Enhancement of solar cell performance of p-Cu2O/n-ZnO-nanotube and nanorod heterojunction devices
Source abstract
Abstract
Abstract Nanostructured thin films are appealing to solar light harvesting and high-efficiency photovoltaic devices. A new Cu 2 O/ZnO heterojunction solar cell architecture has been developed with ZnO nanotubes (NTs) and nanorods (NRs), on a 500 nm thick, n-type ZnO seed layer, covered by a 2.5–3 µm thick, p-type Cu 2 O layer to provide the full built-in potential across the junction area, all done by electrodeposition method. This architecture is used to improve the light harvesting and charge collection efficiency by taking advantage of the high surface area junction and direct charge transfer pathway of these one-dimensional ZnO nanostructures. In addition, we calculate the optimized thickness of p-type Cu 2 O film of 2.5–3 µm to maximize their open-circuit voltages. Post-annealing of the p-type Cu 2 O nanostructured film at 200 °C is found to provide better crystallinity and a higher conductivity for additional improvement in the performance. Further optimization of the Cu 2 O film thickness according to their charge carrier concentration and absolute permittivity values also assures the full built-in potential across the junction interface. Finally, the electrodeposited tubular ZnO nanostructures are grown on the top of a sufficiently thick ZnO seed layer, which prevents any leakage pathway and increases the junction area, and consequently increases their short-circuit current values. The open-circuit voltages obtained for Cu 2 O/ZnO-NT (0.66 V) and Cu 2 O/ZnO-NR heterojunction devices (0.71 V) represent the highest values reported to date for this type of electrodeposited Cu 2 O/ZnO solar cells. Interestingly, the short-circuit current density of the Cu 2 O/ZnO-NT cell (2.40 mA/cm 2 ) is twice that of the Cu 2 O/ZnO-NR cell (1.12 mA/cm 2 ) with a photon-to-electron conversion efficiencies of 0.8% and 0.4%, respectively. These results illustrate the advantage of single-step electrodeposition of ZnO nanotubes, which provide a larger interfacial area and a much lower defect density than previously reported nanotubes obtained by etching ZnO nanorods. The new device architecture also offers a minimum leakage path and reduced recombination loss expected in typical nanostructure-based photovoltaics. This study demonstrates a promising approach to fabricating low-cost metal oxide nanostructured thin-film solar cells by a scalable, efficient electrochemical method for cost reduction, process simplification, and performance improvement.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Copper-based nanomaterials and applications · ZnO doping and properties · Electronic and Structural Properties of Oxides
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (42)
Show source-provided references
1. Light trapping in thin crystalline Si solar cells using surface Mie scatterers10.1109/JPHOTOV.2013.2292744 ↗
2. High efficiency solution processed sintered CdTe nanocrystal solar cells: the role of interfaces10.1021/nl403912w ↗
3. Al-Doped ZnO/Cu2O heterojunction fabricated on (200) and (111)-orientated Cu2O substrates10.1149/1.2980424 ↗
4. Three kinds of Cu2O/ZnO heterostructure solar cells fabricated with electrochemical deposition and their structure-related photovoltaic properties10.1039/c1ce05540b ↗
5. The p-type conduction mechanism in Cu2O: a first principles study10.1039/b611969g ↗
6. Shape evolution and size-controllable synthesis of Cu2O octahedra and their morphology-dependent photocatalytic properties10.1021/jp061934y ↗
7. Thin cuprous oxide films prepared by thermal oxidation of copper foils with water vapor10.1016/j.tsf.2011.11.037 ↗
8. Reactive magnetron sputtering of Cu2O: dependence on oxygen pressure and interface formation with indium tin oxide10.1063/1.3592981 ↗
9. Electrodeposited ZnO/Cu2O heterojunction solar cells10.1016/j.electacta.2007.09.030 ↗
10. Electrochemical growth and characterization of a p-Cu2O thin film on n-ZnO nanorods for solar cell application10.1039/c3ra47188h ↗
11. Enhancing the current density of electrodeposited ZnO–Cu2O solar cells by engineering their heterointerfaces10.1039/c2jm35682a ↗
12. A simple two-step electrodeposition of Cu2O/ZnO nanopillar solar cells10.1021/jp1004314 ↗
13. Cu2O/ZnO heterojunction solar cells fabricated by magnetron-sputter deposition method films using sintered ceramics targets10.1088/1742-6596/433/1/012027 ↗
14. High-efficiency oxide solar cells with ZnO/Cu2O heterojunction fabricated on thermally oxidized Cu2O sheets10.1143/APEX.4.062301 ↗
15. Nano-structured Cu2O solar cells fabricated on sparse ZnO nanorods10.1016/j.solmat.2011.04.034 ↗
16. Cu2O growth characteristics on an array of ZnO nanorods for the nano-structured solar cells10.1016/j.surfcoat.2012.05.054 ↗
17. ZnO/Cu2O heterostructure nanopillar arrays: synthesis, structural and optical properties10.1088/0022-3727/45/24/245301 ↗
18. Electrodeposited p-Cu2O/n-ZnO heterojunction diode for photovoltaic device10.1088/0022-3727/40/11/010 ↗
19. A novel buffering technique for aqueous processing of zinc oxide nanostructures and interfaces, and corresponding improvement of electrodeposited ZnO–Cu2O photovoltaics10.1002/adfm.201001956 ↗
20. Thin film deposition of Cu2O and application for solar cells10.1016/j.solener.2005.10.012 ↗
21. Minority carrier transport length of electrodeposited Cu2O in ZnO/Cu2O heterojunction solar cells10.1063/1.3579259 ↗
22. Incompatible length scales in nanostructured Cu2O solar cells10.1002/adfm.201102263 ↗
23. Effect of electrolyte conductivity on controlled electrochemical synthesis of zinc oxide nanotubes and nanorods10.1021/jp312321t ↗
24. Macroscopically uniform electrodeposited ZnO films on conducting glass by surface tension modification and consequent demonstration of significantly improved p–n heterojunctions10.1016/j.electacta.2011.02.067 ↗
25. The structural and optical properties of Cu2O films electrodeposited on different substrates10.1088/0268-1242/20/1/007 ↗
26. Structural and electrical characterizations of electrodeposited p-type semiconductor Cu2O films10.1149/1.1862478 ↗
27. Electrical properties of CdTe layers electrodeposited from ammoniacal basic electrolytes10.1149/1.1570411 ↗
28. Preparation, characteristics and photovoltaic properties of cuprous oxide—a review10.1016/0038-1101(86)90191-7 ↗
29. Synthesis of novel Cu2O micro/nanostructural photocathode for solar water splitting10.1016/j.electacta.2013.05.003 ↗
30. The impact of heterojunction formation temperature on obtainable conversion efficiency in n-ZnO/p-Cu2O solar cells10.1016/j.tsf.2012.09.090 ↗
31. Photoelectrochemical stability of electrodeposited Cu2O films10.1021/jp103437y ↗
32. Synthesis and characterization of high-photoactivity electrodeposited Cu2O solar absorber by photoelectrochemistry and ultrafast spectroscopy10.1021/jp301176y ↗
33. J.F. Moulder, W.F. Stickle, P.E. Sobol, in: J. Chastain (Ed.), Handbook of X-Ray Photoelectron Spectroscopy, 2nd ed., Perkin-Elmer Corp., 1992.
34. Investigation of annealing-treatment on the optical and electrical properties of sol–gel-derived zinc oxide thin films10.1016/j.spmi.2005.08.039 ↗
35. Effect of annealing temperature on photocatalytic activity of ZnO thin films prepared by sol–gel method10.1016/j.spmi.2011.05.003 ↗
36. Effects of doping concentration and annealing temperature on properties of highly-oriented Al-doped ZnO films10.1016/j.jcrysgro.2005.10.047 ↗
37. Effects of annealing temperature on ZnO and AZO films prepared by sol–gel technique10.1016/j.apsusc.2012.05.156 ↗
38. Annealing effects and photoelectric properties of single-oriented Cu2O films electrodeposited on Au(111)/Si(100) substrates10.1039/c3ta11116d ↗
39. Polycrystalline n-ZnO/p-Cu2O heterojunctions grown by RF-magnetron sputtering10.1002/pssc.200304245 ↗
40. Fabrication of ZnO/Cu2O heterojunctions in atmospheric conditions: improved interface quality and solar cell performance10.1016/j.solmat.2014.09.018 ↗
41. Strong efficiency improvements in ultra-low-cost inorganic nanowire solar cells10.1002/adma.201001455 ↗
42. Three-dimensional ordered ZnO/Cu2O nanoheterojunctions for efficient metal-oxide solar cells