
26. Exergy and energy analysis of wavy tubes photovoltaic-thermal systems using microencapsulated PCM nano-slurry coolant fluid10.1016/j.apenergy.2020.114849 ↗
27. A comprehensive review on phase change material emulsions: fabrication, characteristics, and heat transfer performance10.1016/j.solmat.2018.11.016 ↗
28. Review of phase change emulsions (PCMEs) and their applications in HVAC systems10.1016/j.enbuild.2015.03.003 ↗
29. Tadros · 2006
30. Flow and heat transfer characteristics of phase change emulsions in a circular tube: Part 1. Laminar flow10.1016/j.ijheatmasstransfer.2017.10.055 ↗
31. Flow and heat transfer characteristics of phase change emulsions in a circular tube: Part 2. Turbulent flow10.1016/j.ijheatmasstransfer.2017.10.052 ↗
32. Preparation and characterization of nano-sized phase change emulsions as thermal energy storage and transport media10.1016/j.apenergy.2017.01.012 ↗
33. Thermophysical properties of phase change emulsions prepared by D-phase emulsification10.1016/j.enconman.2016.05.065 ↗
34. Paraffin wax–water nanoemulsion: a superior thermal energy storage medium providing higher rate of thermal energy storage per unit heat exchanger volume than water and paraffin wax10.1016/j.enconman.2018.01.073 ↗
35. Fabrication of a novel nano phase change material emulsion with low supercooling and enhanced thermal conductivity10.1016/j.renene.2019.11.044 ↗
36. Subcooling in PCM emulsions – Part 2: interpretation in terms of nucleation theory10.1016/j.tca.2011.04.027 ↗
37. Synthesis and characterization of a narrow size distribution nano phase change material emulsion for thermal energy storage10.1016/j.solener.2017.03.056 ↗
38. Review of the T -history method to determine thermophysical properties of phase change materials (PCM)10.1016/j.rser.2013.05.066 ↗
39. Rheological and energy transport characteristics of a phase change material slurry10.1016/j.energy.2016.03.025 ↗