journal article·2017-03

All-oxide solar cells based on electrodeposited Cu2O absorber and atomic layer deposited ZnMgO on precious-metal-free electrode

Jatinder Kaur, Ole Bethge, Rachmat Adhi Wibowo, Neha Bansal, Martin Bauch, Raad Hamid, Emmerich Bertagnolli, Theodoros Dimopoulos

Publisher page

Abstract

Abstract All-oxide solar cells based on electrodeposited p -type Cu 2 O absorber and atomic layer deposited n -type ZnMgO are investigated. The introduced solar cell architecture is free of precious metals that are usually employed as electrodes in Cu 2 O solar cells and is composed almost exclusively of oxide layers. Firstly, a detailed investigation is made on the potentiostatic electrodeposition of the absorber layer on the sputtered, highly conductive and reflective Cr/ITO (ITO: tin-doped indium oxide) electrode. The focus is set on adjusting the deposition parameters to obtain Cu 2 O layers, which are void-free and with large grains. A multi-textured film is obtained with prominent (111), (200) and (220) reflections. The absorber has a bandgap of 1.93 eV and a rough, antireflective surface. Next, the n -type ZnMgO layer has been investigated and a linear relation of the optical bandgap (3.2–3.9 eV) versus Mg content was found. The valence band maximum levels have been extracted from X-Ray photoelectron spectroscopy and the band alignment of the Cu 2 O/ZnMgO was evaluated. Solar cells employing ZnMgO films with ~10 at% Mg show best photovoltaic performance, whereas for larger Mg contents a dramatic decrease of the performance takes place, presumably due to excessive, deep-level defects, leading to tunnel recombination. Best cells show short circuit current density of 6.8 mA/cm 2 , open circuit voltage of 550 mV, fill factor of 45% and power conversion efficiency of 1.67%.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Copper-based nanomaterials and applications · ZnO doping and properties · Chalcogenide Semiconductor Thin Films

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (65)

Show source-provided references
1. B. Lange, Photoelements, Reinhold Publ. Corp., New York, 1938.
2. Materials availability expands the opportunity for large-scale photovoltaics deployment10.1021/es8019534 ↗
3. The copper oxide rectifier10.1103/RevModPhys.23.203 ↗
4. Detailed balance limit of efficiency of p-n junction solar cells10.1063/1.1736034 ↗
5. Absorption coefficient of bulk and thin film Cu2O10.1016/j.solmat.2011.05.047 ↗
6. Production of cuprous oxide, a solar cell material, by thermal oxidation and a study of its physical and electrical properties10.1016/S0927-0248(97)00233-X ↗
7. Heterojunction solar cell with 2% efficiency based on a Cu2O substrate10.1063/1.2194315 ↗
8. Experimental and theoretical studies of Cu2O solar cells10.1016/0379-6787(82)90050-3 ↗
9. Chlorine doping of Cu2O10.1016/j.solmat.2010.06.022 ↗
10. Self-compensation in semiconductors10.1103/PhysRevB.60.8138 ↗
11. Heterojunction solar cells on cuprous oxide10.1016/0379-6787(81)90084-3 ↗
12. Valence band offset of Cu2O/In2O3 heterojunction determined by X-ray photoelectron spectroscopy10.1063/1.3641637 ↗
13. CdO/Cu2O solar cells by chemical deposition10.1016/j.solener.2004.05.014 ↗
14. Sulphidation of electrodeposited cuprous oxide thin films for photovoltaic applications10.1016/S0927-0248(99)00115-4 ↗
15. Fabrication and photovoltaic characteristics of Cu2O/TiO2 thin film heterojunction solar cell10.1016/j.tsf.2012.08.013 ↗
16. TiO2/Cu2O all-oxide heterojunction solar cells produced by spray pyrolysis10.1016/j.solmat.2014.10.005 ↗
17. High-efficiency oxide solar cells with ZnO/Cu 2O heterojunction fabricated on thermally oxidized Cu2O sheets10.1143/APEX.4.062301 ↗
18. Photovoltaic properties in Al-doped ZnO/non-doped Zn1−XMgXO/Cu2O heterojunction solar cells
19. High-Efficiency Cu 2 O-Based Heterojunction Solar Cells Fabricated Using a Ga2O 3 Thin Film as N-Type Layer10.7567/APEX.6.044101 ↗
20. Heterojunction solar cell with 6% efficiency based on an n-type aluminum–gallium–oxide thin film and p-type sodium-doped Cu2O sheet10.7567/APEX.8.022301 ↗
21. Efficiency enhancement using a Zn1−xGexO thin film as an n-type window layer in Cu2O-based heterojunction solar cells10.7567/APEX.9.052301 ↗
22. Electrochemically constructed p-Cu2O/n-ZnO heterojunction diode for photovoltaic device10.1088/0022-3727/40/11/010 ↗
23. Ultrathin amorphous zinc-tin-oxide buffer layer for enhancing heterojunction interface quality in metal-oxide solar cells10.1039/c3ee24461j ↗
24. Improved Cu2O-based solar cells using atomic layer deposition to control the Cu oxidation state at the p-n junction10.1002/aenm.201301916 ↗
25. Atomic layer deposited gallium oxide buffer layer enables 1.2 V open-circuit voltage in cuprous oxide solar cells10.1002/adma.201401054 ↗
26. The band alignment of Cu2O/ZnO and Cu2O/GaN heterostructures10.1063/1.3685719 ↗
27. Effects of Mg composition on open circuit voltage of Cu2O/MgxZn1−xO heterojunction solar cells10.1016/j.solmat.2011.09.047 ↗
28. Band offsets of n-type electron-selective contacts on cuprous oxide (Cu2O) for photovoltaics10.1063/1.4905180 ↗
29. J. Matthew, In: D. Briggs, J.T. Grant, (Eds.), Surface Analysis by Auger And X-ray Photoelectron Spectroscopy, IMPublications, Chichester, UK and SurfaceSpectra Manchester, UK 900 http://dx.doi.org/10.1002/sia.2005, 200310.1002/sia.2005 ↗
30. Nitrogen-doped cuprous oxide as a p-type hole-transporting layer in thin-film solar cells10.1039/c3ta13208k ↗
31. Atomic Layer Deposited Gallium Oxide Buffer Layer Enables 1.2 V open-circuit voltage in cuprous oxide solar cells10.1002/adma.201401054 ↗
32. Lee · 2008
33. Lide · 2008
34. Substrate effects on the surface topography of evaporated gold films—A scanning tunnelling microscopy investigation10.1016/0039-6028(89)90622-5 ↗
35. Metal/metal-oxide interfaces: a surface science approach to the study of adhesion10.1116/1.577656 ↗
36. Improvement of interfacial adhesion of Al/Cr films deposited on indium tin oxide coated glasses by interfacial oxidation10.1016/j.surfcoat.2003.09.055 ↗
37. Defining the transfer coefficient in electrochemistry: an assessment (IUPAC Technical Report)
38. Island growth in electrodeposition10.1088/0022-3727/44/44/443001 ↗
39. On the influence of the nucleation overpotential on island growth in electrodeposition10.1016/j.electacta.2010.02.038 ↗
40. Theoretical and experimental studies of multiple nucleation10.1016/0013-4686(83)85163-9 ↗
41. Structural and optical properties of Cu2O crystalline electrodeposited films10.1016/j.tsf.2014.04.013 ↗
42. L. Wang, U. of T. at A. ProQuest Dissertations and Theses (Electronic resource collection), College of Engineering, Preparation and characterization of properties of electrodeposited copper oxide films, 2006
43. Optical band gaps of selected ternary sulfide minerals10.2138/am-1998-7-818 ↗
44. Effect of thermal annealing in vacuum on the photovoltaic properties of electrodeposited Cu2O-absorber solar cell10.1051/epjpv/2014005 ↗
45. Structural, electrical, and optical properties of atomic layer deposition Al-doped ZnO films10.1063/1.3466987 ↗
46. D.Briggs, Handbook of X-ray Photoelectron Spectroscopy C.D. Wanger, W.M. Riggs, L.E. Davis, J.F. Moulder, G.E.Muilenberg Perkin-Elmer Corp., Physical Electronics Division, Eden Prairie, Minnesota, USA, 1979. 190pp. 195, Surf. Interface Anal. 3v–v. doi:10.1002/sia.740030412, 1981.10.1002/sia.740030412 ↗
47. Crist · 2000
48. Self-assembled MgxZn1−xO quantum dots (0≤x≤1) on different substrates using spray pyrolysis methodology10.1039/C2CE26253C ↗
49. Optical properties and electronic structure of amorphous Ge and Si10.1016/0025-5408(68)90023-8 ↗
50. MgxZn1−xO as a II–VI widegap semiconductor alloy10.1063/1.121384 ↗
51. Growth and physical behaviour of Zn1−xMgxO films10.1016/j.tsf.2007.12.098 ↗
52. Effect of Mg content on structural, electrical and optical properties of Zn1−xMgxO nanocomposite thin films10.1016/j.solmat.2008.09.039 ↗
53. André Bikowski, · 2014
54. Band gap and electronic properties of wurtzite-structure ZnO co-doped with IIA and IIIA10.1063/1.3627233 ↗
55. Absolute deformation potentials and band alignment of wurtzite ZnO, MgO, and CdO10.1103/PhysRevB.75.121201 ↗
56. First-principles investigation of electronic and optical properties in wurtzite Zn1−xMgxO10.1140/epjb/e2008-00186-9 ↗
57. Structural, electrical and optical properties of transparent Zn1−xMgxO nanocomposite thin films10.1016/j.tsf.2009.09.020 ↗
58. Realization of band gap above 5.0 eV in metastable cubic-phase MgxZn1−xO alloy films10.1063/1.1456266 ↗
59. Semiconductor core-level to valence-band maximum binding-energy differences: precise determination by x-ray photoelectron spectroscopy10.1103/PhysRevB.28.1965 ↗
60. Electronic structure of Cu2O and CuO10.1103/PhysRevB.38.11322 ↗
61. Perspective: maintaining surface-phase purity is key to efficient open air fabricated cuprous oxide solar cells10.1063/1.4913442 ↗
62. Band alignment at the Cu2O/ZnO heterojunction10.7567/JJAP.50.051002 ↗
63. Interface stoichiometry control to improve device voltage and modify band alignment in ZnO/Cu2O heterojunction solar cells10.1039/C4EE01956C ↗
64. Performance improvement in Cd-free Cu(In,Ga)Se2 solar cells by modifying the electronic structure of the ZnMgO buffer layer10.1039/C4RA07776H ↗
65. Deep level related photoluminescence in ZnMgO10.1063/1.3518480 ↗