journal article·2023-05

Solution-processed, flexible, and highly transparent ZrO2:PVP hybrid dielectric layer

Guoping Su, Zhihao Liang, Jinyao Zhong, Honglong Ning, Kuankuan Lu, Tian Qiu, Dongxiang Luo, Xianzhe Liu, Rihui Yao, Junbiao Peng

Organic Electronics· Volume 116
Publisher page

Abstract

Organic-inorganic hybrid dielectric layers have attracted extensive attention due to their ability to simultaneously improve the relative dielectric constant ( k ) and mechanical properties of gate dielectric layers, and have great potential in flexible and wearable displays. This paper reports a low-temperature deposition method of high-quality Zirconium (IV) dioxide (ZrO 2) and Polyvinylpyrrolidone (PVP) hybrid gate dielectric layers by sol-gel method. The hybrid films have a smooth morphology, low roughness, high transmittance of 95% in the wavelength range higher than 320 nm, and an optical bandgap of up to 5.63 eV. The leakage current density (J) of the hybrid film is as low as 6.85 × 10 −6 A/cm 2 at 1 MV/cm, and no breakdown phenomenon was observed when electric fields up to 2 MV/cm were applied. In addition, enhanced interface polarization occurred between PVP and ZrO 2, thereby increasing the hybrid film`s k , resulting in a high- k (32.3 at 1 kHz). The fabricated films also exhibited good flexibility and maintain excellent insulation after 200 times of bending with a radius of 10 mm. Finally, low operating voltage thin film transistors (TFTs) using these high k ZrO 2:PVP dielectrics were obtained and a threshold voltage of 0.05 V and on/off current ratio of 1.24 × 10 5 were measured. The results demonstrate that the fabricated hybrid films are ideal gate dielectric materials for flexible wearable and low power consumption devices.
Source: expertdata · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Thin-Film Transistor Technologies · Semiconductor materials and devices · Advanced Sensor and Energy Harvesting Materials

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (49)

Show source-provided references
1. Fully integrated wearable sensor arrays for multiplexed in situ perspiration analysis10.1038/nature16521 ↗
2. Skin-like biosensor system via electrochemical channels for noninvasive blood glucose monitoring10.1126/sciadv.1701629 ↗
3. Wearable sensors for biochemical sweat analysis10.1146/annurev-anchem-061318-114910 ↗
4. All-in-one cellulose based triboelectric nanogenerator for electronic paper using simple filtration process10.1016/j.nanoen.2018.09.060 ↗
5. Flexible MXene-based composites for wearable devices10.1142/12331 ↗
6. Energy harvesting for wearable devices: a review10.1109/JSEN.2019.2925638 ↗
7. Evolution of wearable devices with real-time disease monitoring for personalized healthcare10.3390/nano9060813 ↗
8. High-k gate dielectrics for emerging flexible and stretchable electronics10.1021/acs.chemrev.8b00045 ↗
9. Hybrid gate dielectric materials for unconventional electronic circuitry10.1021/ar4002262 ↗
10. Review of solution-processed oxide thin-film transistors
11. High-mobility ZnO thin film transistors based on solution-processed Hafnium oxide gate dielectrics10.1002/adfm.201402684 ↗
12. In-depth studies on rapid photochemical activation of various sol-gel metal oxide films for flexible transparent electronics10.1002/adfm.201500545 ↗
13. High performance self-aligned top-gate ZnO thin film transistors using sputtered Al2O3 gate dielectric10.1016/j.tsf.2012.06.066 ↗
14. Low operating voltage InGaZnO thin-film transistors based on Al2O3 high-k dielectrics fabricated using pulsed laser deposition10.3938/jkps.64.1437 ↗
15. A simple, low cost ink system for drop-on-demand printing high performance metal oxide dielectric film at low temperature10.1021/acsami.8b14328 ↗
16. Binary solvent systems for piezoelectric printing crack-free PAM/ZrOx hybrid thin films through nanostructure modulation10.1021/acs.langmuir.1c00500 ↗
17. Solution-processed amorphous ZrO2 gate dielectric films synthesized by a non-hydrolytic sol-gel route10.1039/C8RA06911E ↗
18. Low-voltage ZnO thin-film transistors based on Y2O3 and Al2O3 high-k dielectrics deposited by spray pyrolysis in air
19. Solution processed metal oxide high-k dielectrics for emerging transistors and circuits
20. Sol-gel metal oxide dielectrics for all-solution-processed electronics10.1016/j.mser.2017.01.003 ↗
21. Polymer-based dielectrics with high permittivity and low dielectric loss for flexible electronics10.1039/D2TC00193D ↗
22. Gate dielectrics for organic field-effect transistors: new opportunities for organic electronics10.1002/adma.200500517 ↗
23. Marks, high-k organic, inorganic, and hybrid dielectrics for low-voltage organic field-effect transistors10.1021/cr9001275 ↗
24. Gate insulators in organic field-effect transistors10.1021/cm049598q ↗
25. Alumina nanoparticle/polymer nanocomposite dielectric for flexible amorphous indium-gallium-zinc oxide thin film transistors on plastic substrate with superior stability10.1063/1.4891426 ↗
26. High field-effect mobility pentacene thin-film transistors with nanoparticle polymer composite/polymer bilayer insulators10.1063/1.3124660 ↗
27. Flexible low-voltage organic thin-film transistors enabled by low-temperature, ambient solution-processable inorganic/organic hybrid gate dielectrics10.1021/ja107079d ↗
28. Solution processable high dielectric constant nanocomposites based on ZrO2 nanoparticles for flexible organic transistors10.1021/am404129u ↗
29. PMMA-SiO2 organic-inorganic hybrid films: determination of dielectric characteristics10.1007/s10971-010-2380-9 ↗
30. UV-curable organic-inorganic hybrid gate dielectrics for organic thin film transistors10.1016/j.orgel.2012.08.014 ↗
31. High dielectric constant gate oxides for metal oxide Si transistors10.1088/0034-4885/69/2/R02 ↗
32. In-situ low-temperature synthesis of PS-ZrO2 hybrid films and their characterization for high-k gate dielectric application10.1016/j.porgcoat.2021.106188 ↗
33. UV-assisted low temperature oxide dielectric films for TFT applications10.1002/admi.201400206 ↗
34. Inkjet printing of homogeneous and green cellulose nanofibril dielectrics for high performance IGZO TFTs10.1039/D0TC02424D ↗
35. Toward ultraviolet solution processed ZrOx/IZO transistors with top-gate and dual-gate operation: selection of solvents, precursors, stabilizers, and additive elements10.1016/j.jallcom.2020.156431 ↗
36. High-refractive-index thin films prepared from Trialkoxysilane-capped poly(methyl methacrylate)-Titania materials10.1021/cm000937z ↗
37. Air plasma or UV-irradiation applied to surface modification of pectin/poly(vinyl alcohol) blends10.1016/j.apsusc.2010.07.005 ↗
38. UV irradiation induced microstructural changes in CdCl2 doped PVA-PVP blend10.1007/s10854-017-8355-7 ↗
39. Effects of annealing temperature on optical band gap of sol-gel tungsten trioxide films10.3390/mi9080377 ↗
40. Effect of UV irradiation on optical, mechanical and microstructural properties of PVA/NaAlg blends10.1016/j.radphyschem.2014.05.036 ↗
41. High k PVP titanium dioxide composite dielectric with low leakage current for thin film transistor10.1016/j.orgel.2021.106413 ↗
42. Low-temperature, solution-processed ZrO2:B thin film: a bifunctional inorganic/organic interfacial glue for flexible thin-film transistors10.1021/acsami.5b00036 ↗
43. Characterization of amorphous silica nanofiller effect on the structural, morphological, optical, thermal, dielectric and electrical properties of PVA-PVP blend based polymer nanocomposites for their flexible nanodielectric applications10.1007/s10854-018-9116-y ↗
44. Novel poly(N-vinyl-2-pyrrolidone) nanocomposites containing poly(amide-imide)/aluminum oxide nanostructure hybrid as a filler10.1177/0954008315570399 ↗
45. Photooxidation of poly(N-vinylpyrrolidone) (PVP) in the solid state and in aqueous solution10.1016/j.polymdegradstab.2009.08.007 ↗
46. UV-irradiation assisted control of the structural, optical and thermal properties of PEO/PVP blended gold nanoparticles10.1016/j.matchemphys.2017.08.022 ↗
47. Nanosecond laser-irradiation assisted the improvement of structural, optical and thermal properties of polyvinyl pyrrolidone/carboxymethyl cellulose blend filled with gold nanoparticles10.1007/s10854-018-0545-4 ↗
48. Effect of annealing temperature on microstructural evolution and electrical properties of sol-gel processed ZrO2/Si films10.1063/1.3541784 ↗
49. PMMA-SiO2 hybrid films as gate dielectric for ZnO based thin-film transistors10.1016/j.matchemphys.2014.03.042 ↗