journal article·2020-06Open access

Sputtered indium tin oxide as a recombination layer formed on the tunnel oxide/poly-Si passivating contact enabling the potential of efficient monolithic perovskite/Si tandem solar cells

Woojun Yoon, David Scheiman, Young-Woo Ok, Zhaoning Song, Cong Chen, Glenn Jernigan, Ajeet Rohatgi, Yanfa Yan, Phillip Jenkins

Abstract

Abstract We focus on utilizing sputtered indium tin oxide (ITO) as a recombination layer, having low junction damage to an n-type silicon solar cell with a front-side tunnel oxide passivating electron contact, thereby enabling the development of a high efficiency monolithic perovskite/Si tandem device. High transparency and low resistivity ITO films are deposited via low power DC magnetron sputtering at room temperature onto a front-side thin SiOx/n+ poly-Si contact in a complete Cz n-Si cell with a back-side Al2O3/SiNx passivating boron-diffused p+-emitter on a random pyramid textured surface. We report the cell characteristics before and after ITO sputtering, and we find a cure at 250 °C in air is highly effective at mitigating any sputtering induced damage. Our ITO coated sample resulted in an implied open-circuit voltage (iVoc) of 684.7 ± 11.3 mV with the total saturation current density of 49.2 ± 14.8 fA/cm2, an implied fill factor (iFF) of 81.9 ± 0.8%, and a contact resistivity in the range of 60 mΩ-cm2 to 90 mΩ-cm2. After formation of a local Ag contact to the rear emitter and sputtered ITO film as the front-side contact without grid fingers, the pseudo-efficiency of 20.2 ± 0.5% was obtained with the Voc of 670.4 ± 7 mV and pseudo FF of 77.3 ± 1.3% under simulated one sun with the calculated short-circuit current density of 30.9 mA/cm2 from the measured external quantum efficiency. Our modelling result shows that efficiency exceeding 25% under one sun is practically achievable in perovskite/Si tandem configuration using the ITO recombination layer connecting a perovskite top cell and a poly-Si bottom cell.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Silicon and Solar Cell Technologies · Thin-Film Transistor Technologies · Semiconductor materials and interfaces

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (53)

Show source-provided references
1. Silicon heterojunction solar cell with interdigitated back contacts for a photoconversion efficiency over 26%10.1038/nenergy.2017.32 ↗
2. Reassessment of the limiting efficiency for crystalline silicon solar cells10.1109/JPHOTOV.2013.2270351 ↗
3. Band gap-voltage offset and energy production in next-generation multijunction solar cells10.1002/pip.1044 ↗
4. H. Shen, D. Walter, Y. Wu, K.C. Fong, D.A. Jacobs, T. Duong, J. Peng, K. Weber, T.P. White, K.R. Catchpole, Monolithic perovskite/Si tandem solar cells: pathways to over 30% efficiency, Adv. Energy Mater., n/a 1902840.
5. Promises and challenges of perovskite solar cells10.1126/science.aam6323 ↗
6. Textured interfaces in monolithic perovskite/silicon tandem solar cells: advanced light management for improved efficiency and energy yield10.1039/C8EE02469C ↗
7. Minimizing current and voltage losses to reach 25% efficient monolithic two-terminal perovskite–silicon tandem solar cells10.1021/acsenergylett.8b01201 ↗
8. Highly efficient monolithic perovskite silicon tandem solar cells: analyzing the influence of current mismatch on device performance10.1039/C9SE00120D ↗
9. Grain engineering for perovskite/silicon monolithic tandem solar cells with efficiency of 25.4%10.1016/j.joule.2018.10.003 ↗
10. Infrared light management using a nanocrystalline silicon oxide interlayer in monolithic perovskite/silicon heterojunction tandem solar cells with efficiency above 25%10.1002/aenm.201803241 ↗
11. Solar cell efficiency tables (Version 55)10.1002/pip.3228 ↗
12. Monolithic perovskite/silicon-homojunction tandem solar cell with over 22% efficiency10.1039/C7EE02288C ↗
13. A 2-terminal perovskite/silicon multijunction solar cell enabled by a silicon tunnel junction10.1063/1.4914179 ↗
14. Zinc tin oxide as high-temperature stable recombination layer for mesoscopic perovskite/silicon monolithic tandem solar cells10.1063/1.4971361 ↗
15. Large area efficient interface layer free monolithic perovskite/homo-junction-silicon tandem solar cell with over 20% efficiency10.1039/C8EE00689J ↗
16. 21.8% efficient monolithic perovskite/homo-junction-silicon tandem solar cell on 16 cm210.1021/acsenergylett.8b01382 ↗
17. Very low surface recombination velocities on p- and n-type silicon wafers passivated with hydrogenated amorphous silicon films
18. Thermal stability of amorphous silicon/silicon nitride stacks for passivating crystalline silicon solar cells10.1063/1.3009571 ↗
19. A cost roadmap for silicon heterojunction solar cells10.1016/j.solmat.2015.12.026 ↗
20. 25.1%-Efficient monolithic perovskite/silicon tandem solar cell based on a p-type monocrystalline textured silicon wafer and high-temperature passivating contacts10.1021/acsenergylett.9b00377 ↗
21. A new carbon phase with direct bandgap and high carrier mobility as electron transport material for perovskite solar cells10.1038/s41524-018-0146-z ↗
22. A review of inorganic hole transport materials for perovskite solar cells10.1002/admi.201800882 ↗
23. Monolithic perovskite/silicon-heterojunction tandem solar cells processed at low temperature10.1039/C5EE02965A ↗
24. Efficient monolithic perovskite/silicon tandem solar cell with cell area >1 cm210.1021/acs.jpclett.5b02686 ↗
25. 23.6%-efficient monolithic perovskite/silicon tandem solar cells with improved stability10.1038/nenergy.2017.9 ↗
26. Transparent conducting oxide-based, passivated contacts for high efficiency crystalline Si solar cells
27. Passivating/hole-selective contacts based on V2O5/SiOx stacks deposited at ambient temperature10.1016/j.egypro.2017.09.294 ↗
28. Improved optics in monolithic perovskite/silicon tandem solar cells with a nanocrystalline silicon recombination junction10.1002/aenm.201701609 ↗
29. Fully textured monolithic perovskite/silicon tandem solar cells with 25.2% power conversion efficiency10.1038/s41563-018-0115-4 ↗
30. Reduction of optical loss in hydrogenated amorphous silicon/crystalline silicon heterojunction solar cells by high-mobility hydrogen-doped In2O3Transparent conductive oxide
31. Damage at hydrogenated amorphous/crystalline silicon interfaces by indium tin oxide overlayer sputtering10.1063/1.4764529 ↗
32. Passivated rear contacts for high-efficiency n-type Si solar cells providing high interface passivation quality and excellent transport characteristics10.1016/j.solmat.2013.09.017 ↗
33. Efficient carrier-selective p- and n-contacts for Si solar cells10.1016/j.solmat.2014.05.039 ↗
34. Large area tunnel oxide passivated rear contact n-type Si solar cells with 21.2% efficiency10.1002/pip.2739 ↗
35. Laser contact openings for local poly-Si-metal contacts enabling 26.1%-efficient POLO-IBC solar cells10.1016/j.solmat.2018.06.020 ↗
36. Mass production of industrial tunnel oxide passivated contacts (i-TOPCon) silicon solar cells with average efficiency over 23% and modules over 345 W10.1002/pip.3180 ↗
37. n-Type Si solar cells with passivating electron contact: identifying sources for efficiency limitations by wafer thickness and resistivity variation10.1016/j.solmat.2017.05.042 ↗
38. From PERC to tandem: POLO- and p+/n+ poly-Si tunneling junction as interface between bottom and top cell10.1109/JPHOTOV.2018.2876999 ↗
39. Implementing transparent conducting oxides by DC sputtering on ultrathin SiOx/poly-Si passivating contacts10.1016/j.solmat.2019.109960 ↗
40. High and low work function materials for passivated contacts10.1016/j.egypro.2015.07.037 ↗
41. Passivating and low-resistive poly-Si tunneling junction enabling high-efficiency monolithic perovskite/silicon tandem solar cells10.1063/1.5120552 ↗
42. High quality ITO thin films grown by dc and RF sputtering without oxygen10.1088/0022-3727/43/5/055402 ↗
43. Impact of deposition of ITO on tunnel oxide passivating poly-Si contact
44. Contactless determination of current–voltage characteristics and minority‐carrier lifetimes in semiconductors from quasi‐steady‐state photoconductance data10.1063/1.117723 ↗
45. Generalized analysis of quasi-steady-state and transient decay open circuit voltage measurements10.1063/1.1416134 ↗
46. A quasi-steady-state open-circuit voltage method for solar cell characterization
47. Integrating transparent conductive oxides to improve the infrared response of silicon solar cells with passivating rear contacts10.1063/1.5049286 ↗
48. Achieving a high open-circuit voltage in inverted wide-bandgap perovskite solar cells with a graded perovskite homojunction10.1016/j.nanoen.2019.04.069 ↗
49. Efficient two-terminal all-perovskite tandem solar cells enabled by high-quality low-bandgap absorber layers10.1038/s41560-018-0278-x ↗
50. Low resistivity indium–tin oxide transparent conductive films. II. Effect of sputtering voltage on electrical property of films10.1116/1.576890 ↗
51. Recombination analysis of phosphorus-doped nanostructured silicon oxide passivating electron contacts for silicon solar cells10.1109/JPHOTOV.2017.2779871 ↗
52. The impact of indium tin oxide deposition and post annealing on the passivation property of TOPCon solar cells10.1016/j.solener.2018.10.034 ↗
53. General transfer-matrix method for optical multilayer systems with coherent, partially coherent, and incoherent interference10.1364/AO.41.003978 ↗