journal article·2013-06

Numerical modelling and experimental validation of a low concentrating photovoltaic system

Hasan Baig, Nabin Sarmah, Keith C. Heasman, Tapas K. Mallick

Publisher page

Abstract

Concentrator solar cells need to be designed optimally depending on the concentrating photovoltaic (CPV) system, application and operating conditions to ensure the best system performance. The important factors while designing include concentration ratio, cell material properties, expected operating temperature, cell shape, bus bar configuration, number of fingers their size and spacing. The irradiation incident on the solar cell while being concentrated experiences several losses caused by the different physical phenomena's occurring in the system. A particular issue for CPV technology is the non-uniformity of the incident flux on the solar cell which tends to cause hot spots, current mismatch and reduce the overall efficiency of the system. Understanding of this effect and designing the cell while considering these issues, would help in improving the overall performance of the system. This study focuses on modelling a low concentrating photovoltaic system used for building integration, optimising the cell metallisation and analysing the effects of temperature on the overall output of the system. The optical analysis of the concentrator is carried out using ray tracing and finite element methods to determine electrical and thermal performance under operating conditions. Furthermore, an analysis is made to understand the effects of non-uniformity on the output of the device. About 0.5% absolute drop in solar cell efficiency was observed due to non-uniformity at 5o incident angle. A relative drop of 1.85% was observed in the fill factor due to non-uniformity of the flux distribution. A maximum cell temperature of 349.5 K was observed across the cell in both uniform and non-uniform conditions under an incident solar radiation of 1000 W/m2 which further reduced the performance of the solar cell. The solar cell design was also analysed by varying the number of fingers and the optimum grid design reported. A small prototype concentrator based on the design proposed was made using polyurethane and tested experimentally with the optimized solar cell design. On comparing the results obtained using the experimental data a good agreement in the system output could be seen. The difference in the overall system output was seen to be of the order of 11% which could be due to several losses occurring in the prototype which were not accounted in the model. © 2013 Published by Elsevier B.V. All rights reserved.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: solar cell performance optimization · Solar Thermal and Photovoltaic Systems · Photovoltaic System Optimization Techniques

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (49)

Show source-provided references
1. Durability of Fresnel lenses: A review specific to the concentrating photovoltaic application10.1016/j.solmat.2011.01.031 ↗
2. Comparison of Fresnel concentrators for building integrated photovoltaics10.1016/j.enconman.2008.12.002 ↗
3. Concentrated solar energy applications using Fresnel lenses: A review10.1016/j.rser.2011.03.031 ↗
4. Parabolic trough collector testing in the frame of the REACt project10.1016/j.desal.2007.04.062 ↗
5. A novel combined solar concentration/wind augmentation system: Constructions and preliminary testing of a prototype10.1016/j.applthermaleng.2011.01.015 ↗
6. Water desalination with concentrating photovoltaic/thermal (CPVT) systems10.1016/j.solener.2009.04.003 ↗
7. Fabrication and characterization of a flat-plate static-concentrator photovoltaic module10.1016/S0927-0248(00)00311-1 ↗
8. Design and characterization of flat-plate static-concentrator photovoltaic modules10.1016/S0927-0248(00)00313-5 ↗
9. Modeling of static concentrator modules incorporating lambertian or v-groove rear reflectors10.1016/j.solmat.2005.09.012 ↗
10. K. Sakuta, S. Sawata, M. Tanimoto, Luminescent concentrator module of a practical size, in: Photovoltaic Energy Conversion, 1994., Conference Record of the Twenty Fourth. IEEE Photovoltaic Specialists Conference – 1994, 1994 IEEE First World Conference on, 1994, pp. 1115–1118, vol. 1111.
11. Luminescent solar concentrators? A review of recent results10.1364/OE.16.021773 ↗
12. R.K. L.H. Slooff, A. R. Burgers, J.A.M. van Roosmalen, A. Büchtemann, R. Danz, M. Schleusener,, D.F. A. J. Chatten, K. W. J. Barnham, The luminescent concentrator: a bright idea for spectrum conversion, in: 20th European Photovoltaic Solar Energy Conference and Exhibition,Barcelona, Spain, (2005) pp. 6–10.
13. Ideal prism solar concentrators10.1016/0038-092X(78)90175-5 ↗
14. Static concentrator photovoltaic module with prism array10.1016/S0927-0248(00)00310-X ↗
15. J. Alonso, V. Diaz, M. Hernandez, F. Bercero, C. Canizo, I. Pou, R. Mohedano, P. Benitez, J.C. Minano, A. Luque, S. Steckemetz, A. Metz, R. Hezel, J.C. Jimeno, R. Gutierrez, F. Recart, G. Bueno, V. Rodriguez, F. Hernando, V.M. Sukhostavets, S. Beringov, K. Sassoli, C. Iachetti, G. Carotid, A new static concentrator PV module with bifacial cells for integration on facades: the PV VENETIAN store, in: Photovoltaic Specialists Conference, 2002. Conference Record of the Twenty-Ninth IEEE, 2002, pp. 1584–1587.10.1109/PVSC.2002.1190917 ↗
16. Design and fabrication of low concentrating second generation PRIDE concentrator10.1016/j.solmat.2006.11.016 ↗
17. The design and experimental characterisation of an asymmetric compound parabolic photovoltaic concentrator for building façade integration in the UK10.1016/j.solener.2004.05.015 ↗
18. Non-concentrating and asymmetric compound parabolic concentrating building façade integrated photovoltaics: An experimental comparison10.1016/j.solener.2005.05.011 ↗
19. Using air flow to alleviate temperature elevation in solar cells within asymmetric compound parabolic concentrators10.1016/j.solener.2006.04.003 ↗
20. Power losses in an asymmetric compound parabolic photovoltaic concentrator10.1016/j.solmat.2007.03.020 ↗
21. Analytic solutions for the geometric and optical properties of stationary compound parabolic concentrators with fully illuminated inverted V receiver10.1016/j.solener.2007.06.012 ↗
22. E.D. Mammo, N. Sellami, T.K. Mallick, Performance analysis of a reflective 3D crossed compound parabolic concentrating photovoltaic system for building façade integration, Progress in Photovoltaics: Research and Applications, (2012) n/a–n/a.10.1002/pip.2211 ↗
23. O'Gallagher · 2008
24. Pilot production of concentrator silicon solar cells: approaching industrialization10.1016/j.solmat.2008.08.001 ↗
25. C.M. Garner, R.D. Nasby, Effects of nonuniform illumination on the performance of silicon concentrator solar cells, in: Electron Devices Meeting, 1979 Internationa, 1979, pp. 312–313.10.1109/IEDM.1979.189611 ↗
26. Recent developments in photovoltaics10.1016/S0038-092X(03)00065-3 ↗
27. Design analysis of a Fresnel lens concentrating PV cell10.1093/ijlct/ctr002 ↗
28. Laser grooved buried contact cells optimised for linear concentration systems10.1016/j.solmat.2009.08.022 ↗
29. Optical properties of polymeric materials for concentrator photovoltaic systems10.1016/j.solmat.2011.02.025 ↗
30. Multijunction solar cells for conversion of concentrated sunlight to electricity10.1364/OE.18.000A73 ↗
31. B. Pablo, C. Aleksandra, W. Roland, R. Luke, New high-concentration mirror-based kohler integrating optical design for multijunction solar cells, in: Optical Society of America, 2006, pp. TuD3.10.1364/IODC.2006.TuD3 ↗
32. Solar concentrator modules with silicone-on-glass Fresnel lens panels and multijunction cells10.1364/OE.18.000A17 ↗
33. A.Cole, K.C. Heasman, S. Roberts, M. Brown, I. Baistow, S. Devenport and T.M. Bruton, Development of LGBC solar cells for use at concentration factors up to 100×, in: 4th International Conference on Solar Concentrators (ICSC-4), Spain, 2007.10.1109/WCPEC.2006.279586 ↗
34. Optimum grid-line patterns for concentrator solar cells under nonuniform illumination10.1016/0379-6787(85)90061-4 ↗
35. Optimization of grid design for solar cells at different illumination levels10.1016/0379-6787(89)90079-3 ↗
36. S.De. Illiis, L. Serenelli, M. Izzi, M. Tucci, E. Salza, L. Pirozzi, A. Cole, L.M. Brown, S. Devenport, K. Drew, K. Heasman, D.J. Morrison, T. Bruton, S. Dewallef, Screen printing in laser grooved buried contact solar cells: the LAB2LINE hybrid processes, in: 25th European Photovoltaic Solar Energy Conference and Exhibition/ 5th World Conference on Photovoltaic Energy Conversion, Valencia, Spain, 2010, pp. 6–10 September.
37. Non-uniform illumination in concentrating solar cells10.1016/j.rser.2012.06.020 ↗
38. Evaluation and optimization of the optical performance of low-concentrating dielectric compound parabolic concentrator using ray-tracing methods10.1364/AO.50.003303 ↗
39. Experimental validation of a heat transfer model for concentrating photovoltaic system10.1016/j.applthermaleng.2011.09.031 ↗
40. Electrical performance evaluation of low-concentrating non-imaging photovoltaic concentrator10.1002/pip.819 ↗
41. Modelling power output in photovoltaic modules for outdoor operating conditions10.1016/j.enconman.2005.11.004 ↗
42. Hutton · 2003
43. Electrical and thermal performance of silicon concentrator solar cells immersed in dielectric liquids10.1016/j.apenergy.2011.05.037 ↗
44. COMSOL Multiphysics Reference Guide, 2011.
45. A two-dimensional finite element model of front surface current flow in cells under non-uniform, concentrated illumination10.1016/j.solener.2009.03.016 ↗
46. Solar cells design for low and medium concentrating photovoltaic systems10.1063/1.4753843 ↗
47. E. Franklin, J. Coventry, Effects of highly non-uniform illumination distribution on electrical performance of solar cells, in: 40th Annual Conference for the Australian New Zealand Solar Energy Society, 2004.
48. Datasheet · 2008
49. Anon · 2009