Forced in‐plane flow through complex deformable structures: Influence of an imposed curve

Abstract Forced in‐plane flow of liquids through contiguous flat and curved regions of confined fabrics has been studied both as a general phenomenon and for predicting the flow of polymers during injection molding of monolithic composite structures with complex configurations. A controlled pressure difference is applied to drive the flow, while the mass flow rate is measured gravimetrically by Liquid/Air Displacement Analysis (LADA). Measurements have been carried out along fabric paths that are first vertical, then curved, and finally horizontal. Fluid flow equations have been adapted for analyzing flow in the flat sections, leading to the evaluation of permeability constants and capillary pressures. A saturated flow rate measured at constant hydrodynamic pressure is used to evaluate the overall permeability coefficient of the encapsulated fabric. Data are presented showing that permeability can be reduced as a consequence of flow through the curved region.