Modeling the degradation/recovery of short-circuit current density in perovskite and thin film photovoltaics
Source abstract
Abstract
Abstract A time-dependent approach has been developed for modeling the degradation and recovery rate of short-circuit current density in thin film and perovskite solar cells. A set of six different equations has been derived by fundamentally relating the carrier collection efficiency to the defect/trap creation/annihilation kinetics. The distribution and concentration of defects or traps across the absorber layer of a cell vary under aging conditions. As a result, the carrier collection efficiency changes due to distorted diffusion length and depletion width at the junction. These parameters are both related to defect/trap densities by reverse square 1/ N ( t ) . We applied our modeling on the experimental data reported in the literature on degradation/recovery of CdTe, CIGS, CZTS and perovskite solar cells with various architectures and prepared through different fabrication details. These devices were aged under elevated temperature, prolonged irradiation or moisture. The aging effect was taken as a change in shallow/deep defect density or trap density at mid-gap. A good fit has been obtained by setting fitting parameters in a reasonable range. These include the initial defect density, N 0 , and degradation time constant, τ 0 , of a typical defect increment profile given by N ( t ) = N 0 (1 + t/t0)1/2θ. It was shown that opposite to conventionally believed, the defect density variation may significantly change the current density of the cell even if the absorber layer's thickness is kept constant. This has been occasionally observed by aging techniques using different stress conditions.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Perovskite Materials and Applications · Chalcogenide Semiconductor Thin Films · Quantum Dots Synthesis And Properties
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (33)
Show source-provided references
1. The use of 2nd and 3rd level correlation analysis for studying degradation in polycrystalline thin-film solar cells
2. Non-ionizing energy loss calculations for modeling electron-induced degradation of Cu(In, Ga)Se2 thin-film solar cells10.1088/1674-1056/25/9/098402 ↗
3. Correlation of built-in potential and IV crossover in thin-film solar cells10.1109/JPHOTOV.2014.2316364 ↗
4. Quang · 2004
5. Fabrication and photoelectrochemical behavior of n-type Cu2ZnSnSe4 thin-film electrodes prepared via non-vacuum nanoinks process10.1149/2.040311jss ↗
6. Amazing stable open- circuit voltage in perovskite solar cells using AgAl alloy electrode10.1016/j.solmat.2015.11.026 ↗
7. Electron-beam induced degradation in CdTe photovoltaics10.1063/1.1305857 ↗
8. Degradation of CdTe solar cells: simulation and experiment”10.1109/JPHOTOV.2015.2405763 ↗
9. Direct determination of doping concentration and built-in voltage from extraction current transients10.1016/j.orgel.2014.09.027 ↗
10. Modeling the degradation and recovery of perovskite solar cells10.1039/C6RA06635F ↗
11. Modeling the degradation/recovery of open-circuit voltage in perovskite and thin film solar cells10.1016/j.matdes.2016.11.012 ↗
12. Photoluminescence fatigue and related degradation in thin-film photovoltaics10.1063/1.1601687 ↗
13. Degradation and device physics modeling of TiO2/CZTS ultrathin film photovoltaics10.1016/j.matlet.2015.05.055 ↗
14. A simple model for voltage-dependent carrier collection efficiency in solar cells10.1063/1.4870827 ↗
15. Electrical characterization of CdTe pixeElectrical characterization of CdTe pixel detectors with Al Schottky anode10.1016/j.nima.2014.07.011 ↗
16. ’Polarization phenomena in Al/p-CdTe/Pt X-ray detectors10.1016/j.nima.2013.05.157 ↗
17. Luque · 2003 · 92
18. Quantitative determination of optical and recombination losses in thin-film photovoltaic devices based on external quantum efficiency analysis10.1063/1.4960698 ↗
19. Dependence of efficiency of thin-film CdS/CdTe solar cell on parameters of absorber layer and barrier structure10.1016/j.tsf.2008.11.012 ↗
20. Quantitative analysis of optical and recombination losses in Cu(In,Ga)Se2 thin-film solar cells10.1134/S1063782616040138 ↗
21. Dependence of charge collection in thin-film CdTe solar cells on the absorber layer parameters10.1088/0268-1242/23/2/025011 ↗
22. Charge collection properties of a CdTe Schottky diode for x- and γ-rays detectors10.1088/0268-1242/23/7/075024 ↗
23. Towards understanding junction degradation in cadmium telluride solar cells10.1063/1.4883368 ↗
24. Influence of hydration water on CH3NH3PbI3 perovskite films prepared through one-step procedure10.1364/OE.24.0A1431 ↗
25. Intrinsic stability of thin-film CdS/CdTe Modules
26. CdTe thin-film solar cells with cobalt-phthalocyanine back contacts10.1063/1.4871093 ↗
27. The impact of alkali elements on the degradation of CIGS solar cells10.1002/pip.2610 ↗
28. Morgan · 1999
29. Light-activated photocurrent degradation and self-healing in perovskite solar cells10.1038/ncomms11574 ↗
30. Photo-induced degradation of lead halide perovskite solar cells caused by the hole transport layer/metal electrode interface10.1039/C5TA08622A ↗
31. Organometal halide perovskite solar cells: degradation and stability10.1039/C5EE02733K ↗
32. Modeling of optical losses in graphene contacted thin film solar cells10.1016/j.matlet.2015.11.050 ↗
33. Potential buffer layers for Cu2ZnSnS4 (CZTS) solar cells from numerical analysis10.1109/CEAT.2013.6775674 ↗