Analysis of resin transfer/compression molding process

Abstract Resin transfer/compression molding (RT/CM) is a two‐step process in which resin injection is followed by mold closing. This process can enhance the resin flow speed and the fiber volume fraction, as well as reducing the mold filling time. In this study, a simulation program for the mold filling process during RT/CM was developed using the modified control volume finite element method (CVFEM) along with the fixed grid method. The developed numerical code can predict the resin flow, temperature, pressure, and degree of cure distribution during RT/CM. The compression force required for squeezing the impregnated preform can also be calculated. Experiments were performed for a complicated three‐dimensional shell to verify the feasibility of the RT/CM process and the numerical scheme. The compression force and the compression speed were measured. A close agreement was found between the experimental data and the numerical results. The resin front location obtained from a short shot experiment was compared with the numerical prediction. Again, a close agreement was observed. In order to demonstrate the effectiveness of the numerical code, simulations were performed for more complicated process conditions with anisotropic permeability of the preform at higher fiber volume fractions.