journal article·2019-09Open access

Quantitative analysis of degradation mechanisms in 30-year-old PV modules

Zhe Liu, Mariela Lizet Castillo, Amanda Youssef, James G. Serdy, Alliston Watts, Cordula Schmid, Sarah Kurtz, Ian Marius Peters, Tonio Buonassisi

Abstract

Abstract Quantitative analysis of two 30-year-old PV modules is performed by a combination of the equivalent-circuit model and optoelectronic characterization methods. The two modules under analysis were manufactured in 1984 with the nameplate power of 41.0 W, but degraded under two different conditions; one was operated in the field in Northern California for about 30 years, and the other was stored in a warehouse for the same period. The power outputs of the two modules measured in 2016 are as 28.4W for the field-exposed one and 35.9 W for the warehoused one. We further break down this power difference of 7.5 W ± 0.3 W to specific physical mechanisms. Through the encapsulant transmittance measurements and the circuit modeling of module I–V curves, the power degradation due to encapsulant discoloration is found as 59% ± 4% of the total difference. With the bias-dependent electroluminescence imaging and the dark I–V measurement of solar cells (via the additionally-attached probe wires), the series-resistance increase is attributed to 33% ± 1%, with the split of 13% ± 4% due to interconnection resistance and 20% ± 4% due to cell resistance. In addition, the synergistic effect of all the physical mechanisms makes up the remaining 8% ± 4%. This case study presents an example of analyzing multiple degradation mechanisms of the PV modules. With more characterization data being collected for today's modules, the same analysis framework can be broadly applied, yield great insights module power degradation attributed to multiple loss mechanisms.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Photovoltaic System Optimization Techniques · Silicon and Solar Cell Technologies · solar cell performance optimization

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (52)

Show source-provided references
1. Photovoltaic degradation rates—an analytical review10.1002/pip.1182 ↗
2. Technology advances needed for photovoltaics to achieve widespread grid price parity10.1002/pip.2755 ↗
3. Correlation of electrical and visual degradation seen in field survey in India
4. Performance and aging of a 20-year-old silicon PV system10.1109/JPHOTOV.2015.2396360 ↗
5. Degradation mechanism investigation of extended damp heat aged PV modules
6. Correlation of the loss in photovoltaic module performance with the ageing behaviour of the backsheets used10.1002/pip.2580 ↗
7. Analysis of crystalline silicon PV modules after 30 years of outdoor exposure
8. Crystalline silicon PV module degradation after 20 years of field exposure studied by electrical tests, electroluminescence, and LBIC10.1002/pip.2717 ↗
9. Unified methodology for determining CTM ratios: systematic prediction of module power10.1016/j.solmat.2014.06.025 ↗
10. Luminescence imaging analysis of light harvesting from inactive areas in crystalline silicon PV modules10.1016/j.solmat.2015.09.013 ↗
11. Investigation of the short-circuit current increase for PV modules using halved silicon wafer solar cells10.1016/j.solmat.2014.11.012 ↗
12. Full loss analysis for a multicrystalline silicon wafer solar cell PV module at short-circuit conditions10.1002/pip.2593 ↗
13. Quantitative analysis of PV-modules by electroluminescence images for quality control
14. Investigation of polysilicon passivated contact's resilience to potential-induced degradation10.1016/j.solmat.2019.02.038 ↗
15. Elucidating potential-induced degradation in bifacial PERC silicon photovoltaic modules10.1002/pip.3028 ↗
16. Chicca · 2015
17. Quantitative analysis of crystalline silicon wafer PV modules by electroluminescence imaging
18. Quantitative local current-voltage analysis and calculation of performance parameters of single solar cells in modules10.1016/j.solmat.2016.08.029 ↗
19. Fast and reliable calculation of the two-diode model without simplifications10.1002/pip.2301 ↗
20. Köntges · 2014
21. Emery · 2009
22. European Commission Joint Research Centre · 2010
23. Technology and climate trends in PV module degradation
24. The results of performance measurements of field-aged crystalline silicon photovoltaic modules10.1002/pip.874 ↗
25. Analysis of the long-term performance degradation of crystalline silicon photovoltaic modules in tropical climates10.1109/JPHOTOV.2018.2877007 ↗
26. Detection of the voltage distribution in photovoltaic modules by electroluminescence imaging10.1002/pip.941 ↗
27. S. Suckow, “2-Diode Fit.” NanoHUB.org.
28. A new method for accurate measurements of the lumped series resistance of solar cells
29. A review and comparison of different methods to determine the series resistance of solar cells10.1016/j.solmat.2007.05.026 ↗
30. Investigation of the degradation and stabilization of EVA-based encapsulant in field-aged solar energy modules10.1016/S0141-3910(96)00162-0 ↗
31. Ethylene-vinyl acetate (EVA) encapsulants for photovoltaic modules: degradation and discoloration mechanisms and formulation modifications for improved photostability10.1002/apmc.1997.052520114 ↗
32. Acetic acid production and glass transition concerns with ethylene-vinyl acetate used in photovoltaic devices10.1016/j.solmat.2006.10.009 ↗
33. Aspects of the thermal oxidation of ethylene vinyl acetate copolymer10.1016/S0141-3910(00)00020-3 ↗
34. Investigation into the causes of browning in EVA encapsulated flat plate PV modules
35. Influences of different lamination conditions on the reliability of encapsulation of PV modules
36. Long term reliability of PV modules
37. The influence of PV module materials and design on solder joint thermal fatigue durability10.1109/JPHOTOV.2016.2598255 ↗
38. Mechanisms of adhesion degradation at the photovoltiac module’s cell metallization-encapsulant interface10.1002/pip.3106 ↗
39. Study on mitigation method of solder corrosion for crystalline silicon photovoltaic modules10.1155/2014/809075 ↗
40. Module encapsulation materials, processing and testing
41. Reliability of EVA modules
42. Origin of damp-heat induced cell degradation10.1016/j.solmat.2013.03.022 ↗
43. Investigation of acetic acid corrosion impact on printed solar cell contacts10.1109/JPHOTOV.2015.2395146 ↗
44. Effects of UV on power degradation of photovoltaic modules in combined acceleration tests10.7567/JJAP.55.052301 ↗
45. Evaluation of two-dimensional electrical properties of photovoltaic modules using bias-dependent electroluminescence10.1002/pip.1161 ↗
46. Breakdown of the efficiency gap to 29% based on experimental input data and modeling10.1002/pip.2696 ↗
47. A modeling framework for optimizing current density in four-terminal tandem solar cells: a case study on GaAs/Si tandem10.1016/j.solmat.2017.05.048 ↗
48. 1989
49. 2008
50. Revising and validating spectral irradiance reference standards for photovoltaic performance evaluation10.1115/1.1638784 ↗
51. Solar cell efficiency measurements10.1016/0379-6787(86)90016-5 ↗
52. Evolution of measured module characteristics versus labelled module characteristics of crystalline silicon based PV modules10.1016/j.solener.2017.12.018 ↗