Glass fibers reinforced poly(ethylene 2,6‐naphthalate)/ethylene propylene diene monomer composites: Structure, mechanical, and thermal properties

Ethylene propylene diene monomer (EPDM) was blended with glass fibers (GFs)‐filled poly(ethylene 2,6‐naphthalate) (PEN) composites to improve the impact properties of PEN. The impact strength of PEN/EPDM/GF composite (PEN/EPDM = 60/40) was about 62 J/m, which was nearly four times higher than the PEN/GF composite without EPDM. At the same time, the tensile strength and flexural modulus were still maintained at considerable values since the GFs compensated the loss of mechanical properties of PEN by incorporation of EPDM. The scanning electron microscopy results showed that the GFs were orientated and homogenously dispersed in the PEN matrix and, after incorporation of EPDM, the surface of GFs were covered by a matrix layer which became coarse and thick with increasing EPDM content. The dynamic mechanical analysis results showed the poor compatibility between PEN and EPDM. The thermal gravimetric analysis revealed that the PEN matrix protected the dispersed EPDM domains, resulting in an increased maximum peak temperature (T_max) of the EPDM phase. At last, the results of differential scanning calorimetry analysis indicated that incorporation of EPDM led to an increase in crystallization rate and improvement in crystallization temperature. POLYM. COMPOS., 35:939–947, 2014. © 2013 Society of Plastics Engineers