Physical and numerical modeling of mold filling in resin transfer molding

Abstract Finite element modeling and experimental investigation of mold filling in resin transfer molding (RTM) have been performed. Flow experiments in the molds were performed to investigate resin flow behavior into molds of rectangular and irregular shapes. Silicone fluids with viscosity of 50 and 100 centistoke as well as EPON 826 epoxy resin were used in the mold filling experiments. The reinforcements consisted of several layers of woven fiberglass and carbon fiber mats. The effects of injection pressure, fluid viscosity, type of reinforcement, and mold geometry on mold filling times were investigated. Fiber mat permeability was determined experimentally for the five‐harness and eight‐harness woven mats. Resin flow through fiber mats was modeled as flow through porous media. Pressure distributions inside both types of molds were also determined numerically. In the case of resin flow into rectangular molds, numerical results agreed well with experimental measurements. Comparison between the experimental and numerical results of the resin front position indicated the importance of edge effects in resin flow behavior in small cavities with larger boundary areas. Reducing the resistance to resin flow at the edge region in the numerical model allowed for good agreement between the numerical simulation and the physical observations of the resin front position and mold filling time.